Pretty much any node can have a status property, so it doesn't need to
be in examples.

Converted with the following command and removed examples with SoC and
board specific splits:

git grep -l -E 'status.*=.*' Documentation/devicetree/ | xargs sed -i -E '/\sstatus.*=.*"(disabled|ok|okay)/d'

Acked-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Rob Herring <robh@kernel.org>

The stmfts (ST-Microelectronics FingerTip S) touchscreen device is a
capacitive multi-touch controller mainly for mobile use.  It's connected
through i2c bus at the address 0x49 and it interfaces with userspace
through input event interface.

At the current state it provides a touchscreen multitouch functionality up
to 10 fingers. Each finger is enumerated with a distinctive id (from 0 to
9).

If enabled the device can support single "touch" hovering, by providing
three coordinates, x, y and distance.

It is possible to select the touchkey functionality which provides a basic
two keys interface for "home" and "back" menu, typical in mobile phones.

Signed-off-by: Andi Shyti <andi.shyti@samsung.com>
Reviewed-by: Javier Martinez Canillas <javier@osg.samsung.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Pull input layer fixes from Dmitry Torokhov:
 "Just a few fixups to a couple of drivers"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: elan_i2c - ignore signals when finishing updating firmware
  Input: elan_i2c - clear INT before resetting controller
  Input: atmel_mxt_ts - add T100 as a readable object
  Input: edt-ft5x06 - increase allowed data range for threshold parameter

The datasheet and application note does not mention an allowed range for
the M09_REGISTER_THRESHOLD parameter. One of our customers needs to set
lower values than 20 and they seem to work just fine on EDT EP0xx0M09 with
T5x06 touch.

So, lacking a known lower limit, we increase the range for thresholds,
and set the lower limit to 0. The documentation is updated accordingly.

Signed-off-by: Schoefegger Stefan <stefan.schoefegger@ginzinger.com>
Signed-off-by: Manfred Schlaegl <manfred.schlaegl@ginzinger.com>
Signed-off-by: Martin Kepplinger <martin.kepplinger@ginzinger.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Pull input subsystem updates from Dmitry Torokhov:

 - a big update from Mauro converting input documentation to ReST format

 - Synaptics PS/2 is now aware of SMBus companion devices, which means
   that we can now use native RMI4 protocol to handle touchpads, instead
   of relying on legacy PS/2 mode.

 - we removed support from BMA180 accelerometer from input devices as it
   is now handled properly by IIO

 - update to TSC2007 to corretcly report pressure

 - other miscellaneous driver fixes.

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (152 commits)
  Input: ar1021_i2c - use BIT to check for a bit
  Input: twl4030-pwrbutton - use input_set_capability() helper
  Input: twl4030-pwrbutton - use correct device for irq request
  Input: ar1021_i2c - enable touch mode during open
  Input: add uinput documentation
  dt-bindings: input: add bindings document for ar1021_i2c driver
  dt-bindings: input: rotary-encoder: fix typo
  Input: xen-kbdfront - add module parameter for setting resolution
  ARM: pxa/raumfeld: fix compile error in rotary controller resources
  Input: xpad - do not suggest writing to Dominic
  Input: xpad - don't use literal blocks inside footnotes
  Input: xpad - note that usb/devices is now at /sys/kernel/debug/
  Input: docs - freshen up introduction
  Input: docs - split input docs into kernel- and user-facing
  Input: docs - note that MT-A protocol is obsolete
  Input: docs - update joystick documentation a bit
  Input: docs - remove disclaimer/GPL notice
  Input: fix "Game console" heading level in joystick documentation
  Input: rotary-encoder - remove references to platform data from docs
  Input: move documentation for Amiga CD32
  ...

This patch removes the sun4i touchscreen controller binding
documentation since it has been merged with the sun4i GPADC binding
documentation.

Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

Add a simple binding document describing the supported devices and the
I2C bus address.

Signed-off-by: Martin Kepplinger <martin.kepplinger@ginzinger.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

The driver contains compatible strings for different models, but the DT
binding doc only lists one of them. Add the remaining to the document.

Signed-off-by: Javier Martinez Canillas <javier@osg.samsung.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Add missing documentation of max11801-ts dt-binding details.

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

This moves device tree bindings for ADS7846 together with the other
touchscreen bindings.

Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>