The ARM architecture defines the memory locations that are permitted
to be accessed as the result of a speculative instruction fetch from
an exception level for which all stages of translation are disabled.
Specifically, the core is permitted to speculatively fetch from the
4KB region containing the current program counter 4K and next 4K.

When translation is changed from enabled to disabled for the running
exception level (SCTLR_ELn[M] changed from a value of 1 to 0), the
Falkor core may errantly speculatively access memory locations outside
of the 4KB region permitted by the architecture. The errant memory
access may lead to one of the following unexpected behaviors.

1) A System Error Interrupt (SEI) being raised by the Falkor core due
   to the errant memory access attempting to access a region of memory
   that is protected by a slave-side memory protection unit.
2) Unpredictable device behavior due to a speculative read from device
   memory. This behavior may only occur if the instruction cache is
   disabled prior to or coincident with translation being changed from
   enabled to disabled.

The conditions leading to this erratum will not occur when either of the
following occur:
 1) A higher exception level disables translation of a lower exception level
   (e.g. EL2 changing SCTLR_EL1[M] from a value of 1 to 0).
 2) An exception level disabling its stage-1 translation if its stage-2
    translation is enabled (e.g. EL1 changing SCTLR_EL1[M] from a value of 1
    to 0 when HCR_EL2[VM] has a value of 1).

To avoid the errant behavior, software must execute an ISB immediately
prior to executing the MSR that will change SCTLR_ELn[M] from 1 to 0.

Signed-off-by: Shanker Donthineni <shankerd@codeaurora.org>
Signed-off-by: Will Deacon <will.deacon@arm.com>

To enable the kernel to use SVE, SVE traps from EL1 to EL2 must be
disabled.  To take maximum advantage of the hardware, the full
available vector length also needs to be enabled for EL1 by
programming ZCR_EL2.LEN.  (The kernel will program ZCR_EL1.LEN as
required, but this cannot override the limit set by ZCR_EL2.)

This patch makes the appropriate changes to the EL2 early setup
code.

Signed-off-by: Dave Martin <Dave.Martin@arm.com>
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: Alex Bennée <alex.bennee@linaro.org>
Signed-off-by: Will Deacon <will.deacon@arm.com>

When booting at EL2, ensure that we permit the EL1 host to sample
physical addresses and physical counter values using SPE.

Acked-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>

When the kernel is entered at EL2 on an ARMv8.0 system, we construct
the EL1 pstate and make sure this uses the the EL1 stack pointer
(we perform an exception return to EL1h).

But if the kernel is either entered at EL1 or stays at EL2 (because
we're on a VHE-capable system), we fail to set SPsel, and use whatever
stack selection the higher exception level has choosen for us.

Let's not take any chance, and make sure that SPsel is set to one
before we decide the mode we're going to run in.

Cc: <stable@vger.kernel.org>
Acked-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>

Pull arm64 updates from Catalin Marinas:

 - VMAP_STACK support, allowing the kernel stacks to be allocated in the
   vmalloc space with a guard page for trapping stack overflows. One of
   the patches introduces THREAD_ALIGN and changes the generic
   alloc_thread_stack_node() to use this instead of THREAD_SIZE (no
   functional change for other architectures)

 - Contiguous PTE hugetlb support re-enabled (after being reverted a
   couple of times). We now have the semantics agreed in the generic mm
   layer together with API improvements so that the architecture code
   can detect between contiguous and non-contiguous huge PTEs

 - Initial support for persistent memory on ARM: DC CVAP instruction
   exposed to user space (HWCAP) and the in-kernel pmem API implemented

 - raid6 improvements for arm64: faster algorithm for the delta syndrome
   and implementation of the recovery routines using Neon

 - FP/SIMD refactoring and removal of support for Neon in interrupt
   context. This is in preparation for full SVE support

 - PTE accessors converted from inline asm to cmpxchg so that we can use
   LSE atomics if available (ARMv8.1)

 - Perf support for Cortex-A35 and A73

 - Non-urgent fixes and cleanups

* tag 'arm64-upstream' of git://git.kernel.org/pub/scm/linux/kernel/git/arm64/linux: (75 commits)
  arm64: cleanup {COMPAT_,}SET_PERSONALITY() macro
  arm64: introduce separated bits for mm_context_t flags
  arm64: hugetlb: Cleanup setup_hugepagesz
  arm64: Re-enable support for contiguous hugepages
  arm64: hugetlb: Override set_huge_swap_pte_at() to support contiguous hugepages
  arm64: hugetlb: Override huge_pte_clear() to support contiguous hugepages
  arm64: hugetlb: Handle swap entries in huge_pte_offset() for contiguous hugepages
  arm64: hugetlb: Add break-before-make logic for contiguous entries
  arm64: hugetlb: Spring clean huge pte accessors
  arm64: hugetlb: Introduce pte_pgprot helper
  arm64: hugetlb: set_huge_pte_at Add WARN_ON on !pte_present
  arm64: kexec: have own crash_smp_send_stop() for crash dump for nonpanic cores
  arm64: dma-mapping: Mark atomic_pool as __ro_after_init
  arm64: dma-mapping: Do not pass data to gen_pool_set_algo()
  arm64: Remove the !CONFIG_ARM64_HW_AFDBM alternative code paths
  arm64: Ignore hardware dirty bit updates in ptep_set_wrprotect()
  arm64: Move PTE_RDONLY bit handling out of set_pte_at()
  kvm: arm64: Convert kvm_set_s2pte_readonly() from inline asm to cmpxchg()
  arm64: Convert pte handling from inline asm to using (cmp)xchg
  arm64: neon/efi: Make EFI fpsimd save/restore variables static
  ...

In the KASLR setup routine, we ensure that the early virtual mapping
of the kernel image does not cover more than a single table entry at
the level above the swapper block level, so that the assembler routines
involved in setting up this mapping can remain simple.

In this calculation we add the proposed KASLR offset to the values of
the _text and _end markers, and reject it if they would end up falling
in different swapper table sized windows.

However, when taking the addresses of _text and _end, the modulo offset
(the physical displacement modulo 2 MB) is already accounted for, and
so adding it again results in incorrect results. So disregard the modulo
offset from the calculation.

Fixes: 08cdac619c81 ("arm64: relocatable: deal with physically misaligned ...")
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Tested-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Will Deacon <will.deacon@arm.com>

* 'arm64/exception-stack' of git://git.kernel.org/pub/scm/linux/kernel/git/mark/linux:
  arm64: unwind: remove sp from struct stackframe
  arm64: unwind: reference pt_regs via embedded stack frame
  arm64: unwind: disregard frame.sp when validating frame pointer
  arm64: unwind: avoid percpu indirection for irq stack
  arm64: move non-entry code out of .entry.text
  arm64: consistently use bl for C exception entry
  arm64: Add ASM_BUG()

As it turns out, the unwind code is slightly broken, and probably has
been for a while. The problem is in the dumping of the exception stack,
which is intended to dump the contents of the pt_regs struct at each
level in the call stack where an exception was taken and routed to a
routine marked as __exception (which means its stack frame is right
below the pt_regs struct on the stack).

'Right below the pt_regs struct' is ill defined, though: the unwind
code assigns 'frame pointer + 0x10' to the .sp member of the stackframe
struct at each level, and dump_backtrace() happily dereferences that as
the pt_regs pointer when encountering an __exception routine. However,
the actual size of the stack frame created by this routine (which could
be one of many __exception routines we have in the kernel) is not known,
and so frame.sp is pretty useless to figure out where struct pt_regs
really is.

So it seems the only way to ensure that we can find our struct pt_regs
when walking the stack frames is to put it at a known fixed offset of
the stack frame pointer that is passed to such __exception routines.
The simplest way to do that is to put it inside pt_regs itself, which is
the main change implemented by this patch. As a bonus, doing this allows
us to get rid of a fair amount of cruft related to walking from one stack
to the other, which is especially nice since we intend to introduce yet
another stack for overflow handling once we add support for vmapped
stacks. It also fixes an inconsistency where we only add a stack frame
pointing to ELR_EL1 if we are executing from the IRQ stack but not when
we are executing from the task stack.

To consistly identify exceptions regs even in the presence of exceptions
taken from entry code, we must check whether the next frame was created
by entry text, rather than whether the current frame was crated by
exception text.

To avoid backtracing using PCs that fall in the idmap, or are controlled
by userspace, we must explcitly zero the FP and LR in startup paths, and
must ensure that the frame embedded in pt_regs is zeroed upon entry from
EL0. To avoid these NULL entries showin in the backtrace, unwind_frame()
is updated to avoid them.

Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
[Mark: compare current frame against .entry.text, avoid bogus PCs]
Signed-off-by: Mark Rutland <mark.rutland@arm.com>
Cc: Catalin Marinas <catalin.marinas@arm.com>
Cc: James Morse <james.morse@arm.com>
Cc: Will Deacon <will.deacon@arm.com>

__inval_cache_range() is already the odd one out among our data cache
maintenance routines as the only remaining range-based one; as we're
going to want an invalidation routine to call from C code for the pmem
API, let's tweak the prototype and name to bring it in line with the
clean operations, and to make its relationship with __dma_inv_area()
neatly mirror that of __clean_dcache_area_poc() and __dma_clean_area().
The loop clearing the early page tables gets mildly massaged in the
process for the sake of consistency.

Reviewed-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>

* 'arm64/common-sysreg' of git://git.kernel.org/pub/scm/linux/kernel/git/mark/linux:
  arm64: sysreg: add Set/Way sys encodings
  arm64: sysreg: add register encodings used by KVM
  arm64: sysreg: add physical timer registers
  arm64: sysreg: subsume GICv3 sysreg definitions
  arm64: sysreg: add performance monitor registers
  arm64: sysreg: add debug system registers
  arm64: sysreg: sort by encoding