Allwinner fixes for 4.13, take 3

This is a revert of the EMAC bindings. The discussion has not settled down
yet on a proper representation of the PHY, and therefore we cannot commit
to a binding yet

* tag 'sunxi-fixes-for-4.13-3' of https://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux:
  arm: dts: sunxi: Revert EMAC changes
  arm64: dts: allwinner: Revert EMAC changes
  dt-bindings: net: Revert sun8i dwmac binding

Signed-off-by: Olof Johansson <olof@lixom.net>

Since the discussion is not settled yet for the EMAC, and that the release
in getting really close, let's revert the changes for now, and we'll
reintroduce them later.

Acked-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>

CEC support was added for Exynos5 in 4.13, but for the Odroids we need to set
'needs-hpd' as well since CEC is disabled when there is no HDMI hotplug signal,
just as for the exynos4 Odroid-U3.

This is due to the level-shifter that is disabled when there is no HPD, thus
blocking the CEC signal as well. Same close-but-no-cigar board design as the
Odroid-U3.

Tested with my Odroid XU4.

Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Pull "i.MX fixes for 4.13, round 3" from Shawn Guo:

 - Fix PCIe reset GPIO of imx6qdl-nitrogen6_som2 board, which was
   a bad copy from nitrogen6_max device tree.

* tag 'imx-fixes-4.13-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  ARM: dts: imx6qdl-nitrogen6_som2: fix PCIe reset

Previous value was a bad copy of nitrogen6_max device tree.

Signed-off-by: Gary Bisson <gary.bisson@boundarydevices.com>
Fixes: 3faa1bb2e89c ("ARM: dts: imx: add Boundary Devices Nitrogen6_SOM2 support")
Cc: <stable@vger.kernel.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

Pull "DT fixes for 4.13" from Alexandre Belloni:

 - Fix NAND flash support for sama5d2

* tag 'at91-ab-4.13-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux:
  ARM: dts: at91: sama5d2: fix EBI/NAND controllers declaration
  ARM: dts: at91: sama5d2: use sama5d2 compatible string for SMC

Pull "i.MX fixes for 4.13, round 2" from Shawn Guo:

 - Add missing 'ranges' property for i.MX25 device tree TSCADC node, so
   that it's child nodes ADC and TSC device can be probed by kernel.
 - Fix i.MX GPCv2 power domain driver to request regulator after power
   domain initialization, since regulator could defer probing and
   therefore cause power domain initialized twice.

* tag 'imx-fixes-4.13-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  ARM: dts: i.MX25: add ranges to tscadc
  soc: imx: gpcv2: fix regulator deferred probe

Pull "i.MX fixes for 4.13" from Shawn Guo:

 - A fix for imx7d-sdb board to move pinctrl_spi4 pins from low power
   iomux controller to normal iomuxc node, as the pins belong to normal
   iomuxc rather than low power one.

* tag 'imx-fixes-4.13' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  ARM: dts: imx7d-sdb: Put pinctrl_spi4 in the correct location

Add a ranges; line to the tscadc node. This creates a 1:1 mapping between
the addresses used by tscadc and those in its child nodes (adc, tsc).

Without such a mapping, the reg = ... lines in the tsc and adc nodes do
not create a resource. Probing the fsl-imx25-tcq and fsl-imx25-tsadc
drivers will then fail since there's no IORESOURCE_MEM.

Signed-off-by: Martin Kaiser <martin@kaiser.cx>
Fixes: 92f651f39b42 ("ARM: dts: imx25: Add TSC and ADC support")
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

Pull "DaVinci fixes for v4.13" from Sekhar Nori:

Drop unused VPIF endpoints from device-tree.
They should be used only when an actual
remote-endpoint is connected.

* tag 'davinci-fixes-for-v4.13' of git://git.kernel.org/pub/scm/linux/kernel/git/nsekhar/linux-davinci:
  ARM: dts: da850-lcdk: drop unused VPIF endpoints
  ARM: dts: da850-evm: drop unused VPIF endpoints