Pull tty / serial updates from Greg KH:
 "Here is the big set of tty/serial driver changes for 6.10-rc1.
  Included in here are:

   - Usual good set of api cleanups and evolution by Jiri Slaby to make
     the serial interfaces move out of the 1990's by using kfifos
     instead of hand-rolling their own logic.

   - 8250_exar driver updates

   - max3100 driver updates

   - sc16is7xx driver updates

   - exar driver updates

   - sh-sci driver updates

   - tty ldisc api addition to help refuse bindings

   - other smaller serial driver updates

  All of these have been in linux-next for a while with no reported
  issues"

* tag 'tty-6.10-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty: (113 commits)
  serial: Clear UPF_DEAD before calling tty_port_register_device_attr_serdev()
  serial: imx: Raise TX trigger level to 8
  serial: 8250_pnp: Simplify "line" related code
  serial: sh-sci: simplify locking when re-issuing RXDMA fails
  serial: sh-sci: let timeout timer only run when DMA is scheduled
  serial: sh-sci: describe locking requirements for invalidating RXDMA
  serial: sh-sci: protect invalidating RXDMA on shutdown
  tty: add the option to have a tty reject a new ldisc
  serial: core: Call device_set_awake_path() for console port
  dt-bindings: serial: brcm,bcm2835-aux-uart: convert to dtschema
  tty: serial: uartps: Add support for uartps controller reset
  arm64: zynqmp: Add resets property for UART nodes
  dt-bindings: serial: cdns,uart: Add optional reset property
  serial: 8250_pnp: Switch to DEFINE_SIMPLE_DEV_PM_OPS()
  serial: 8250_exar: Keep the includes sorted
  serial: 8250_exar: Make type of bit the same in exar_ee_*_bit()
  serial: 8250_exar: Use BIT() in exar_ee_read()
  serial: 8250_exar: Switch to use dev_err_probe()
  serial: 8250_exar: Return directly from switch-cases
  serial: 8250_exar: Decrease indentation level
  ...

Pull more SoC devicetree updates from Arnd Bergmann:
 "This is a follow-up to an earlier pull request for device tree
  changes, as three platform maintainers sent their contents too late to
  be included in the main set, but had not caused any further problems
  since then:

   - The Amlogic platform now containts support for two new SoC types,
     the A4 and A5 chips for audio applications. Both come with a
     reference board, and one more dts file gets addded for the
     combination of the MNT Reform Laptop with the BPI-CM4 CPU module

   - The ASpeed platform adds support for six addititional server
     platforms that use ast2500 or ast2600 as their BMC, while another
     one gets removed

   - The RISC-V platforms from Microchip, Starfive and and T-HEAD get
     additional features for existing hardware, plus the addition of the
     Milk-V Mars based on the StarFive VisionFive v2 board"

* tag 'soc-dt-late-6.10' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (76 commits)
  riscv: dts: microchip: add pac1934 power-monitor to icicle
  riscv: dts: thead: Fix node ordering in TH1520 device tree
  ARM: dts: aspeed: Add ASRock E3C256D4I BMC
  dt-bindings: arm: aspeed: document ASRock E3C256D4I
  dt-bindings: trivial-devices: add isil,isl69269
  ARM: dts: aspeed: x4tf: Add dts for asus x4tf project
  dt-bindings: arm: aspeed: add ASUS X4TF board
  ARM: dts: aspeed: Remove Facebook Cloudripper dts
  ARM: dts: aspeed: drop unused ref_voltage ADC property
  ARM: dts: aspeed: harma: correct Mellanox multi-host property
  ARM: dts: aspeed: yosemitev2: correct Mellanox multi-host property
  ARM: dts: aspeed: yosemite4: correct Mellanox multi-host property
  ARM: dts: aspeed: greatlakes: correct Mellanox multi-host property
  ARM: dts: aspeed: Modify I2C bus configuration
  ARM: dts: aspeed: Disable unused ADC channels for Asrock X570D4U BMC
  ARM: dts: aspeed: Modify GPIO table for Asrock X570D4U BMC
  ARM: dts: aspeed: yosemite4: set bus13 frequency to 100k
  ARM: dts: Aspeed: Bonnell: Fix NVMe LED labels
  ARM: dts: aspeed: yosemite4: Enable ipmb device for OCP debug card
  ARM: dts: aspeed: ahe50dc: Update lm25066 regulator name
  ...

Pull devicetree updates from Rob Herring:
 "DT Bindings:

   - Convert samsung,exynos5-dp, atmel,lcdc, aspeed,ast2400-wdt bindings
     to schemas

   - Add bindings for Allwinner H616 NMI controller, Renesas r8a779g0
     irqc, Renesas R-Car V4M TMU and CMT timers, Freescale S32G3
     linflexuart, and Mediatek MT7988 XHCI

   - Add 'reg' constraints on DSI and SPI display panels

   - More dropping of unnecessary quotes in schemas

   - Use full paths rather than relative paths in schema $refs

   - Drop redundant storing of phandle for reserved memory

  DT Core:

   - Use scope based cleanups for kfree() and of_node_put()

   - Track interrupt-map and power-supplies for fw_devlink

   - Add buffer overflow check in of_modalias()

   - Add and use __of_prop_free() helper for freeing struct property"

* tag 'devicetree-for-6.10' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux: (25 commits)
  of: property: Add fw_devlink support for interrupt-map property
  dt-bindings: display: panel: constrain 'reg' in DSI panels
  dt-bindings: display: panel: constrain 'reg' in SPI panels
  dt-bindings: display: samsung,ams495qa01: add missing SPI properties ref
  dt-bindings: Use full path to other schemas
  dt-bindings: PCI: qcom,pcie-sm8350: Drop redundant 'oneOf' sub-schema
  of: module: add buffer overflow check in of_modalias()
  dt-bindings: PCI: microchip: increase number of items in ranges property
  dt-bindings: Drop unnecessary quotes on keys
  dt-bindings: interrupt-controller: mediatek,mt6577-sysirq: Drop unnecessary quotes
  of: property: Use scope based cleanup on port_node
  of: reserved_mem: Remove the use of phandle from the reserved_mem APIs
  of: property: fw_devlink: Add support for "power-supplies" binding
  dt-bindings: watchdog: aspeed,ast2400-wdt: Convert to DT schema
  dt-bindings: irq: sun7i-nmi: Add binding for the H616 NMI controller
  dt-bindings: interrupt-controller: renesas,irqc: Add r8a779g0 support
  dt-bindings: timer: renesas,tmu: Add R-Car V4M support
  dt-bindings: timer: renesas,cmt: Add R-Car V4M support
  of: Use scope based of_node_put() cleanups
  of: Use scope based kfree() cleanups
  ...

Pull SoC driver updates from Arnd Bergmann:
 "As usual, these are updates for drivers that are specific to certain
  SoCs or firmware running on them.

  Notable updates include

   - The new STMicroelectronics STM32 "firewall" bus driver that is used
     to provide a barrier between different parts of an SoC

   - Lots of updates for the Qualcomm platform drivers, in particular
     SCM, which gets a rewrite of its initialization code

   - Firmware driver updates for Arm FF-A notification interrupts and
     indirect messaging, SCMI firmware support for pin control and
     vendor specific interfaces, and TEE firmware interface changes
     across multiple TEE drivers

   - A larger cleanup of the Mediatek CMDQ driver and some related bits

   - Kconfig changes for riscv drivers to prepare for adding Kanaan k230
     support

   - Multiple minor updates for the TI sysc bus driver, memory
     controllers, hisilicon hccs and more"

* tag 'soc-drivers-6.10' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (103 commits)
  firmware: qcom: uefisecapp: Allow on sc8180x Primus and Flex 5G
  soc: qcom: pmic_glink: Make client-lock non-sleeping
  dt-bindings: soc: qcom,wcnss: fix bluetooth address example
  soc/tegra: pmc: Add EQOS wake event for Tegra194 and Tegra234
  bus: stm32_firewall: fix off by one in stm32_firewall_get_firewall()
  bus: etzpc: introduce ETZPC firewall controller driver
  firmware: arm_ffa: Avoid queuing work when running on the worker queue
  bus: ti-sysc: Drop legacy idle quirk handling
  bus: ti-sysc: Drop legacy quirk handling for smartreflex
  bus: ti-sysc: Drop legacy quirk handling for uarts
  bus: ti-sysc: Add a description and copyrights
  bus: ti-sysc: Move check for no-reset-on-init
  soc: hisilicon: kunpeng_hccs: replace MAILBOX dependency with PCC
  soc: hisilicon: kunpeng_hccs: Add the check for obtaining complete port attribute
  firmware: arm_ffa: Fix memory corruption in ffa_msg_send2()
  bus: rifsc: introduce RIFSC firewall controller driver
  of: property: fw_devlink: Add support for "access-controller"
  soc: mediatek: mtk-socinfo: Correct the marketing name for MT8188GV
  soc: mediatek: mtk-socinfo: Add entry for MT8395AV/ZA Genio 1200
  soc: mediatek: mtk-mutex: Add support for MT8188 VPPSYS
  ...

Convert the Broadcom BCM2835 Auxiliary UART to newer DT schema.
Created DT schema based on the .txt file which had
`compatible`, `reg` `clocks` and `interrupts` as the
required properties. This binding is used by Broadcom BCM2835
SOC used in some Raspberry PI boards.
Changes from original file:
Implemented complete example which the original txt binding lacked.

Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Reviewed-by: Conor Dooley <conor.dooley@microchip.com>
Signed-off-by: Pratik Farkase <pratik.farkase@wsisweden.com>
Link: https://lore.kernel.org/r/20240425162554.13576-1-pratik.farkase@wsisweden.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Add optional reset device-tree property to the uartps controller.

Signed-off-by: Manikanta Guntupalli <manikanta.guntupalli@amd.com>
Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://lore.kernel.org/r/20240425062358.1347684-2-manikanta.guntupalli@amd.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

We want the tty fixes in here as well, and it resolves a merge conflict
in:
	drivers/tty/serial/serial_core.c
as well.

Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Add a compatible string for the uart binding of NXP S32G3 platforms. Here
we use "s32v234-linflexuart" as fallback since the current linflexuart
driver can still work on S32G3.

Signed-off-by: Wadim Mueller <wafgo01@gmail.com>
Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://lore.kernel.org/r/20240324214329.29988-3-wafgo01@gmail.com
Signed-off-by: Rob Herring <robh@kernel.org>

Amlogic A4 SoCs uses the same UART controller as S4 SoCs and G12A.
There is no need for an extra compatible line in the driver, but
add A4 compatible line for documentation.

Signed-off-by: Xianwei Zhao <xianwei.zhao@amlogic.com>
Acked-by: Conor Dooley <conor.dooley@microchip.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Link: https://lore.kernel.org/r/20240401-basic_dt-v3-3-cb29ae1c16da@amlogic.com
Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>

I'm working now at bootlin, so I'll use my bootlin address for kernel
development from now on.

Update also the yaml file for atmel-serial accordingly.

Signed-off-by: Richard Genoud <richard.genoud@bootlin.com>
Reviewed-by: Nicolas Ferre <nicolas.ferre@microchip.com>
Link: https://lore.kernel.org/r/20240408101329.9448-1-richard.genoud@bootlin.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>