i.MX fixes for 5.11, round 3:

- Fix DCFG address range on LS1046A SoC.

* tag 'imx-fixes-5.11-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  arm64: dts: ls1046a: fix dcfg address range

Link: https://lore.kernel.org/r/20210202071441.GP907@dragon
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Dcfg was overlapping with clockgen address space which resulted
in failure in memory allocation for dcfg. According regs description
dcfg size should not be bigger than 4KB.

Signed-off-by: Zyta Szpak <zr@semihalf.com>
Fixes: 8126d88162a5 ("arm64: dts: add QorIQ LS1046A SoC support")
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arm64: dts: amlogic fixes for v5.11-rc (round 3)
- fix reboot issue on odroid C4

* tag 'amlogic-fixes-3' of git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-amlogic:
  arm64: dts: meson: switch TFLASH_VDD_EN pin to open drain on Odroid-C4

Link: https://lore.kernel.org/r/7hk0ryi6rs.fsf@baylibre.com
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arm64: dts: amlogic fixes for v5.11-rc (round 2)
- fix ethernet resets

* tag 'amlogic-fixes-2' of git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-amlogic:
  Revert "arm64: dts: amlogic: add missing ethernet reset ID"

Link: https://lore.kernel.org/r/7ho8hai7e6.fsf@baylibre.com
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Wrong irq number on px30 and cleanups of stuff on rk3399 regarding
wrongly used dt properties and parts that shouldn't be enabled.

* tag 'v5.11-rockchip-dtsfixes1' of git://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip:
  arm64: dts: rockchip: Disable display for NanoPi R2S
  arm64: dts: rockchip: remove interrupt-names property from rk3399 vdec node
  arm64: dts: rockchip: Fix PCIe DT properties on rk3399
  arm64: dts: rockchip: Use only supported PCIe link speed on Pinebook Pro
  arm64: dts: rockchip: fix vopl iommu irq on px30

Link: https://lore.kernel.org/r/5429065.DvuYhMxLoT@phil
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

For the proper reboot Odroid-C4 board requires to switch TFLASH_VDD_EN
pin to the high impedance mode, otherwise the board is stuck in the
middle of loading early stages of the bootloader from SD card.

This can be achieved by using the OPEN_DRAIN flag instead of the
ACTIVE_HIGH, what will leave the pin in input mode to achieve high state
(pin has the pull-up) and solve the issue.

Suggested-by: Neil Armstrong <narmstrong@baylibre.com>
Fixes: 326e57518b0d ("arm64: dts: meson-sm1: add support for Hardkernel ODROID-C4")
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Acked-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Link: https://lore.kernel.org/r/20210122055218.27241-1-m.szyprowski@samsung.com

Qualcomm ARM64 fixes for 5.11

This fixes a regression in Lenovo Yoga C630, where the touchpad in some
units stopped working, by re-enabling the "tsc2" device.

It also marks the LPASS related clocks as protected to allow DB845c and
the Lenovo Yoga C630 to boot even if CONFIG_SDM_LPASSCC_845 is enabled.

* tag 'qcom-arm64-fixes-for-5.11' of git://git.kernel.org/pub/scm/linux/kernel/git/qcom/linux:
  arm64: dts: qcom: sdm845: Reserve LPASS clocks in gcc
  arm64: dts: qcom: c630: keep both touchpad devices enabled

Link: https://lore.kernel.org/r/20210125232039.642565-1-bjorn.andersson@linaro.org
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arm64: dts: amlogic: fixes for v5.11-rc
- meson-g12: Set FL-adj property value

* tag 'amlogic-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-amlogic:
  arm64: dts: amlogic: meson-g12: Set FL-adj property value

Link: https://lore.kernel.org/r/7hk0s0x3im.fsf@baylibre.com
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

It has been reported on IRC and in KernelCI boot tests, this change breaks
internal PHY support on the Amlogic G12A/SM1 Based boards.

We suspect the added signal to reset more than the Ethernet MAC but also
the MDIO/(RG)MII mux used to redirect the MAC signals to the internal PHY.

This reverts commit f3362f0c18174a1f334a419ab7d567a36bd1b3f3 while we find
and acceptable solution to cleanly reset the Ethernet MAC.

Reported-by: Corentin Labbe <clabbe@baylibre.com>
Acked-by: Jérôme Brunet <jbrunet@baylibre.com>
Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Link: https://lore.kernel.org/r/20210126080951.2383740-1-narmstrong@baylibre.com

NanoPi R2S is headless, so rightly does not enable any of the display
interface hardware, which currently provokes an obnoxious error in the
boot log from the fake DRM device failing to find anything to bind to.
It probably isn't *too* hard to obviate the fake device shenanigans
entirely with a bit of driver reshuffling, but for now let's just
disable it here to shut up the spurious error.

Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Link: https://lore.kernel.org/r/c4553dfad1ad6792c4f22454c135ff55de77e2d6.1611186099.git.robin.murphy@arm.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>