i.MX fixes for 6.18, 2nd round:

- Correct i.MX8DXL's pcie-ep interrupt number (Frank Li)
- Swap interrupt numbers of eqos for imx8dxl-ss-conn (Frank Li)
- Correct SAI3 interrupt line for i.MX6UL (Maarten Zanders)
- Correct mux-controller select/enable-gpios polarity for imx8qm-mek
  board (Xu Yang)

* tag 'imx-fixes-6.18-2' of https://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  arm64: dts: imx8qm-mek: fix mux-controller select/enable-gpios polarity
  ARM: dts: nxp: imx6ul: correct SAI3 interrupt line
  arm64: dts: imx8dxl-ss-conn: swap interrupts number of eqos
  arm64: dts: imx8dxl: Correct pcie-ep interrupt number

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Regulator/supply fixes for a number of boards, removed too fast
cpu OPPs from rk3576 (not supported in newer vendor TF-A and never
supported in upstream TF-A). As well as some DTS validation fixes
and one pinctrl fix for the odroid-m1.

* tag 'v6.18-rockchip-dtsfixes1' of git://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip:
  arm64: dts: rockchip: fix PCIe 3.3V regulator voltage on orangepi-5
  arm64: dts: rockchip: disable HS400 on RK3588 Tiger
  arm64: dts: rockchip: drop reset from rk3576 i2c9 node
  arm64: dts: rockchip: Fix USB power enable pin for BTT CB2 and Pi2
  arm64: dts: rockchip: Fix vccio4-supply on rk3566-pinetab2
  arm64: dts: rockchip: include rk3399-base instead of rk3399 in rk3399-op1
  arm64: dts: rockchip: Fix indentation on rk3399 haikou demo dtso
  arm64: dts: rockchip: Make RK3588 GPU OPP table naming less generic
  arm64: dts: rockchip: Drop 'rockchip,grf' prop from tsadc on rk3328
  arm64: dts: rockchip: Remove non-functioning CPU OPPs from RK3576
  arm64: dts: rockchip: Fix PCIe power enable pin for BigTreeTech CB2 and Pi2
  arm64: dts: rockchip: Set correct pinctrl for I2S1 8ch TX on odroid-m1

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

According to the board design, set SEL to high means flipped
connection (TX2/RX2). And the TCPM will output logical 1 if it needs
flipped connection. So switch to active high for select-gpios.
The EN pin on mux chip is low active, so switch to active low for
enable-gpios too.

Fixes: b237975b2cd5 ("arm64: dts: imx8qm-mek: add usb 3.0 and related type C nodes")
Cc: stable@vger.kernel.org
Reviewed-by: Jun Li <jun.li@nxp.com>
Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

This pull request contains Broadcom ARM64-based SoCs Device Tree fixes
for 6.18, please pull the following:

- Andrea assigns clocks rates for the Ethernet controller for the
  Raspberry Pi 5 systems

- Laurent adds an ethernet0 alias to allow client programs consuming
  that alias to populate the correct Ethernet address for the Raspberry
  Pi 5 systems

* tag 'arm-soc/for-6.18/devicetree-arm64-fixes-v2' of https://github.com/Broadcom/stblinux:
  arm64: dts: broadcom: bcm2712: rpi-5: Add ethernet0 alias
  arm64: dts: broadcom: Assign clock rates in eth node for RPi5

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

i.MX fixes for 6.18:

- Enable ext4 support explicitly in imx_v6_v7_defconfig to fix a regression
  caused by commit d6ace46c82fd ("ext4: remove obsolete EXT3 config options")
- Correct report-rate-hz setting for imx6ull-engicam-microgea-rmm board
- Fix MSI mapping for i.MX95 PCIe endpoint device nodes
- Fix USB OTG role switching for imx8mp-kontron board
- Fix a dt-schema warning caused by audmux node for imx51-zii-rdu1 board
- Avoid gpio0_mipi_csi GPIOs being deferred for i.MX8 img subsystem

* tag 'imx-fixes-6.18' of https://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  arm64: dts: imx8mp-kontron: Fix USB OTG role switching
  arm64: dts: imx95: Fix MSI mapping for PCIe endpoint nodes
  arm64: dts: imx8-ss-img: Avoid gpio0_mipi_csi GPIOs being deferred
  arm: imx_v6_v7_defconfig: enable ext4 directly
  ARM: dts: imx51-zii-rdu1: Fix audmux node names
  ARM: dts: imx6ull-engicam-microgea-rmm: fix report-rate-hz value

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arm64: tegra: Fixes for v6.18

This contains a simple fix to mark the Ethernet PHY on Jetson Xavier NX
as a wakeup source so the device can support WoL.

* tag 'tegra-for-6.18-arm64-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/tegra/linux:
  arm64: tegra: Mark Jetson Xavier NX's PHY as a wakeup source

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

The vcc3v3_pcie20 fixed regulator powers the PCIe device-side 3.3V rail
for pcie2x1l2 via vpcie3v3-supply. The DTS mistakenly set its
regulator-min/max-microvolt to 1800000 (1.8 V). Correct both to 3300000
(3.3 V) to match the rail name, the PCIe/M.2 power requirement, and the
actual hardware wiring on Orange Pi 5.

Fixes: b6bc755d806e ("arm64: dts: rockchip: Add Orange Pi 5")
Cc: stable@vger.kernel.org
Signed-off-by: Mykola Kvach <xakep.amatop@gmail.com>
Reviewed-by: Michael Riesch <michael.riesch@collabora.com>
Link: https://patch.msgid.link/cf6e08dfdfbf1c540685d12388baab1326f95d2c.1762165324.git.xakep.amatop@gmail.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>

We've had reports from the field that some RK3588 Tiger have random
issues with eMMC errors.

Applying commit a28352cf2d2f ("mmc: sdhci-of-dwcmshc: Change
DLL_STRBIN_TAPNUM_DEFAULT to 0x4") didn't help and seemed to have made
things worse for our board.

Our HW department checked the eMMC lines and reported that they are too
long and don't look great so signal integrity is probably not the best.

Note that not all Tigers with the same eMMC chip have errors, so the
suspicion is that we're really on the edge in terms of signal integrity
and only a handful devices are failing. Additionally, we have RK3588
Jaguars with the same eMMC chip but the layout is different and we also
haven't received reports about those so far.

Lowering the max-frequency to 150MHz from 200MHz instead of simply
disabling HS400 was briefly tested and seem to work as well. We've
disabled HS400 downstream and haven't received reports since so we'll go
with that instead of lowering the max-frequency.

Signed-off-by: Quentin Schulz <quentin.schulz@cherry.de>
Fixes: 6173ef24b35b ("arm64: dts: rockchip: add RK3588-Q7 (Tiger) SoM")
Cc: stable@vger.kernel.org
Link: https://patch.msgid.link/20251112-tiger-hs200-v1-1-b50adac107c0@cherry.de
[added Fixes tag and stable-cc from 2nd mail]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>

The reset property is not part of the binding, so drop it.
It is also not used by the driver, so it was likely copied
from some vendor-kernel node.

Fixes: 57b1ce903966 ("arm64: dts: rockchip: Add rk3576 SoC base DT")
Signed-off-by: Chukun Pan <amadeus@jmu.edu.cn>
Link: https://patch.msgid.link/20251101140101.302229-1-amadeus@jmu.edu.cn
Signed-off-by: Heiko Stuebner <heiko@sntech.de>

Swap interrupt numbers of eqos because the below commit just swap
interrupt-names and missed swap interrupts also.

The driver (drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c) use
interrupt-names to get irq numbers.

Fixes: f29c19a6e488 ("arm64: dts: imx8dxl-ss-conn: Fix Ethernet interrupt-names order")
Signed-off-by: Frank Li <Frank.Li@nxp.com>
Tested-by: Alexander Dahl <ada@thorsis.com>
Cc: stable@vger.kernel.org
Signed-off-by: Shawn Guo <shawnguo@kernel.org>