Document RZ/G2N (R8A774B1) SoC bindings.

Signed-off-by: Biju Das <biju.das@bp.renesas.com>
Reviewed-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The `adi,disable-energy-detect` property was implemented in an initial
version of the `adin` driver series, but after a review it was discarded in
favor of implementing the ETHTOOL_PHY_EDPD phy-tunable option.

With the ETHTOOL_PHY_EDPD control, it's possible to disable/enable
Energy-Detect-Power-Down for the `adin` PHY, so this device-tree is not
needed.

Fixes: 767078132ff9 ("dt-bindings: net: add bindings for ADIN PHY driver")
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Jakub Kicinski <jakub.kicinski@netronome.com>

The 'mac-mode' property is similar to 'phy-mode' and 'phy-connection-type',
which are enums of mode strings.

The 'dwmac' driver supports almost all modes declared in the 'phy-mode'
enum (except for 1 or 2). But in general, there may be a case where
'mac-mode' becomes more generic and is moved as part of phylib or netdev.

In any case, the 'mac-mode' field should be made an enum, and it also makes
sense to just reference the 'phy-connection-type' from
'ethernet-controller.yaml'. That will also make it more future-proof for new
modes.

Fixes: 9c15d3597c62 ("dt-bindings: net: dwmac: document 'mac-mode' property")
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Jakub Kicinski <jakub.kicinski@netronome.com>

The documentation of skew values for the KSZ9021 PHY was misleading
because the driver implementation followed the erroneous information
given in the original KSZ9021 datasheet before it was corrected in
revision 1.2 (Feb 2014). It is probably too late to correct the driver
now because of the many existing device trees, so instead this just
corrects the documentation to explain that what you actually get is not
what you might think when looking at the device tree.

Signed-off-by: James Byrne <james.byrne@origamienergy.com>
Signed-off-by: Jakub Kicinski <jakub.kicinski@netronome.com>

Pull networking updates from David Miller:

 1) Support IPV6 RA Captive Portal Identifier, from Maciej Żenczykowski.

 2) Use bio_vec in the networking instead of custom skb_frag_t, from
    Matthew Wilcox.

 3) Make use of xmit_more in r8169 driver, from Heiner Kallweit.

 4) Add devmap_hash to xdp, from Toke Høiland-Jørgensen.

 5) Support all variants of 5750X bnxt_en chips, from Michael Chan.

 6) More RTNL avoidance work in the core and mlx5 driver, from Vlad
    Buslov.

 7) Add TCP syn cookies bpf helper, from Petar Penkov.

 8) Add 'nettest' to selftests and use it, from David Ahern.

 9) Add extack support to drop_monitor, add packet alert mode and
    support for HW drops, from Ido Schimmel.

10) Add VLAN offload to stmmac, from Jose Abreu.

11) Lots of devm_platform_ioremap_resource() conversions, from
    YueHaibing.

12) Add IONIC driver, from Shannon Nelson.

13) Several kTLS cleanups, from Jakub Kicinski.

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net-next: (1930 commits)
  mlxsw: spectrum_buffers: Add the ability to query the CPU port's shared buffer
  mlxsw: spectrum: Register CPU port with devlink
  mlxsw: spectrum_buffers: Prevent changing CPU port's configuration
  net: ena: fix incorrect update of intr_delay_resolution
  net: ena: fix retrieval of nonadaptive interrupt moderation intervals
  net: ena: fix update of interrupt moderation register
  net: ena: remove all old adaptive rx interrupt moderation code from ena_com
  net: ena: remove ena_restore_ethtool_params() and relevant fields
  net: ena: remove old adaptive interrupt moderation code from ena_netdev
  net: ena: remove code duplication in ena_com_update_nonadaptive_moderation_interval _*()
  net: ena: enable the interrupt_moderation in driver_supported_features
  net: ena: reimplement set/get_coalesce()
  net: ena: switch to dim algorithm for rx adaptive interrupt moderation
  net: ena: add intr_moder_rx_interval to struct ena_com_dev and use it
  net: phy: adin: implement Energy Detect Powerdown mode via phy-tunable
  ethtool: implement Energy Detect Powerdown support via phy-tunable
  xen-netfront: do not assume sk_buff_head list is empty in error handling
  s390/ctcm: Delete unnecessary checks before the macro call “dev_kfree_skb”
  net: ena: don't wake up tx queue when down
  drop_monitor: Better sanitize notified packets
  ...

Pull ARM DT updates from Arnd Bergmann:
 "This is another huge branch with close to 450 changessets related to
  devicetree files, roughly half of this for 32-bit and 64-bit
  respectively. There are lots of cleanups and additional hardware
  support for platforms we already support based on SoCs from Renesas,
  ST-Microelectronics, Intel/Altera, Rockchips, Allwinner, Broadcom and
  other manufacturers.

  A total of 6 new SoCs and 37 new boards gets added this time, one more
  SoC will come in a follow-up branch. Most of the new boards are for
  64-bit ARM SoCs, the others are typically for the 32-bit Cortex-A7.

  Going more into details for SoC platforms with new hardware support:

   - The Snapdragon 855 (SM8150) is Qualcomm's current high-end phone
     platform, usually paired with an external 5G modem. So far we only
     support the Qualcomm SM8150 MTP reference platform, but no actual
     products.

   - For the slightly older Qualcomm platforms, support for several
     interesting products is getting added: Three laptops based on
     Snapdragon 835/MSM8998 (Asus NovaGo, HP Envy X2 and Lenovo Miix
     630), one laptop based on Snapdragon 850/sdm850 (Lenovo Yoga C630)
     and several phones based on the older Snapdragon 410/MSM8916
     (Samsung A3 and A5, Longcheer L8150 aka Android One 2nd gen "seed"
     aka Wileyfox Swift).

   - Mediatek MT7629 is a new wireless network router chip, similar to
     the older MT7623. It gets added together with the reference board
     implementation.

   - Allwinner V3 is a repackaged version of the existing low-end V3s
     chip, and is used in the tiny Lichee Pi Zero plus, also added here.
     There is also a new TV set-top box based on Allwinner H6, the Tanix
     TX6, and the eMMC variant of the Olimex A64-Olinuxino development
     board.

   - NXP i.MX8M Nano is a new member of the ever-expanding i.MX SoC
     family, similar to the i.MX8M Mini. As usual, there is a large
     number of new boards for i.MX SoCs: Einfochips i.MX8QXP AI_ML,
     SolidRun Hummingboard Pulse baseboard and System-on-Module,
     Boundary Devices i.MX8MQ Nitrogen8M, and TechNexion
     PICO-PI-IMX8M-DEV for the 64-bit i.MX8 line. For 32-bit, we get the
     Kontron i.MX6UL N6310 SoM with two baseboards, the PHYTEC
     phyBOARD-Segin SoM with three baseboards, and the Zodiac Inflight
     Innovations i.MX7 RMU2 board.

   - In a different NXP product line, the Layerscape LS1046A "Freeway"
     reference board gets added.

   - Amlogic SM1 (S905X3) and G12B (S922X, A311D) are updated chips from
     their set-top-box line and smart speaker with newer CPU and GPU
     cores compared to their predecessors. Both are now also supported
     by the Khadas VIM3 development board series, and the dts files for
     that get reorganized a bit to better deal with all variants.
     Another board based on SM1 that gets added is the SEI Robotics
     SEI610.

   - There are a handful of new x86 and Power9 server boards using
     Aspeed BMC chips that are gaining support for running Linux on the
     BMC through the OpenBMC project: Facebook
     Minipack/Wedge100/Wedge40, Lenovo Hr855xg2, and Mihawk. Notably
     these are still new machines using SoCs based on the ARM9 and ARM11
     CPU cores, as support for the new Cortex-A7 based AST2600 is still
     ramping up.

   - There are three new end-user products using 32-bit Rockchips SoCs:
     Mecer Xtreme Mini S6 is an Android "mini PC" box based on the
     low-end RK3229 chip, while the two AOpen products Chromebox Mini
     (Fievel) and Chromebase Mini (Tiger) run ChromeOS and are meant for
     commercial settings(digital signage, PoS, ...).

   - One more single-board computer based on the popular 64-bit RK3399
     is added: the Leez RK3399 P710"

* tag 'armsoc-dt' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (467 commits)
  arm64: dts: qcom: Add Lenovo Yoga C630
  ARM: dts: aspeed-g5: Fixe gpio-ranges upper limit
  ARM; dts: aspeed: mihawk: File should not be executable
  ARM: dts: aspeed: swift: Change power supplies to version 2
  ARM: dts: aspeed: vesnin: Add secondary SPI flash chip
  ARM: dts: aspeed: vesnin: Add wdt2 with alt-boot option
  ARM: dts: aspeed-g4: Add all flash chips
  ARM: dts: exynos: Enable GPU/Mali T604 on Arndale board
  ARM: dts: exynos: Enable GPU/Mali T604 on Chromebook Snow
  ARM: dts: exynos: Add GPU/Mali T604 node to Exynos5250
  ARM: dts: exynos: Fix min/max buck4 for GPU on Arndale board
  ARM: dts: exynos: Mark LDO10 as always-on on Peach Pit/Pi Chromebooks
  ARM: dts: exynos: Remove not accurate secondary ADC compatible
  arm64: dts: rockchip: limit clock rate of MMC controllers for RK3328
  arm64: dts: meson-sm1-sei610: add stdout-path property back
  arm64: dts: meson-sm1-sei610: enable DVFS
  arm64: dts: khadas-vim3: add support for the SM1 based VIM3L
  dt-bindings: arm: amlogic: add Amlogic SM1 based Khadas VIM3L bindings
  arm64: dts: khadas-vim3: move common nodes into meson-khadas-vim3.dtsi
  arm64: dts: meson: g12a: add reset to tdm formatters
  ...

Add documentation of ti,sgmii-ref-clock-output-enable
which can be used to select SGMII mode type (4 or 6-wire).

Signed-off-by: Vitaly Gaiduk <vitaly.gaiduk@cloudbear.ru>
Signed-off-by: David S. Miller <davem@davemloft.net>

This change documents the 'mac-mode' property that was introduced in the
'stmmac' driver to support passive mode converters that can sit in-between
the MAC & PHY.

Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This is present in the AP6526 WiFi/Bluetooth 5.0 module.

Signed-off-by: Ondrej Jirman <megous@megous.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

Marc Kleine-Budde says:

====================
pull-request: can-next 2019-09-03

this is a pull request for net-next/master consisting of 15 patches.

The first patch is by Christer Beskow, targets the kvaser_pciefd driver
and fixes the PWM generator's frequency.

The next three patches are by Dan Murphy, the tcan4x5x is updated to use
a proper interrupts/interrupt-parent DT binding to specify the devices
IRQ line. Further the unneeded wake ups of the device is removed from
the driver.

A patch by me for the mcp25xx driver removes the deprecated board file
setup example. Three patches by Andy Shevchenko simplify clock handling,
update the driver from OF to device property API and simplify the
mcp251x_can_suspend() function.

The remaining 7 patches are by me and clean up checkpatch warnings in
the generic CAN device infrastructure.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>