Pull RTC updates from Alexandre Belloni:
 "It is now possible to add custom sysfs attributes while avoiding a
  possible race condition. Unused code has been removed resulting in a
  nice reduction of the code base. And more drivers have been switched
  to SPDX by their maintainers.

 Summary:

  Subsystem:
   - new helpers to add custom sysfs attributes
   - struct rtc_task removal along with rtc_irq_[un]register()
   - rtc_irq_set_state and rtc_irq_set_freq are not exported anymore

  Drivers:
   - armada38x: reset after rtc power loss
   - ds1307: now supports m41t11
   - isl1208: now supports isl1219 and tamper detection
   - pcf2127: internal SRAM support"

* tag 'rtc-4.19' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux: (34 commits)
  rtc: ds1307: simplify hwmon config
  rtc: s5m: Add SPDX license identifier
  rtc: maxim: Add SPDX license identifiers
  rtc: isl1219: add device tree documentation
  rtc: isl1208: set ev-evienb bit from device tree
  rtc: isl1208: Add "evdet" interrupt source for isl1219
  rtc: isl1208: add support for isl1219 with tamper detection
  rtc: sysfs: facilitate attribute add to rtc device
  rtc: remove struct rtc_task
  char: rtc: remove task handling
  rtc: pcf85063: preserve control register value between stop and start
  rtc: sh: remove unused variable rtc_dev
  rtc: unexport rtc_irq_set_*
  rtc: simplify rtc_irq_set_state/rtc_irq_set_freq
  rtc: remove irq_task and irq_task_lock
  rtc: remove rtc_irq_register/rtc_irq_unregister
  rtc: sh: remove dead code
  rtc: sa1100: don't set PIE frequency
  rtc: ds1307: support m41t11 variant
  rtc: ds1307: fix data pointer to m41t0
  ...

The devicetree documentation for the ISL1219 device tree
binding is added with a short example. It is not a trivial
device, because it supports two interrupt sources.

Signed-off-by: Denis Osterland <Denis.Osterland@diehl.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

'interrupt-parent' is often documented as part of define bindings, but
it is really outside the scope of a device binding. It's never required
in a given node as it is often inherited from a parent node. Or it can
be implicit if a parent node is an 'interrupt-controller' node. So
remove it from all the binding files.

Cc: Mark Rutland <mark.rutland@arm.com>
Cc: devicetree@vger.kernel.org
Signed-off-by: Rob Herring <robh@kernel.org>

The m41t11 variant is very similar to the already supported m41t00 and
m41t0, but it has also 56 bytes of NVRAM.

Add it to driver taking into account NVRAM section.

Signed-off-by: Giulio Benetti <giulio.benetti@micronovasrl.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

RTC embedded in stm32mp1 SoC is slightly different from stm32h7 one, it
doesn't require to disable backup domain write protection, and rtc_ck
parent clock assignment isn't allowed.
To sum up, stm32mp1 RTC requires 2 clocks, pclk and rtc_ck, and an RTC
alarm interrupt.

Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

According to Devicetree Specification v0.2 document:

"The name of a node should be somewhat generic, reflecting the function
of the device and not its precise programming model."

Do as suggested in the binding example.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

RTC driver should not be aware of the PWR registers offset and bits
position. Furthermore, we can imagine that Disable Backup Protection (DBP)
relative register and bit mask could change depending on the SoC. So this
patch moves st,syscfg property from single pwrcfg phandle to pwrcfg
phandle/offset/mask triplet.

Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
Acked-by: Alexandre TORGUE <alexandre.torgue@st.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

The ISL12026 is a combination RTC and EEPROM device with I2C
interface.  The standard RTC driver interface is provided.  The EEPROM
is accessed via the NVMEM interface.

Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Signed-off-by: David Daney <david.daney@cavium.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Document the binding for i.MX53 SRTC implemented by rtc-mxc_v2

Signed-off-by: Patrick Bruenn <p.bruenn@beckhoff.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>

Pull RTC updates from Alexandre Belloni:
 "There is nothing scary this cycle, mostly driver fixes and updates.

  The core fix has been in for a while and has been tested on multiple
  kernel revisions by multiple teams.

  Core:
   - Fix setting the alarm to the next expiring timer

  New drivers:
   - Mediatek MT7622 RTC
   - NXP PCF85363
   - Spreadtrum SC27xx PMIC RTC

  Drivers updates:
   - Use generic nvmem to expose the Non volatile ram for ds1305,
     ds1511, m48t86 and omap
   - abx80x: solve possible race condition at probe
   - armada38x: support trimming the RTC oscillator
   - at91rm9200: fix reading the alarm value at boot
   - ds1511: allow waking platform
   - m41t80: rework square wave output
   - pcf8523: support trimming the RTC oscillator
   - pcf8563: fix clock output rate
   - pl031: make interrupt optional
   - xgene: fix suspend/resume"

* tag 'rtc-4.15' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux: (50 commits)
  dt-bindings: rtc: imxdi: Improve the bindings text
  rtc: sc27xx: Add Spreadtrum SC27xx PMIC RTC driver
  dt-bindings: rtc: Add Spreadtrum SC27xx RTC documentation
  rtc: at91rm9200: fix reading alarm value
  rtc: at91rm9200: stop calculating yday in at91_rtc_readalarm
  rtc: sysfs: Use time64_t variables to set time/alarm
  rtc: xgene: mark PM functions as __maybe_unused
  rtc: xgene: Fix suspend/resume
  rtc: pcf8563: don't alway enable the alarm
  rtc: pcf8563: fix output clock rate
  rtc: rx8010: Fix for incorrect return value
  rtc: rx8010: Specify correct address for RX8010_RESV31
  rtc: rx8010: Remove duplicate define
  rtc: m41t80: remove unneeded checks from m41t80_sqw_set_rate
  rtc: m41t80: avoid i2c read in m41t80_sqw_is_prepared
  rtc: m41t80: avoid i2c read in m41t80_sqw_recalc_rate
  rtc: m41t80: fix m41t80_sqw_round_rate return value
  rtc: m41t80: m41t80_sqw_set_rate should return 0 on success
  rtc: add support for NXP PCF85363 real-time clock
  rtc: omap: Support scratch registers
  ...