Pull ARM SoC fixes from Olof Johansson:
"The usual batch; most of them are DT tweaks to fix misdescribed
hardware. Beyond that:
- A bugfix for MMP2 CPU detection, it's been there quite a while but
makes sense to fix now anyway.
- Some power management tweaks:
+ disabling of CPU idle power state on Marvell Armada 7K/8K
(Macchiatobin et al)
+ Increase of minimum voltage on BananaPi M3
+ Tweak of power ramp time for DVFS on NXP/Freescale i.MX7SX
- A couple of MAINTAINER updates:
+ MMP has a new volunteer to look after it
+ Mediatek adds a few keywords, IRC channel and wiki URL"
* tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
ARM: dts: imx7d-nitrogen7: Fix the description of the Wifi clock
ARM: imx: update the cpu power up timing setting on i.mx6sx
Revert "arm64: dts: marvell: add CPU Idle power state support on Armada 7K/8K"
ARM: dts: imx7d-pico: Describe the Wifi clock
ARM: dts: realview: Fix some more duplicate regulator nodes
MAINTAINERS: update entry for MMP platform
ARM: mmp/mmp2: fix cpu_is_mmp2() on mmp2-dt
MAINTAINERS: mediatek: Update SoC entry
ARM: dts: bcm2837: Fix polarity of wifi reset GPIOs
arm64: dts: mt7622: Drop the general purpose timer node
arm64: dts: mt7622: fix no more console output on BPI-R64 board
arm64: dts: mt7622: fix no more console output on rfb1
ARM: dts: sun8i: a83t: bananapi-m3: increase vcc-pd voltage to 3.3V
Allwinner fixes for 4.20 One small fix for a regulator range on the Banana Pi M3 * tag 'sunxi-fixes-for-4.20' of https://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux: ARM: dts: sun8i: a83t: bananapi-m3: increase vcc-pd voltage to 3.3V Signed-off-by: Olof Johansson <olof@lixom.net>
i.MX fixes for 4.20, round 3: - A couple of fixes on imx7d-pico and imx7d-nitrogen7 boards to correct the description of the Wifi clock. - Change SW2ISO count to get a safer ARM LDO ramp-up time, so that different boards can be covered. This fixes the ARM LDO failure seen on some customer boards. * tag 'imx-fixes-4.20-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux: ARM: dts: imx7d-nitrogen7: Fix the description of the Wifi clock ARM: imx: update the cpu power up timing setting on i.mx6sx ARM: dts: imx7d-pico: Describe the Wifi clock Signed-off-by: Olof Johansson <olof@lixom.net>
Pull ARM spectre fix from Russell King: "Exynos folk noticed that CPU hotplug wasn't working with their kernel configuration, and have tested this as fixing the problem" * 'spectre' of git://git.armlinux.org.uk/~rmk/linux-arm: ARM: ensure that processor vtables is not lost after boot
Pull ARM fixes from Russell King:
"Some small fixes that have been accumulated:
- Chris Cole noticed that in a SMP environment, the DMA cache
coherence handling can produce undesirable results in a corner
case
- Propagate that fix for ARMv7M as well
- Fix a false positive with source fortification
- Fix an uninitialised return that Nathan Jones spotted"
* 'fixes' of git://git.armlinux.org.uk/~rmk/linux-arm:
ARM: 8816/1: dma-mapping: fix potential uninitialized return
ARM: 8815/1: V7M: align v7m_dma_inv_range() with v7 counterpart
ARM: 8814/1: mm: improve/fix ARM v7_dma_inv_range() unaligned address handling
ARM: 8806/1: kprobes: Fix false positive with FORTIFY_SOURCE
Marek Szyprowski reported problems with CPU hotplug in current kernels.
This was tracked down to the processor vtables being located in an
init section, and therefore discarded after kernel boot, despite being
required after boot to properly initialise the non-boot CPUs.
Arrange for these tables to end up in .rodata when required.
Reported-by: Marek Szyprowski <m.szyprowski@samsung.com>
Tested-by: Krzysztof Kozlowski <krzk@kernel.org>
Fixes: 383fb3ee8024 ("ARM: spectre-v2: per-CPU vtables to work around big.Little systems")
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
According to bindings/regulator/fixed-regulator.txt the 'clocks' and
'clock-names' properties are not valid ones.
In order to turn on the Wifi clock the correct location for describing
the CLKO2 clock is via a mmc-pwrseq handle, so do it accordingly.
Fixes: 56354959cfec ("ARM: dts: imx: add Boundary Devices Nitrogen7 board")
Signed-off-by: Fabio Estevam <festevam@gmail.com>
Acked-by: Troy Kisky <troy.kisky@boundarydevices.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
The sw2iso count should cover ARM LDO ramp-up time,
the MAX ARM LDO ramp-up time may be up to more than
100us on some boards, this patch sets sw2iso to 0xf
(~384us) which is the reset value, and it is much
more safe to cover different boards, since we have
observed that some customer boards failed with current
setting of 0x2.
Fixes: 05136f0897b5 ("ARM: imx: support arm power off in cpuidle for i.mx6sx")
Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Reviewed-by: Fabio Estevam <festevam@gmail.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
The Wifi chip should be clocked by a 32kHz clock coming from i.MX7D
CLKO2 output pin, so describe the pinmux and clock hierarchy in the
device tree to allow the Wifi chip to be properly clocked.
Managed to successfully test Wifi with such change. Used the standard
nvram.txt file provided by TechNexion, which selects an external 32kHz
clock for the Wifi chip by default.
Fixes: 99a52450c707 ("ARM: dts: imx7d-pico: Add Wifi support")
Suggested-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Tested-by: Otavio Salvador <otavio@ossystems.com.br>
Signed-off-by: Fabio Estevam <festevam@gmail.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
While trying to use the dma_mmap_*() interface, it was noticed that this
interface returns strange values when passed an incorrect length.
If neither of the if() statements fire then the return value is
uninitialized. In the worst case it returns 0 which means the caller
will think the function succeeded.
Fixes: 1655cf8829d8 ("ARM: dma-mapping: Remove traces of NOMMU code")
Signed-off-by: Nathan Jones <nathanj439@gmail.com>
Reviewed-by: Robin Murphy <robin.murphy@arm.com>
Acked-by: Vladimir Murzin <vladimir.murzin@arm.com>
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>