Pull ARM SoC fixes from Olof Johansson:
 "A smallish set of fixes that we've been sitting on for a while now,
  flushing the queue here so they go in.  Summary:

  A handful of fixes for OMAP, i.MX, Allwinner and Tegra:

   - A clock rate and a PHY setup fix for i.MX6Q/DL
   - A couple of fixes for the reduced serial bus (sunxi-rsb) on
     Allwinner
   - UART wakeirq fix for an OMAP4 board, timer config fixes for AM43XX.
   - Suspend fix for Tegra124 Chromebooks
   - Fix for missing implicit include that's different between
     ARM/ARM64"

* tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  ARM: tegra: Fix suspend hang on Tegra124 Chromebooks
  bus: sunxi-rsb: Fix peripheral IC mapping runtime address
  bus: sunxi-rsb: Fix primary PMIC mapping hardware address
  ARM: dts: Fix UART wakeirq for omap4 duovero parlor
  ARM: OMAP2+: AM43xx: select ARM TWD timer
  ARM: OMAP2+: am43xx: enable GENERIC_CLOCKEVENTS_BROADCAST
  fsl-ifc: add missing include on ARM64
  ARM: dts: imx6: Fix Ethernet PHY mode on Ventana boards
  ARM: dts: imx: Fix the assigned-clock mismatch issue on imx6q/dl
  bus: sunxi-rsb: unlock on error in sunxi_rsb_read()
  ARM: dts: sunxi: sun6i-a31s-primo81.dts: add touchscreen axis swapping property

Enabling CPUFreq support for Tegra124 Chromebooks is causing the Tegra124
to hang when resuming from suspend.

When CPUFreq is enabled, the CPU clock is changed from the PLLX clock to
the DFLL clock during kernel boot. When resuming from suspend the CPU
clock is temporarily changed back to the PLLX clock before switching back
to the DFLL. If the DFLL is operating at a much lower frequency than the
PLLX when we enter suspend, and so the CPU voltage rail is at a voltage
too low for the CPUs to operate at the PLLX frequency, then the device
will hang.

Please note that the PLLX is used in the resume sequence to switch the CPU
clock from the very slow 32K clock to a faster clock during early resume
to speed up the resume sequence before the DFLL is resumed.

Ideally, we should fix this by setting the suspend frequency so that it
matches the PLLX frequency, however, that would be a bigger change. For
now simply disable CPUFreq support for Tegra124 Chromebooks to avoid the
hang when resuming from suspend.

Fixes: 9a0baee960a7 ("ARM: tegra: Enable CPUFreq support for Tegra124
		      Chromebooks")

Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Olof Johansson <olof@lixom.net>

Few fixes for omaps to allow am437x only builds to boot properly with
CPU_IDLE and ARM TWD timer. This is probably a common configuration setup
for people making products with these SoCs so let's make sure it works.

Also a wakeirq fix for duovero parlor making my life a bit easier as that
allows me to run basic PM regression tests on it.

It would be nice to have these in v4.4, but if it gets too late for that
because of the holidays, it is not super critical if these get merged for
v4.5.

* tag 'omap-for-v4.4/fixes-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
  ARM: dts: Fix UART wakeirq for omap4 duovero parlor
  ARM: OMAP2+: AM43xx: select ARM TWD timer
  ARM: OMAP2+: am43xx: enable GENERIC_CLOCKEVENTS_BROADCAST

Signed-off-by: Olof Johansson <olof@lixom.net>

The i.MX fixes for 4.4, 3rd round:
- Fix Ethernet PHY mode on i.MX6 Ventana boards, which can result in
  a non-functional Ethernet when Marvell phy driver rather than generic
  phy driver is selected.
- Fix an assigned-clock configuration bug on imx6qdl-sabreauto board
  which was introduced by commit ed339363de1b ("ARM: dts:
  imx6qdl-sabreauto: Allow HDMI and LVDS to work simultaneously").

* tag 'imx-fixes-4.4-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  ARM: dts: imx6: Fix Ethernet PHY mode on Ventana boards
  ARM: dts: imx: Fix the assigned-clock mismatch issue on imx6q/dl

Looks like we're missing the wakeirq for the console uart for
duovero parlor. Let's add that as without it console acess just
hangs with PM enabled.

Cc: Arun Bharadwaj <arun@gumstix.com>
Cc: Ash Charles <ash@gumstix.com>
Cc: Florian Vaussard <florian.vaussard@epfl.ch>
Signed-off-by: Tony Lindgren <tony@atomide.com>

Gateworks Ventana boards seem to need "RGMII-ID" (internal delay)
PHY mode, instead of simple "RGMII", for their Marvell 88E1510
transceiver. Otherwise, the Ethernet MAC doesn't work with Marvell PHY
driver (TX doesn't seem to work correctly).

Tested on GW5400 rev. C.

This bug affects ARM Fedora 23.

Signed-off-by: Krzysztof Hałasa <khalasa@piap.pl>
Acked-by: Tim Harvey <tharvey@gateworks.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

The 'assigned-clock-parents' and 'assigned-clock-rates' list
should corresponding to the 'assigned-clocks' property clock list.

Signed-off-by: Bai Ping <b51503@freescale.com>
Fixes: ed339363de1b ("ARM: dts: imx6qdl-sabreauto: Allow HDMI and LVDS to work simultaneously")
Cc: <stable@vger.kernel.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

Merge "Allwinner fixes for 4.4" from Maxime Ripard:

Allwinner fixes for 4.4

Two patches, one to fix the touchscreen axis on one Allwinner board, and
the other one fixing a mutex unlocking issue on one error path in the RSB
driver.

* tag 'sunxi-fixes-for-4.4' of https://git.kernel.org/pub/scm/linux/kernel/git/mripard/linux:
  bus: sunxi-rsb: unlock on error in sunxi_rsb_read()
  ARM: dts: sunxi: sun6i-a31s-primo81.dts: add touchscreen axis swapping property

Pull ARM SoC fixes from Arnd Bergmann:
 "Here are a bunch of small bug fixes for various ARM platforms, nothing
  really sticks out this week, most of either fixes bugs in code that
  was just added in 4.4, or that has been broken for many years without
  anyone noticing.

  at91/sama5d2:
   - fix sama5de hardware setup of sd/mmc interface
   - proper selection of pinctrl drivers.  PIO4 is necessary for sama5d2

  berlin:
   - fix incorrect clock input for SDIO

  exynos:
   - Fix potential NULL pointer dereference in Exynos PMU driver.

  imx:
   - Fix vf610 SAI clock configuration bug which is discovered by the
     newly added master mode support in SAI audio driver.
   - Fix buggy L2 cache latency values in vf610 device trees, which may
     cause system hang when cpu runs at a higher frequency.

  ixp4xx:
   - fix prototypes for readl/writel functions

  ls2080a:
   - use little-endian register access for GPIO and SDHCI

  omap:
   - Fix clock source for ARM TWD and global timers on am437x
   - Always select REGULATOR_FIXED_VOLTAGE for omap2+ instead of when
     MACH_OMAP3_PANDORA is selected
   - Fix SPI DMA handles for dm816x as only some were mapped
   - Fix up mbox cells for dm816x to make mailbox usable

  pxa:
   - use PWM lookup table for all ezx machines

  s3c24xx:
   - Remove incorrect __init annotation from s3c24xx cpufreq driver
     structures.

  versatile:
   - fix PCI IRQ mapping on Versatile PB"

* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  ls2080a/dts: Add little endian property for GPIO IP block
  dt-bindings: define little-endian property for QorIQ GPIO
  ARM64: dts: ls2080a: fix eSDHC endianness
  ARM: dts: vf610: use reset values for L2 cache latencies
  ARM: pxa: use PWM lookup table for all machines
  ARM: dts: berlin: add 2nd clock for BG2Q sdhci0 and sdhci1
  ARM: dts: berlin: correct BG2Q's sdhci2 2nd clock
  ARM: dts: am4372: fix clock source for arm twd and global timers
  ARM: at91: fix pinctrl driver selection
  ARM: at91/dt: add always-on to 1.8V regulator
  ARM: dts: vf610: fix clock definition for SAI2
  ARM: imx: clk-vf610: fix SAI clock tree
  ARM: ixp4xx: fix read{b,w,l} return types
  irqchip/versatile-fpga: Fix PCI IRQ mapping on Versatile PB
  ARM: OMAP2+: enable REGULATOR_FIXED_VOLTAGE
  ARM: dts: add dm816x missing spi DT dma handles
  ARM: dts: add dm816x missing #mbox-cells
  cpufreq: s3c24xx: Do not mark s3c2410_plls_add as __init
  ARM: EXYNOS: Fix potential NULL pointer access in exynos_sys_powerdown_conf

Merge "ARM: imx: fixes for 4.4, 2nd round" from Shawn Guo:

The i.MX fixes for 4.4, 2nd round:
- Fix vf610 SAI clock configuration bug which is discovered by the newly
  added master mode support in SAI audio driver.
- Fix buggy L2 cache latency values in vf610 device trees, which may
  cause system hang when cpu runs at a higher frequency.

* tag 'imx-fixes-4.4-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  ARM: dts: vf610: use reset values for L2 cache latencies
  ARM: dts: vf610: fix clock definition for SAI2
  ARM: imx: clk-vf610: fix SAI clock tree