Pull USB and PHY driver fixes from Greg KH:
 "Here are some USB and PHY driver fixes that resolve some reported
  regressions.  Also in here are some new device ids.

  All of the details are in the shortlog and these patches have been in
  linux-next with no problems"

* tag 'usb-4.1-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb: (22 commits)
  USB: cp210x: add ID for HubZ dual ZigBee and Z-Wave dongle
  usb: renesas_usbhs: Don't disable the pipe if Control write status stage
  usb: renesas_usbhs: Fix fifo unclear in usbhsf_prepare_pop
  usb: gadget: f_fs: fix check in read operation
  usb: musb: fix order of conditions for assigning end point operations
  usb: gadget: f_uac1: check return code from config_ep_by_speed
  usb: gadget: ffs: fix: Always call ffs_closed() in ffs_data_clear()
  usb: gadget: g_ffs: Fix counting of missing_functions
  usb: s3c2410_udc: correct reversed pullup logic
  usb: dwc3: gadget: Fix incorrect DEPCMD and DGCMD status macros
  usb: phy: tahvo: Pass the IRQF_ONESHOT flag
  usb: phy: ab8500-usb: Pass the IRQF_ONESHOT flag
  usb: renesas_usbhs: Revise the binding document about the dma-names
  usb: host: xhci: add mutex for non-thread-safe data
  usb: make module xhci_hcd removable
  USB: serial: ftdi_sio: Add support for a Motion Tracker Development Board
  usb: gadget: f_midi: fix segfault when reading empty id
  phy: phy-rcar-gen2: Fix USBHS_UGSTS_LOCK value
  phy: omap-usb2: invoke pm_runtime_disable on error path
  phy: fix Kconfig dependencies
  ...

Felipe writes:

usb: fixes for v4.1-rc5

A few late important fixes which have been pending
on mailing list due to my vacations.

The important fixes are a fix for DEPCMD and DGCMD
status bitfields on DWC3, a couple fixes for Renesas
USB Controller, one of which prevents a broken DT
binding from reaching v4.1-final, and an old fix for
s3c2410-udc where pullup logic was reversed.

Signed-off-by: Felipe Balbi <balbi@ti.com>

Since the DT should describe the hardware (not the driver limitation),
This patch revises the binding document about the dma-names to change
simple numbering as "ch%d" instead of "tx<n>" and "rx<n>".

Also this patch fixes the actual code of renesas_usbhs driver to handle
the new dma-names.

Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Acked-by: Mark Rutland <mark.rutland@arm.com>
Acked-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Felipe Balbi <balbi@ti.com>

Pull networking fixes from David Miller:

 1) Don't leak ipvs->sysctl_tbl, from Tommi Rentala.

 2) Fix neighbour table entry leak in rocker driver, from Ying Xue.

 3) Do not emit bonding notifications for unregistered interfaces, from
    Nicolas Dichtel.

 4) Set ipv6 flow label properly when in TIME_WAIT state, from Florent
    Fourcot.

 5) Fix regression in ipv6 multicast filter test, from Henning Rogge.

 6) do_replace() in various footables netfilter modules is missing a
    check for 0 counters in the datastructure provided by the user.  Fix
    from Dave Jones, and found with trinity.

 7) Fix RCU bug in packet scheduler classifier module unloads, from
    Daniel Borkmann.

 8) Avoid deadlock in tcp_get_info() by using u64_sync.  From Eric
    Dumzaet.

 9) Input packet processing can race with inetdev_destroy() teardown,
    fix potential OOPS in ip_error() by explicitly testing whether the
    inetdev is still attached.  From Eric W Biederman.

10) MLDv2 parser in bridge multicast code breaks too early while
    parsing.  Fix from Thadeu Lima de Souza Cascardo.

11) Asking for settings on non-zero PHYID doesn't work because we do not
    import the command structure from the user and use the PHYID
    provided there.  Fix from Arun Parameswaran.

12) Fix UDP checksums with IPV6 RAW sockets, from Vlad Yasevich.

13) Missing NF_TABLES depends for TPROXY etc can cause build failures,
    fix from Florian Westphal.

14) Fix netfilter conntrack to handle RFC5961 challenge ACKs properly,
    from Jesper Dangaard Brouer.

15) If netlink autobind retry fails, we have to reset the sockets portid
    back to zero.  From Herbert Xu.

16) VXLAN netns exit code unregisters using wrong device, from John W
    Linville.

17) Add some USB device IDs to ath3k and btusb bluetooth drivers, from
    Dmitry Tunin and Wen-chien Jesse Sung.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (44 commits)
  bridge: fix lockdep splat
  net: core: 'ethtool' issue with querying phy settings
  bridge: fix parsing of MLDv2 reports
  ARM: zynq: DT: Use the zynq binding with macb
  net: macb: Disable half duplex gigabit on Zynq
  net: macb: Document zynq gem dt binding
  ipv4: fill in table id when replacing a route
  cdc_ncm: Fix tx_bytes statistics
  ipv4: Avoid crashing in ip_error
  tcp: fix a potential deadlock in tcp_get_info()
  net: sched: fix call_rcu() race on classifier module unloads
  net: phy: Make sure phy_start() always re-enables the phy interrupts
  ipv6: fix ECMP route replacement
  ipv6: do not delete previously existing ECMP routes if add fails
  Revert "netfilter: bridge: query conntrack about skb dnat"
  netfilter: ensure number of counters is >0 in do_replace()
  netfilter: nfnetlink_{log,queue}: Register pernet in first place
  tcp: don't over-send F-RTO probes
  tcp: only undo on partial ACKs in CA_Loss
  net/ipv6/udp: Fix ipv6 multicast socket filter regression
  ...

Signed-off-by: Nathan Sullivan <nathan.sullivan@ni.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull clk fixes from Michael Turquette:
 "The first set of clk fixes for 4.1 are all driver bugs, with the
  exception of a single locking fix in the core code.

  All driver fixes are for code that was merged recently.  The Samsung
  stuff is mostly fixes around suspend/resume, the Qualcomm fixes are
  for invalid hardware configuration data and the Silicon Labs patches
  are fixes following their move away from platform_data to Device Tree"

* tag 'clk-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux:
  clk: si5351: Do not pass struct clk in platform_data
  clk: si5351: Mention clock-names in the binding documentation
  clk: add missing lock when call clk_core_enable in clk_set_parent
  clk: exynos5420: Restore GATE_BUS_TOP on suspend
  clk: qcom: Fix MSM8916 gfx3d_clk_src configuration
  clk: qcom: Fix MSM8916 venus divider value
  clk: exynos5433: Fix wrong PMS value of exynos5433_pll_rates
  clk: exynos5433: Fix wrong parent clock of sclk_apollo clock
  clk: exynos5433: Fix CLK_PCLK_MONOTONIC_CNT clk register assignment
  clk: exynos5433: Fix wrong offset of PCLK_MSCL_SECURE_SMMU_JPEG
  clk: Use CONFIG_ARCH_EXYNOS instead of CONFIG_ARCH_EXYNOS5433

Pull MTD fixes from Brian Norris:
 "Two MTD fixes for 4.1:

   - readtest: the signal-handling code was clobbering the error codes
     we should be handling/reporting in this test, rendering it useless.
     Noticed by Coverity.

   - the common SPI NOR flash DT binding (merged for 4.1-rc1) is being
     revised, so let's change that before 4.1 is minted"

* tag 'for-linus-20150516' of git://git.infradead.org/linux-mtd:
  Documentation: dt: mtd: replace "nor-jedec" binding with "jedec, spi-nor"
  mtd: readtest: don't clobber error reports

In commit 8ff16cf77ce3 ("Documentation: devicetree: m25p80: add "nor-jedec"
binding"), we added a generic "nor-jedec" binding to catch all
mostly-compatible SPI NOR flash which can be detected via the READ ID
opcode (0x9F). This was discussed and reviewed at the time, however
objections have come up since then as part of this discussion:

  http://lkml.kernel.org/g/20150511224646.GJ32500@ld-irv-0074

It seems the parties involved agree that "jedec,spi-nor" does a better
job of capturing the fact that this is SPI-specific, not just any NOR
flash.

This binding was only merged for v4.1-rc1, so it's still OK to change
the naming.

At the same time, let's move the documentation to a better name.

Next up: stop referring to code (drivers/mtd/devices/m25p80.c) from the
documentation.

Signed-off-by: Brian Norris <computersforpeace@gmail.com>
Cc: Marek Vasut <marex@denx.de>
Cc: Rafał Miłecki <zajec5@gmail.com>
Cc: Rob Herring <robh+dt@kernel.org>
Cc: Pawel Moll <pawel.moll@arm.com>
Cc: Ian Campbell <ijc+devicetree@hellion.org.uk>
Cc: Kumar Gala <galak@codeaurora.org>
Cc: devicetree@vger.kernel.org
Acked-by: Stephen Warren <swarren@nvidia.com>
Acked-by: Geert Uytterhoeven <geert+renesas@glider.be>
Acked-by: Mark Rutland <mark.rutland@arm.com>

Pull ARM SoC fixes from Arnd Bergmann:
 "A few patches have come up since the merge window.  The largest one is
  a rewrite of the PXA lubbock/mainstone IRQ handling.  This was already
  broken in 2011 by a change to the GPIO code and only noticed now.

  The other changes contained here are:

  MAINTAINERS file updates:

   - Ray Jui and Scott Branden are now co-maintainers for some of the
     mach-bcm chips, while Christian Daudt and Marc Carino have stepped
     down.

   - Andrew Victor is no longer maintaining at91.  Instead, Alexandre
     Belloni now becomes an official maintainer, after having done a
     bulk of the work for a while.

   - Baruch Siach, who added the mach-digicolor platform in 4.1 is now
     listed as maintainer

   - The git URL for mach-socfpga has changed

  Bug fixes:

   - Three bug fixes for new rockchip rk3288 code

   - A regression fix to make SD card support work on certain ux500
     boards

   - multiple smaller dts fixes for imx, omap, mvebu, and shmobile

   - a regression fiix for omap3 power consumption

   - a fix for regression in the ARM CCI bus driver

  Configuration changes:

   - more imx platforms are now enabled in multi_v7_defconfig"

* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (39 commits)
  MAINTAINERS: add Conexant Digicolor machines entry
  MAINTAINERS: socfpga: update the git repo for SoCFPGA
  ARM: multi_v7_defconfig: Select more FSL SoCs
  MAINTAINERS: replace an AT91 maintainer
  drivers: CCI: fix used_mask init in validate_group()
  bus: omap_l3_noc: Fix master id address decoding for OMAP5
  bus: omap_l3_noc: Fix offset for DRA7 CLK1_HOST_CLK1_2 instance
  ARM: dts: dra7: Fix efuse register size for ABB
  ARM: dts: am57xx-beagle-x15: Switch GPIO fan number
  ARM: dts: am57xx-beagle-x15: Switch UART mux pins
  ARM: dts: am437x-sk: reduce col-scan-delay-us
  ARM: dts: am437x-sk: fix for new newhaven display module revision
  ARM: dts: am57xx-beagle-x15: Fix RTC aliases
  ARM: dts: am57xx-beagle-x15: Fix IRQ type for mcp7941x
  ARM: dts: omap3: Add #iommu-cells to isp and iva iommu
  ARM: omap2plus_defconfig: Enable EXTCON_USB_GPIO
  ARM: dts: OMAP3-N900: Add microphone bias voltages
  ARM: OMAP2+: Fix omap off idle power consumption creeping up
  MAINTAINERS: Update brcmstb entry
  MAINTAINERS: Remove Christian Daudt for mach-bcm
  ...

Since the introduction of clk-si5351 the way we should deal with DT provided
clocks has changed from indexed to named clock phandles. Amend the binding
documentation to reflect named clock phandles by clock-names property.

Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
Signed-off-by: Michael Turquette <mturquette@linaro.org>