Pull ARM SoC platform updates (part 3) from Arnd Bergmann:
"This is the third and smallest of the SoC specific updates. Changes
include:
- SMP support for the Xilinx zynq platform
- Smaller imx changes
- LPAE support for mvebu
- Moving the orion5x, kirkwood, dove and mvebu platforms to a common
"mbus" driver for their internal devices.
It would be good to get feedback on the location of the "mbus" driver.
Since this is used on multiple platforms may potentially get shared
with other architectures (powerpc and arm64), it was moved to
drivers/bus/. We expect other similar drivers to get moved to the
same place in order to avoid creating more top-level directories under
drivers/ or cluttering up the messy drivers/misc/ even more."
* tag 'soc-for-linus-3' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (50 commits)
ARM: imx: reset_controller may be disabled
ARM: mvebu: Align the internal registers virtual base to support LPAE
ARM: mvebu: Limit the DMA zone when LPAE is selected
arm: plat-orion: remove addr-map code
arm: mach-mv78xx0: convert to use the mvebu-mbus driver
arm: mach-orion5x: convert to use mvebu-mbus driver
arm: mach-dove: convert to use mvebu-mbus driver
arm: mach-kirkwood: convert to use mvebu-mbus driver
arm: mach-mvebu: convert to use mvebu-mbus driver
ARM i.MX53: set CLK_SET_RATE_PARENT flag on the tve_ext_sel clock
ARM i.MX53: tve_di clock is not part of the CCM, but of TVE
ARM i.MX53: make tve_ext_sel propagate rate change to PLL
ARM i.MX53: Remove unused tve_gate clkdev entry
ARM i.MX5: Remove tve_sel clock from i.MX53 clock tree
ARM: i.MX5: Add PATA and SRTC clocks
ARM: imx: do not bring up unavailable cores
ARM: imx: add initial imx6dl support
ARM: imx1: mm: add call to mxc_device_init
ARM: imx_v4_v5_defconfig: Add CONFIG_GPIO_SYSFS
ARM: imx_v6_v7_defconfig: Select CONFIG_PERF_EVENTS
...
Pull ARM SoC driver changes from Olof Johansson:
"This is a rather large set of patches for device drivers that for one
reason or another the subsystem maintainer preferred to get merged
through the arm-soc tree. There are both new drivers as well as
existing drivers that are getting converted from platform-specific
code into standalone drivers using the appropriate subsystem specific
interfaces.
In particular, we can now have pinctrl, clk, clksource and irqchip
drivers in one file per driver, without the need to call into platform
specific interface, or to get called from platform specific code, as
long as all information about the hardware is provided through a
device tree.
Most of the drivers we touch this time are for clocksource. Since now
most of them are part of drivers/clocksource, I expect that we won't
have to touch these again from arm-soc and can let the clocksource
maintainers take care of these in the future.
Another larger part of this series is specific to the exynos platform,
which is seeing some significant effort in upstreaming and
modernization of its device drivers this time around, which
unfortunately is also the cause for the churn and a lot of the merge
conflicts.
There is one new subsystem that gets merged as part of this series:
the reset controller interface, which is a very simple interface for
taking devices on the SoC out of reset or back into reset. Patches to
use this interface on i.MX follow later in this merge window, and we
are going to have other platforms (at least tegra and sirf) get
converted in 3.11. This will let us get rid of platform specific
callbacks in a number of platform independent device drivers."
* tag 'drivers-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (256 commits)
irqchip: s3c24xx: add missing __init annotations
ARM: dts: Disable the RTC by default on exynos5
clk: exynos5250: Fix parent clock for sclk_mmc{0,1,2,3}
ARM: exynos: restore mach/regs-clock.h for exynos5
clocksource: exynos_mct: fix build error on non-DT
pinctrl: vt8500: wmt: Fix checking return value of pinctrl_register()
irqchip: vt8500: Convert arch-vt8500 to new irqchip infrastructure
reset: NULL deref on allocation failure
reset: Add reset controller API
dt: describe base reset signal binding
ARM: EXYNOS: Add arm-pmu DT binding for exynos421x
ARM: EXYNOS: Add arm-pmu DT binding for exynos5250
ARM: EXYNOS: Enable PMUs for exynos4
irqchip: exynos-combiner: Correct combined IRQs for exynos4
irqchip: exynos-combiner: Add set_irq_affinity function for combiner_irq
ARM: EXYNOS: fix compilation error introduced due to common clock migration
clk: exynos5250: Fix divider values for sclk_mmc{0,1,2,3}
clk: exynos4: export clocks required for fimc-is
clk: samsung: Fix compilation error
clk: tegra: fix enum tegra114_clk to match binding
...
Pull ARM SoC platform updates from Olof Johansson: "This branch contains part 1 of the platform updates for 3.10. Among the highlights: - Support for the new Atmel Cortex-A5 based platforms (SAMA5D3) - New support for CSR SiRFatlas6 SoCs - A handful of updates for NVidia T114 (a.k.a. Tegra 4) - A bunch of updates for the shmobile platforms - A handful of updates for davinci - A few updates for Qualcomm MSM - Plus a handful of other patches, defconfig updates, etc." * tag 'soc-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (135 commits) ARM: tegra: pm: fix build error w/o PM_SLEEP ARM: davinci: ensure global variables are declared ARM: davinci: sram.c: fix incorrect type in assignment ARM: davinci: da8xx dt: make file local symbols static ARM: davinci: da8xx: add remoteproc support ARM: socfpga: Upgrade clk driver for socfpga to make use of dts clock entries ARM: socfpga: Add clock entries into device tree ARM: socfpga: Enable soft reset ARM: EXYNOS: replace cpumask by the corresponding macro ARM: EXYNOS: handle properly the return values ARM: EXYNOS: factor out the idle states ARM: OMAP4: Enable fix for Cortex-A9 erratas ARM: OMAP2+: Export SoC information to userspace ARM: OMAP2+: SoC name and revision unification ARM: OMAP2+: Move common part of late init into common function ARM: tegra: pm: remove duplicated include from pm.c ARM: davinci: da850: override mmc DT node device name ARM: davinci: da850: add mmc DT entries mmc: davinci_mmc: add DT support ARM: SAMSUNG: check processor type before cache restoration in resume ...
Pull ARM SoC device-tree updates from Olof Johansson: "Part 1 of device-tree updates for 3.10. The bulk of the churn in this branch is due to i.MX moving from C-defined pin control over to device tree, which is a one-time conversion that will allow greater flexibility down the road. Besides that, there's PCI-e bindings for Marvell mvebu platforms and a handful of cleanups to tegra due to the new include file functionality of the device tree compiler" * tag 'dt-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (113 commits) arm: mvebu: PCIe Device Tree informations for Armada XP GP arm: mvebu: PCIe Device Tree informations for Armada 370 DB arm: mvebu: PCIe Device Tree informations for Armada 370 Mirabox arm: mvebu: PCIe Device Tree informations for Armada XP DB arm: mvebu: PCIe Device Tree informations for OpenBlocks AX3-4 arm: mvebu: add PCIe Device Tree informations for Armada XP arm: mvebu: add PCIe Device Tree informations for Armada 370 ARM: sunxi: unify osc24M_fixed and osc24M arm: vt8500: Add SDHC support to WM8505 DT ARM: dts: Add a 64 bits version of the skeleton device tree ARM: mvebu: Add Device Bus and CFI flash memory support to defconfig ARM: mvebu: Add support for NOR flash device on Openblocks AX3 board ARM: mvebu: Add support for NOR flash device on Armada XP-GP board ARM: mvebu: Add Device Bus support for Armada 370/XP SoC ARM: dts: imx6dl-wandboard: Add USB Host support ARM: dts: imx51 cpu node ARM: dts: Add missing imx27-phytec-phycore dtb target ARM: dts: Add NFC support for i.MX27 Phytec PCM038 module ARM: i.MX51: Add PATA support ARM: dts: Add initial support for Wandboard Dual-Lite ...
Adds the main PLL clock groups for SOCFPGA into device tree file
so that the clock framework to query the clock and clock rates
appropriately.
$cat /sys/kernel/debug/clk/clk_summary
clock enable_cnt prepare_cnt rate
---------------------------------------------------------------------
osc1 2 2 25000000
sdram_pll 0 0 400000000
s2f_usr2_clk 0 0 66666666
ddr_dq_clk 0 0 200000000
ddr_2x_dqs_clk 0 0 400000000
ddr_dqs_clk 0 0 200000000
periph_pll 2 2 500000000
s2f_usr1_clk 0 0 50000000
per_base_clk 4 4 100000000
per_nand_mmc_clk 0 0 25000000
per_qsi_clk 0 0 250000000
emac1_clk 1 1 125000000
emac0_clk 0 0 125000000
main_pll 1 1 1600000000
cfg_s2f_usr0_clk 0 0 100000000
main_nand_sdmmc_clk 0 0 100000000
main_qspi_clk 0 0 400000000
dbg_base_clk 0 0 400000000
mainclk 0 0 400000000
mpuclk 1 1 800000000
smp_twd 1 1 200000000
Signed-off-by: Dinh Nguyen <dinguyen@altera.com>
Reviewed-by: Pavel Machek <pavel@denx.de>
Signed-off-by: Olof Johansson <olof@lixom.net>
This patch adds a common clock driver for Silicon Labs Si5351a/b/c i2c programmable clock generators. Currently, the driver does not support VXCO feature of si5351b. Passing platform_data or DT bindings selectively allows to overwrite stored Si5351 configuration which is very helpful for clock generators with empty eeprom configuration. Corresponding device tree binding documentation is also added. Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> Tested-by: Daniel Mack <zonque@gmail.com> Acked-by: Guenter Roeck <linux@roeck-us.net> Tested-by: Michal Bachraty <michal.bachraty@streamunlimited.com> Signed-off-by: Mike Turquette <mturquette@linaro.org>
Add support for DT "fixed-factor-clock" binding to the common fixed factor clock support. Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com> Tested-by: Christian Ruppert <christian.ruppert@abilis.com> Signed-off-by: Mike Turquette <mturquette@linaro.org>
Remove the tve_di clock from the CCM clock tree. It will be provided by the Television Encoder driver, as this clock is an output signal of the TVE module. Signed-off-by: Philipp Zabel <p.zabel@pengutronix.de> Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
This adds the clock gates and the binding documentation for PATA and SRTC. Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
These two clocks connect to external pins and can be muxed to various internal clocks. They are typically used either for debugging or to provide clocks to external chips (eg audio codecs). Currently only the selectable clocks that already exist in the clock tree have been added. Signed-off-by: Martin Fuzzey <mfuzzey@parkeon.com> Acked-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: Shawn Guo <shawn.guo@linaro.org>