Add boolean context flag to disable SCM call for statically
mapped msa region.

Signed-off-by: Govind Singh <govinds@codeaurora.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

The WiFi firmware found on sm8150 requires that the QDSS clock is
ticking in order to operate, so add an optional clock to the binding to
allow this to be specified in the sm8150 dts and add the clock to the
list of clocks in the driver.

Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

ath.git patches for v5.6. Major changes:

ath11k

* a new driver for Qualcomm Wi-Fi 6 (IEEE 802.11ax) devices

ath10k

* significant improvements on receive throughput and firmware download
  with SDIO bus

* report signal strength for each chain also on SDIO

* set max mtu to 1500 on SDIO devices

Pull MMC updates from Ulf Hansson:
 "These are the updates for MMC and MEMSTICK for v5.5.

  Note that this also contains quite some additional changes reaching
  beyond both the MMC and MEMSTICK subsystems. This is primarily because
  of fixing an old regression for a WiFi driver based on the SDIO
  interface on an OMAP openpandora board

  MMC core:
   - Add CMD13 polling for MMC IOCTLS with R1B response.
   - Add common DT properties for clk-phase-delays for various speed
     modes.
   - Fix size overflow for mmc gp-partitions.
   - Re-work HW reset for SDIO cards, which also includes a re-work for
     Marvell's WiFi mwifiex SDIO func driver.

  MMC host:
   - jz4740: Add support for X1000 and JZ4760.
   - jz4740: Add support for 8-bit bus and for low power mode.
   - mmci: Add support for HW busy timeout for the stm32_sdmmc variant.
   - owl-mmc: Add driver for Actions Semi Owl SoCs SD/MMC controller.
   - renesas_sdhi: Add support for r8a774b1.
   - sdhci_am654: Add support for Command Queuing Engine for J721E.
   - sdhci-milbeaut: Add driver for the Milbeaut SD controller.
   - sdhci-of-arasan: Add support for ZynqMP tap-delays.
   - sdhci-of-arasan: Add support for clk-phase-delays for SD cards.
   - sdhci-of-arasan: Add support for Intel LGM SDXC.
   - sdhci-of-aspeed: Allow inversion of the internal card detect
     signal.
   - sdhci-of-esdhc: Fixup workaround for erratum A-008171 for tunings.
   - sdhci-of-at91: Improve support for calibration.
   - sdhci-pci: Add support for Intel JSL.
   - sdhci-pci: Add quirk for AMD SDHC Device 0x7906.
   - tmio: Enable support for erase/discard/trim requests.

  MMC/OMAP/pandora/wl1251:

  The TI wl1251 WiFi driver for SDIO on the OMAP openpandora board has
  been broken since v4.7. To fix the problems, changes have been made
  cross subsystems, but also to OMAP2 machine code and to openpandora
  DTS files, as summarized below. Relevant changes have been tagged for
  stable.

   - mmc/wl1251: Re-introduce lost SDIO quirks and vendor-id for wl1251
   - omap/omap_hsmmc: Remove redundant platform config for openpandora
   - omap_hsmmc: Initialize non-std SDIO card for wl1251 for pandora
   - omap/dts/pandora: Specify wl1251 through a child node of mmc3
   - wl1251: Add devicetree support for TI wl1251 SDIO"

* tag 'mmc-v5.5' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (73 commits)
  dt-bindings: mmc: Correct the type of the clk phase properties
  Revert "mmc: tmio: remove workaround for NON_REMOVABLE"
  memstick: Fix Kconfig indentation
  mmc: sdhci-of-arasan: Add support for ZynqMP Platform Tap Delays Setup
  dt-bindings: mmc: arasan: Document 'xlnx,zynqmp-8.9a' controller
  firmware: xilinx: Add SDIO Tap Delay nodes
  mmc: sdhci-of-arasan: Add support to set clock phase delays for SD
  dt-bindings: mmc: Add optional generic properties for mmc
  mmc: sdhci-of-arasan: Add sampling clock for a phy to use
  dt-bindings: mmc: arasan: Update Documentation for the input clock
  mmc: sdhci-of-arasan: Separate out clk related data to another structure
  mmc: sdhci: Fix grammar in warning message
  mmc: sdhci-of-aspeed: add inversion signal presence
  mmc: sdhci-of-aspeed: enable CONFIG_MMC_SDHCI_IO_ACCESSORS
  mmc: sdhci_am654: Add Support for Command Queuing Engine to J721E
  mmc: core: Fix size overflow for mmc partitions
  mmc: tmio: Add MMC_CAP_ERASE to allow erase/discard/trim requests
  net: wireless: ti: remove local VENDOR_ID and DEVICE_ID definitions
  net: wireless: ti: wl1251 use new SDIO_VENDOR_ID_TI_WL1251 definition
  mmc: core: fix wl1251 sdio quirks
  ...

ath11k is a driver for Qualcomm IEEE 802.11ax devices. Add a
bindings document for the driver, first documenting IPQ8074 which is the
only device ath11k currently supports.

Signed-off-by: Anilkumar Kolli <akolli@codeaurora.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

The standard method for sdio devices connected to
an sdio interface is to define them as a child node
like we can see with wlcore.

Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
Acked-by: Kalle Valo <kvalo@codeaurora.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Cc: <stable@vger.kernel.org> # v4.7+
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

Add dt binding to get xo calibration data support for wifi rf clock.

Signed-off-by: Govind Singh <govinds@codeaurora.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

The introduction of 768ec4c012ac ("ath10k: update HOST capability QMI
message") served the purpose of supporting the new and extended HOST
capability QMI message.

But while the new message adds a slew of optional members it changes the
data type of the "daemon_support" member, which means that older
versions of the firmware will fail to decode the incoming request
message.

There is no way to detect this breakage from Linux and there's no way to
recover from sending the wrong message (i.e. we can't just try one
format and then fallback to the other), so a quirk is introduced in
DeviceTree to indicate to the driver that the firmware requires the 8bit
version of this message.

Cc: stable@vger.kernel.org
Fixes: 768ec4c012ac ("ath10k: update HOST capability qmi message")
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

In commit 687e3d5550c7 ("dt-bindings: doc: reflect new NVMEM
of_get_mac_address behaviour") I've kept or added references to Linux
of_get_mac_address API which is unwanted so this patch fixes that by
removing those references.

Fixes: 687e3d5550c7 ("dt-bindings: doc: reflect new NVMEM of_get_mac_address behaviour")
Suggested-by: Rob Herring <robh@kernel.org>
Signed-off-by: Petr Štetiar <ynezz@true.cz>
Signed-off-by: David S. Miller <davem@davemloft.net>

As of_get_mac_address now supports NVMEM under the hood, we need to update
the bindings documentation with the new nvmem-cell* properties, which would
mean copy&pasting a lot of redundant information to every binding
documentation currently referencing some of the MAC address properties.

So I've just removed all the references to the optional MAC address
properties and replaced them with the small note referencing
net/ethernet.txt file.

Signed-off-by: Petr Štetiar <ynezz@true.cz>
Signed-off-by: David S. Miller <davem@davemloft.net>