Pull MIPS updates from Ralf Baechle:

 - Improvements to the tlb_dump code
 - KVM fixes
 - Add support for appended DTB
 - Minor improvements to the R12000 support
 - Minor improvements to the R12000 support
 - Various platform improvments for BCM47xx
 - The usual pile of minor cleanups
 - A number of BPF fixes and improvments
 - Some improvments to the support for R3000 and DECstations
 - Some improvments to the ATH79 platform support
 - A major patchset for the JZ4740 SOC adding support for the CI20 platform
 - Add support for the Pistachio SOC
 - Minor BMIPS/BCM63xx platform support improvments.
 - Avoid "SYNC 0" as memory barrier when unlocking spinlocks
 - Add support for the XWR-1750 board.
 - Paul's __cpuinit/__cpuinitdata cleanups.
 - New Malta CPU board support large memory so enable ZONE_DMA32.

* 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (131 commits)
  MIPS: spinlock: Adjust arch_spin_lock back-off time
  MIPS: asmmacro: Ensure 64-bit FP registers are used with MSA
  MIPS: BCM47xx: Simplify handling SPROM revisions
  MIPS: Cobalt Don't use module_init in non-modular MTD registration.
  MIPS: BCM47xx: Move NVRAM driver to the drivers/firmware/
  MIPS: use for_each_sg()
  MIPS: BCM47xx: Don't select BCMA_HOST_PCI
  MIPS: BCM47xx: Add helper variable for storing NVRAM length
  MIPS: IRQ/IP27: Move IRQ allocation API to platform code.
  MIPS: Replace smp_mb with release barrier function in unlocks.
  MIPS: i8259: DT support
  MIPS: Malta: Basic DT plumbing
  MIPS: include errno.h for ENODEV in mips-cm.h
  MIPS: Define GCR_GIC_STATUS register fields
  MIPS: BPF: Introduce BPF ASM helpers
  MIPS: BPF: Use BPF register names to describe the ABI
  MIPS: BPF: Move register definition to the BPF header
  MIPS: net: BPF: Replace RSIZE with SZREG
  MIPS: BPF: Free up some callee-saved registers
  MIPS: Xtalk: Update xwidget.h with known Xtalk device numbers
  ...

Pull pin control updates from Linus Walleij:
 "Here is the bulk of pin control changes for the v4.2 series: Quite a
  lot of new SoC subdrivers and two new main drivers this time, apart
  from that business as usual.

  Details:

  Core functionality:
   - Enable exclusive pin ownership: it is possible to flag a pin
     controller so that GPIO and other functions cannot use a single pin
     simultaneously.

  New drivers:
   - NXP LPC18xx System Control Unit pin controller
   - Imagination Pistachio SoC pin controller

  New subdrivers:
   - Freescale i.MX7d SoC
   - Intel Sunrisepoint-H PCH
   - Renesas PFC R8A7793
   - Renesas PFC R8A7794
   - Mediatek MT6397, MT8127
   - SiRF Atlas 7
   - Allwinner A33
   - Qualcomm MSM8660
   - Marvell Armada 395
   - Rockchip RK3368

  Cleanups:
   - A big cleanup of the Marvell MVEBU driver rectifying it to
     correspond to reality
   - Drop platform device probing from the SH PFC driver, we are now a
     DT only shop for SuperH
   - Drop obsolte multi-platform check for SH PFC
   - Various janitorial: constification, grammar etc

  Improvements:
   - The AT91 GPIO portions now supports the set_multiple() feature
   - Split out SPI pins on the Xilinx Zynq
   - Support DTs without specific function nodes in the i.MX driver"

* tag 'pinctrl-v4.2-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (99 commits)
  pinctrl: rockchip: add support for the rk3368
  pinctrl: rockchip: generalize perpin driver-strength setting
  pinctrl: sh-pfc: r8a7794: add SDHI pin groups
  pinctrl: sh-pfc: r8a7794: add MMCIF pin groups
  pinctrl: sh-pfc: add R8A7794 PFC support
  pinctrl: make pinctrl_register() return proper error code
  pinctrl: mvebu: armada-39x: add support for Armada 395 variant
  pinctrl: mvebu: armada-39x: add missing SATA functions
  pinctrl: mvebu: armada-39x: add missing PCIe functions
  pinctrl: mvebu: armada-38x: add ptp functions
  pinctrl: mvebu: armada-38x: add ua1 functions
  pinctrl: mvebu: armada-38x: add nand functions
  pinctrl: mvebu: armada-38x: add sata functions
  pinctrl: mvebu: armada-xp: add dram functions
  pinctrl: mvebu: armada-xp: add nand rb function
  pinctrl: mvebu: armada-xp: add spi1 function
  pinctrl: mvebu: armada-39x: normalize ref clock naming
  pinctrl: mvebu: armada-xp: rename spi to spi0
  pinctrl: mvebu: armada-370: align spi1 clock pin naming
  pinctrl: mvebu: armada-370: align VDD cpu-pd pin naming with datasheet
  ...

These bindings support the GPIO controllers found on the Qualcomm
Atheros AR7xxx/AR9XXX SoC.

Signed-off-by: Alban Bedel <albeu@free.fr>
Cc: linux-mips@linux-mips.org
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Added support to Zynq Ultrascale+ MPSoC on the existing zynq
gpio driver.

Signed-off-by: Anurag Kumar Vulisha <anuragku@xilinx.com>
Acked-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add a GPIO driver for the General I/O block on Axis ETRAX FS SoCs.

Signed-off-by: Rabin Vincent <rabin@rab.in>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

The Pinctrl module (ioc) controls the Pad's function select
(each pad can have 8 functions), Pad's Drive Strength, Pad's
Pull Select and Pad's Input Disable status.

The ioc has two modules, ioc_top & ioc_rtc. Both of these two
modules have function select/clear, Pull select and Drive
Strength registers. But only ioc_rtc has input-disable
registers. The Pads on ioc_top have to access ioc_rtc to set
their input-disable status and intpu-disable-value.

So have to use one ioc driver instance to drive these two
ioc modules at the same time, and each ioc module will be
treat as one bank on the "IOC Device".

The GPIO Controller controls the GPIO status if the Pad has
been config as GPIO by Pinctrl already. Includes the GPIO
Input/output, Interrupt type, Interrupt Status, and Set/Get
Values.
The GPIO pull up/down are controlled by Pinctrl.

There are 7 GPIO Groups and splited into 3 MACROs in atlas7.
The GPIO Groups in one MACRO share one GPIO controllers, each
GPIO Group are treated as one GPIO bank.

For example:
In VDIFM macro, there is one GPIO Controller, it has 3 banks
to control 3 gpio groups. Its gpio name space is from 0 to 95.

The Device Tree can be written as following:

gpio-ranges = <&pinctrl 0 0 0>,
<&pinctrl 32 0 0>,
<&pinctrl 64 0 0>;

gpio-ranges-group-names = "gnss_gpio_grp",
"lcd_vip_gpio_grp",
"sdio_i2s_gpio_grp";

bank#0 is from 0~31, the pins are from pinctrl's "gnss_gpio_grp".
bank#2 is from 32~63, the pins are from pinctrl's "lcd_vip_gpio_grp".
bank#3 is from 64~95, the pins are from pinctrl's "sdio_i2s_gpio_grp".

Signed-off-by: Wei Chen <Wei.Chen@csr.com>
Signed-off-by: Barry Song <Baohua.Song@csr.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add binding for Broadcom STB "UPG GIO" GPIO controller.

Signed-off-by: Gregory Fong <gregory.0xf0@gmail.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Provide documentation for Netlogic XLP SoCs GPIO controller DTS bindings.

Signed-off-by: Kamlakant Patel <kamlakant.patel@broadcom.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Signed-off-by: Joachim Eastwood <manabian@gmail.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Pull devicetree changes from Grant Likely:
 "Here are the devicetree changes queued up for v4.1.  Nothing really
  exciting here.  Rob has another few commits for big-endian attached
  UARTs, but those will be sent in a separate merge request since they
  haven't been as thoroughly tested as this batch.

  Here are the highlights:

   - lots of unittest cleanup from Frank Rowand

   - bugfixes and updates to the of_graph code

   - tighten up of_get_mac_address() code

   - documentation updates"

* tag 'devicetree-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/glikely/linux:
  of/unittest: Fix of_platform_depopulate test case
  of/unittest: early return from test skips tests
  of/unittest: breadcrumbs to reduce pain of future maintainers
  of/unittest: reduce checkpatch noise - line after declarations
  of/unittest: typo in error string
  of/unittest: add const where needed
  of_net: factor out repetitive code from of_get_mac_address()
  drivers/of: Add empty ranges quirk for PA-Semi
  of: Allow selection of OF_DYNAMIC and OF_OVERLAY if OF_UNITTEST
  of: Empty node & property flag accessors when !OF
  of: Explicitly include linux/types.h in of_graph.h
  dt-bindings: brcm: rationalize Broadcom documentation naming
  of/unittest: replace 'selftest' with 'unittest'
  Documentation: rename of_selftest.txt to of_unittest.txt
  Documentation: update the of_selftest.txt
  dt: OF_UNITTEST make dependency broken
  MAINTAINERS: Pantelis Antoniou device tree overlay maintainer
  of: Add of_graph_get_port_by_id function
  of: Add for_each_endpoint_of_node helper macro
  of: Decrement refcount of previous endpoint in of_graph_get_next_endpoint