Pull networking fixes from David Miller:
 "It looks like a decent sized set of fixes, but a lot of these are one
  liner off-by-one and similar type changes:

   1) Fix netlink header pointer to calcular bad attribute offset
      reported to user. From Pablo Neira Ayuso.

   2) Don't double clear PHY interrupts when ->did_interrupt is set,
      from Heiner Kallweit.

   3) Add missing validation of various (devlink, nl802154, fib, etc.)
      attributes, from Jakub Kicinski.

   4) Missing *pos increments in various netfilter seq_next ops, from
      Vasily Averin.

   5) Missing break in of_mdiobus_register() loop, from Dajun Jin.

   6) Don't double bump tx_dropped in veth driver, from Jiang Lidong.

   7) Work around FMAN erratum A050385, from Madalin Bucur.

   8) Make sure ARP header is pulled early enough in bonding driver,
      from Eric Dumazet.

   9) Do a cond_resched() during multicast processing of ipvlan and
      macvlan, from Mahesh Bandewar.

  10) Don't attach cgroups to unrelated sockets when in interrupt
      context, from Shakeel Butt.

  11) Fix tpacket ring state management when encountering unknown GSO
      types. From Willem de Bruijn.

  12) Fix MDIO bus PHY resume by checking mdio_bus_phy_may_suspend()
      only in the suspend context. From Heiner Kallweit"

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (112 commits)
  net: systemport: fix index check to avoid an array out of bounds access
  tc-testing: add ETS scheduler to tdc build configuration
  net: phy: fix MDIO bus PM PHY resuming
  net: hns3: clear port base VLAN when unload PF
  net: hns3: fix RMW issue for VLAN filter switch
  net: hns3: fix VF VLAN table entries inconsistent issue
  net: hns3: fix "tc qdisc del" failed issue
  taprio: Fix sending packets without dequeueing them
  net: mvmdio: avoid error message for optional IRQ
  net: dsa: mv88e6xxx: Add missing mask of ATU occupancy register
  net: memcg: fix lockdep splat in inet_csk_accept()
  s390/qeth: implement smarter resizing of the RX buffer pool
  s390/qeth: refactor buffer pool code
  s390/qeth: use page pointers to manage RX buffer pool
  seg6: fix SRv6 L2 tunnels to use IANA-assigned protocol number
  net: dsa: Don't instantiate phylink for CPU/DSA ports unless needed
  net/packet: tpacket_rcv: do not increment ring index on drop
  sxgbe: Fix off by one in samsung driver strncpy size arg
  net: caif: Add lockdep expression to RCU traversal primitive
  MAINTAINERS: remove Sathya Perla as Emulex NIC maintainer
  ...

Pull ARM SoC fixes from Olof Johansson:
 "We've been accruing these for a couple of weeks, so the batch is a bit
  bigger than usual.

  Largest delta is due to a led-bl driver that is added -- there was a
  miscommunication before the merge window and the driver didn't make it
  in. Due to this, the platforms needing it regressed. At this point, it
  seemed easier to add the new driver than unwind the changes.

  Besides that, there are a handful of various fixes:

   - AMD tee memory leak fix

   - A handful of fixlets for i.MX SCU communication

   - A few maintainers woke up and realized DEBUG_FS had been missing
     for a while, so a few updates of that.

  ... and the usual collection of smaller fixes to various platforms"

* tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (37 commits)
  ARM: socfpga_defconfig: Add back DEBUG_FS
  arm64: dts: socfpga: agilex: Fix gmac compatible
  ARM: bcm2835_defconfig: Explicitly restore CONFIG_DEBUG_FS
  arm64: dts: meson: fix gxm-khadas-vim2 wifi
  arm64: dts: meson-sm1-sei610: add missing interrupt-names
  ARM: meson: Drop unneeded select of COMMON_CLK
  ARM: dts: bcm2711: Add pcie0 alias
  ARM: dts: bcm283x: Add missing properties to the PWR LED
  tee: amdtee: fix memory leak in amdtee_open_session()
  ARM: OMAP2+: Fix compile if CONFIG_HAVE_ARM_SMCCC is not set
  arm: dts: dra76x: Fix mmc3 max-frequency
  ARM: dts: dra7: Add "dma-ranges" property to PCIe RC DT nodes
  bus: ti-sysc: Fix 1-wire reset quirk
  ARM: dts: r8a7779: Remove deprecated "renesas, rcar-sata" compatible value
  soc: imx-scu: Align imx sc msg structs to 4
  firmware: imx: Align imx_sc_msg_req_cpu_start to 4
  firmware: imx: scu-pd: Align imx sc msg structs to 4
  firmware: imx: misc: Align imx sc msg structs to 4
  firmware: imx: scu: Ensure sequential TX
  ARM: dts: imx7-colibri: Fix frequency for sd/mmc
  ...

FMAN DMA read or writes under heavy traffic load may cause FMAN
internal resource leak; thus stopping further packet processing.

The FMAN internal queue can overflow when FMAN splits single
read or write transactions into multiple smaller transactions
such that more than 17 AXI transactions are in flight from FMAN
to interconnect. When the FMAN internal queue overflows, it can
stall further packet processing. The issue can occur with any one
of the following three conditions:

  1. FMAN AXI transaction crosses 4K address boundary (Errata
     A010022)
  2. FMAN DMA address for an AXI transaction is not 16 byte
     aligned, i.e. the last 4 bits of an address are non-zero
  3. Scatter Gather (SG) frames have more than one SG buffer in
     the SG list and any one of the buffers, except the last
     buffer in the SG list has data size that is not a multiple
     of 16 bytes, i.e., other than 16, 32, 48, 64, etc.

With any one of the above three conditions present, there is
likelihood of stalled FMAN packet processing, especially under
stress with multiple ports injecting line-rate traffic.

To avoid situations that stall FMAN packet processing, all of the
above three conditions must be avoided; therefore, configure the
system with the following rules:

  1. Frame buffers must not span a 4KB address boundary, unless
     the frame start address is 256 byte aligned
  2. All FMAN DMA start addresses (for example, BMAN buffer
     address, FD[address] + FD[offset]) are 16B aligned
  3. SG table and buffer addresses are 16B aligned and the size
     of SG buffers are multiple of 16 bytes, except for the last
     SG buffer that can be of any size.

Additional workaround notes:
- Address alignment of 64 bytes is recommended for maximally
efficient system bus transactions (although 16 byte alignment is
sufficient to avoid the stall condition)
- To support frame sizes that are larger than 4K bytes, there are
two options:
  1. Large single buffer frames that span a 4KB page boundary can
     be converted into SG frames to avoid transaction splits at
     the 4KB boundary,
  2. Align the large single buffer to 256B address boundaries,
     ensure that the frame address plus offset is 256B aligned.
- If software generated SG frames have buffers that are unaligned
and with random non-multiple of 16 byte lengths, before
transmitting such frames via FMAN, frames will need to be copied
into a new single buffer or multiple buffer SG frame that is
compliant with the three rules listed above.

Signed-off-by: Madalin Bucur <madalin.bucur@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull devicetree fixes from Rob Herring:
 "Another batch of DT fixes. I think this should be the last of it, but
  sending pull requests seems to cause people to send more fixes.

  Summary:

   - Fixes for warnings introduced by hierarchical PSCI binding changes

   - Fixes for broken doc references due to DT schema conversions

   - Several grammar and typo fixes

   - Fix a bunch of dtc warnings in examples"

* tag 'devicetree-fixes-for-5.6-3' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux:
  dt-bindings: arm: Fixup the DT bindings for hierarchical PSCI states
  dt-bindings: power: Extend nodename pattern for power-domain providers
  MAINTAINERS: update ALLWINNER CPUFREQ DRIVER entry
  dt-bindings: bus: Drop empty compatible string in example
  dt-bindings: power: Convert domain-idle-states bindings to json-schema
  dt-bindings: arm: Fix cpu compatibles in the hierarchical example for PSCI
  dt-bindings: arm: Correct links to idle states definitions
  dt-bindings: mfd: Fix typo in file name of twl-familly.txt
  dt-bindings: mfd: tps65910: Improve grammar
  dt-bindings: mfd: zii,rave-sp: Fix a typo ("onborad")
  dt-bindings: arm: fsl: fix APF6Dev compatible
  dt-bindings: Fix dtc warnings in examples
  docs: dt: fix several broken doc references
  docs: dt: fix several broken references due to renames
  MAINTAINERS: clean up PCIE DRIVER FOR CAVIUM THUNDERX

Pull regulator fixes from Mark Brown:
 "A couple of small fixes, one for a minor issue in the stm32-vrefbuf
  driver and a documentation fix in the Qualcomm code"

* tag 'regulator-fix-v5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator:
  regulator: stm32-vrefbuf: fix a possible overshoot when re-enabling
  regulator: qcom_spmi: Fix docs for PM8004

The hierarchical topology with power-domain should be described through
child nodes, rather than as currently described in the PSCI root node. Fix
this by adding a patternProperties with a corresponding reference to the
power-domain DT binding.

Additionally, update the example to conform to the new pattern, but also to
the adjusted domain-idle-state DT binding.

Fixes: a3f048b5424e ("dt: psci: Update DT bindings to support hierarchical PSCI states")
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
[robh: Add missing allOf, tweak power-domain node name]
Signed-off-by: Rob Herring <robh@kernel.org>

The existing binding requires the nodename to have a '@', which is a bit
limiting for the wider use case. Therefore, let's extend the pattern to
allow either '@' or '-'.

Fixes: a3f048b5424e ("dt: psci: Update DT bindings to support hierarchical PSCI states")
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
[robh: drop example change]
Signed-off-by: Rob Herring <robh@kernel.org>

In preparation to add generic checks of compatible strings, drop
the compatible as '...' is not a valid compatible string.

Cc: Maxime Ripard <mripard@kernel.org>
Cc: Chen-Yu Tsai <wens@csie.org>
Cc: linux-arm-kernel@lists.infradead.org
Signed-off-by: Rob Herring <robh@kernel.org>

While converting to the json-schema, let's also take the opportunity to
further specify/clarify some more details about the DT binding.

For example, let's define the label where to put the states nodes, set a
pattern for nodename of the state nodes and finally add an example.

Fixes: a3f048b5424e ("dt: psci: Update DT bindings to support hierarchical PSCI states")
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
[robh: drop type refs from standard unit properties]
Signed-off-by: Rob Herring <robh@kernel.org>

Fixes: a3f048b5424e ("dt: psci: Update DT bindings to support hierarchical PSCI states")
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Rob Herring <robh@kernel.org>