The following warnings are seen with 'make dt_binding_check':

Documentation/devicetree/bindings/input/touchscreen/edt-ft5x06.example.dts:19.22-30.11: Warning (unit_address_vs_reg): /example-0/i2c@00000000: node has a unit name, but no reg or ranges property
Documentation/devicetree/bindings/input/touchscreen/edt-ft5x06.example.dts:19.22-30.11: Warning (unit_address_format): /example-0/i2c@00000000: unit name should not have leading 0s

Fix it by removing the unneeded i2c unit name.

Signed-off-by: Fabio Estevam <festevam@gmail.com>
Signed-off-by: Rob Herring <robh@kernel.org>

Pull input updates from Dmitry Torokhov:
 "An update to the Goodix touchscreen driver to enable it work properly
  on various Bay Trail and Cherry Trail devices, and a few other
  assorted changes"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (26 commits)
  Input: update SPDX tag for input-event-codes.h
  Input: i8042 - add Acer Aspire 5738z to nomux list
  Input: goodix - fix compilation when ACPI support is disabled
  dt-bindings: touchscreen: Convert edt-ft5x06 to json-schema
  Input: of_touchscreen - explicitly choose axis
  Input: goodix - support gt9147 touchpanel
  dt-bindings: touchscreen: goodix: support of gt9147
  Input: goodix - add support for Goodix GT917S
  Input: goodix - use string-based chip ID
  dt-bindings: input: touchscreen: add compatible string for Goodix GT917S
  Input: goodix - add support for more then one touch-key
  Input: goodix - fix spurious key release events
  Input: goodix - try to reset the controller if the i2c-test fails
  Input: goodix - restore config on resume if necessary
  Input: goodix - make goodix_send_cfg() take a raw buffer as argument
  Input: goodix - add minimum firmware size check
  Input: goodix - save a copy of the config from goodix_read_config()
  Input: goodix - move defines to above struct goodix_ts_data declaration
  Input: goodix - add support for controlling the IRQ pin through ACPI methods
  Input: goodix - add support for getting IRQ + reset GPIOs on Bay Trail devices
  ...

Pull mfd updates from Lee Jones:
 "New Drivers:
   - Add support for IQS620A/621/622/624/625 Azoteq IQS62X Sensors

  New Device Support:
   - Add support for ADC, IRQ, Regulator, RTC and WDT to Ricoh RN5T618 PMIC
   - Add support for Comet Lake to Intel LPSS

  New Functionality:
   - Add support for Charger Detection to Spreadtrum SC27xx PMICs
   - Add support for Interrupt Polarity to Dialog Semi DA9062/61 PMIC
   - Add ACPI enumeration support to Diolan DLN2 USB Adaptor

  Fix-ups:
   - Device Tree; iqs62x, rn5t618, cros_ec_dev, stm32-lptimer, rohm,bd71837, rohm,bd71847
   - I2C registration; rn5t618
   - Kconfig; MFD_CPCAP, AB8500_CORE, MFD_WM8994, MFD_WM97xx, MFD_STPMIC1
   - Use flexible-array members; omap-usb-tll, qcom-pm8xxx
   - Remove unnecessary casts; omap-usb-host, omap-usb-tll
   - Power (suspend/resume/poweroff) enhancements; rk808
   - Improve error/sanity checking; dln2
   - Use snprintf(); aat2870-core

  Bug Fixes:
   - Fix PCI IDs in intel-lpss-pci"

* tag 'mfd-next-5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (33 commits)
  mfd: intel-lpss: Fix Intel Elkhart Lake LPSS I2C input clock
  mfd: aat2870: Use scnprintf() for avoiding potential buffer overflow
  mfd: dln2: Allow to be enumerated via ACPI
  mfd: da9062: Add support for interrupt polarity defined in device tree
  dt-bindings: bd718x7: Yamlify and add BD71850
  mfd: dln2: Fix sanity checking for endpoints
  mfd: intel-lpss: Add Intel Comet Lake PCH-V PCI IDs
  mfd: sc27xx: Add USB charger type detection support
  dt-bindings: mfd: Document STM32 low power timer bindings
  mfd: rk808: Convert RK805 to shutdown/suspend hooks
  mfd: rk808: Reduce shutdown duplication
  mfd: rk808: Stop using syscore ops
  mfd: rk808: Ensure suspend/resume hooks always work
  mfd: rk808: Always use poweroff when requested
  mfd: omap: Remove useless cast for driver.name
  mfd: Kconfig: Fix some misspelling of the word functionality
  mfd: pm8xxx: Replace zero-length array with flexible-array member
  mfd: omap-usb-tll: Replace zero-length array with flexible-array member
  mfd: cpcap: Fix compile if MFD_CORE is not selected
  mfd: cros_ec: Check DT node for usbpd-notify add
  ...

Prepare input updates for 5.7 merge window.

Pull devicetree updates from Rob Herring:

 - Unit test for overlays with GPIO hogs

 - Improve dma-ranges parsing to handle dma-ranges with multiple entries

 - Update dtc to upstream version v1.6.0-2-g87a656ae5ff9

 - Improve overlay error reporting

 - Device link support for power-domains and hwlocks bindings

 - Add vendor prefixes for Beacon, Topwise, ENE, Dell, SG Micro, Elida,
   PocketBook, Xiaomi, Linutronix, OzzMaker, Waveshare Electronics, and
   ITE Tech

 - Add deprecated Marvell vendor prefix 'mrvl'

 - A bunch of binding conversions to DT schema continues. Of note, the
   common serial and USB connector bindings are converted.

 - Add more Arm CPU compatibles

 - Drop Mark Rutland as DT maintainer :(

* tag 'devicetree-for-5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux: (106 commits)
  MAINTAINERS: drop an old reference to stm32 pwm timers doc
  MAINTAINERS: dt: update etnaviv file reference
  dt-bindings: usb: dwc2: fix bindings for amlogic, meson-gxbb-usb
  dt-bindings: uniphier-system-bus: fix warning in the example
  dt-bindings: display: meson-vpu: fix indentation of reg-names' "items"
  dt-bindings: iio: Fix adi, ltc2983 uint64-matrix schema constraints
  dt-bindings: power: Fix example for power-domain
  dt-bindings: arm: Add some constraints for PSCI nodes
  of: some unittest overlays not untracked
  of: gpio unittest kfree() wrong object
  dt-bindings: phy: convert phy-rockchip-inno-usb2 bindings to yaml
  dt-bindings: serial: sh-sci: Convert to json-schema
  dt-bindings: serial: Document serialN aliases
  dt-bindings: thermal: tsens: Set 'additionalProperties: false'
  dt-bindings: thermal: tsens: Fix nvmem-cell-names schema
  dt-bindings: vendor-prefixes: Add Beacon vendor prefix
  dt-bindings: vendor-prefixes: Add Topwise
  of: of_private.h: Replace zero-length array with flexible-array member
  docs: dt: fix a broken reference to input.yaml
  docs: dt: fix references to ap806-system-controller.txt
  ...

Setting 'additionalProperties: false' is frequently omitted, but is
important in order to check that there aren't extra undocumented
properties in a binding.

Ideally, we'd just add this automatically and make this the default, but
there's some cases where it doesn't work. For example, if a common
schema is referenced, then properties in the common schema aren't part
of what's considered for 'additionalProperties'. Also, sometimes there
are bus specific properties such as 'spi-max-frequency' that go into
bus child nodes, but aren't defined in the child node's schema.

So let's stick with the json-schema defined default and add
'additionalProperties: false' where needed. This will be a continual
review comment and game of wack-a-mole.

Signed-off-by: Rob Herring <robh@kernel.org>
Reviewed-by: Neil Armstrong <narmstrong@baylibre.com>
Acked-by: Mark Brown <broonie@kernel.org>
Acked-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Acked-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Reviewed-by: Benjamin Gaignard <benjamin.gaignard@st.com>
Acked-by: Stephen Boyd <sboyd@kernel.org> # clock
Acked-by: Lee Jones <lee.jones@linaro.org>

This patch adds device tree bindings for the Azoteq IQS620A, IQS621,
IQS622, IQS624 and IQS625 multi-function sensors.

A total of three bindings are presented (one MFD and two child nodes);
they are submitted as a single patch because the child node bindings
have no meaning in the absence of the MFD binding.

Signed-off-by: Jeff LaBundy <jeff@labundy.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

Pull input fixes from Dmitry Torokhov:

 - a fix to generate proper timestamps on key autorepeat events that
   were broken recently

 - a fix for Synaptics driver to only activate reduced reporting mode
   when explicitly requested

 - a new keycode for "selective screenshot" function

 - other assorted fixes

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: fix stale timestamp on key autorepeat events
  Input: move the new KEY_SELECTIVE_SCREENSHOT keycode
  Input: avoid BIT() macro usage in the serio.h UAPI header
  Input: synaptics-rmi4 - set reduced reporting mode only when requested
  Input: synaptics - enable RMI on HP Envy 13-ad105ng
  Input: allocate keycode for "Selective Screenshot" key
  Input: tm2-touchkey - add support for Coreriver TC360 variant
  dt-bindings: input: add Coreriver TC360 binding
  dt-bindings: vendor-prefixes: Add Coreriver vendor prefix
  Input: raydium_i2c_ts - fix error codes in raydium_i2c_boot_trigger()

Convert stpmic1 bindings to json-schema.

Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com>
Signed-off-by: Rob Herring <robh@kernel.org>

Convert the EDT-FT5x06 to DT schema using json-schema.

Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20200207084657.31195-1-benjamin.gaignard@st.com
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>