One module per supported filter chain family type takes too much memory
for very little code - too much modularization - place all chain filter
definitions in one single file.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

Add new instruction for the nf_tables VM that allows us to specify what
flows are offloaded into a given flow table via name. This new
instruction creates the flow entry and adds it to the flow table.

Only established flows, ie. we have seen traffic in both directions, are
added to the flow table. You can still decide to offload entries at a
later stage via packet counting or checking the ct status in case you
want to offload assured conntracks.

This new extension depends on the conntrack subsystem.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

This patch adds the IPv6 flow table type, that implements the datapath
flow table to forward IPv6 traffic.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

This patch defines the API to interact with flow tables, this allows to
add, delete and lookup for entries in the flow table. This also adds the
generic garbage code that removes entries that have expired, ie. no
traffic has been seen for a while.

Users of the flow table infrastructure can delete entries via
flow_offload_dead(), which sets the dying bit, this signals the garbage
collector to release an entry from user context.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

We cannot make a direct call to nf_ip6_checksum() because that would
result in autoloading the 'ipv6' module because of symbol dependencies.
Therefore, define checksum indirection in nf_ipv6_ops where this really
belongs to.

For IPv4, we can indeed make a direct function call, which is faster,
given IPv4 is built-in in the networking code by default. Still,
CONFIG_INET=n and CONFIG_NETFILTER=y is possible, so define empty inline
stub for IPv4 in such case.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

This allows to reuse xt_connlimit infrastructure from nf_tables.
The upcoming nf_tables frontend can just pass in an nftables register
as input key, this allows limiting by any nft-supported key, including
concatenations.

For xt_connlimit, pass in the zone and the ip/ipv6 address.

With help from Yi-Hung Wei.

Signed-off-by: Florian Westphal <fw@strlen.de>
Acked-by: Yi-Hung Wei <yihung.wei@gmail.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

Many source files in the tree are missing licensing information, which
makes it harder for compliance tools to determine the correct license.

By default all files without license information are under the default
license of the kernel, which is GPL version 2.

Update the files which contain no license information with the 'GPL-2.0'
SPDX license identifier.  The SPDX identifier is a legally binding
shorthand, which can be used instead of the full boiler plate text.

This patch is based on work done by Thomas Gleixner and Kate Stewart and
Philippe Ombredanne.

How this work was done:

Patches were generated and checked against linux-4.14-rc6 for a subset of
the use cases:
 - file had no licensing information it it.
 - file was a */uapi/* one with no licensing information in it,
 - file was a */uapi/* one with existing licensing information,

Further patches will be generated in subsequent months to fix up cases
where non-standard license headers were used, and references to license
had to be inferred by heuristics based on keywords.

The analysis to determine which SPDX License Identifier to be applied to
a file was done in a spreadsheet of side by side results from of the
output of two independent scanners (ScanCode & Windriver) producing SPDX
tag:value files created by Philippe Ombredanne.  Philippe prepared the
base worksheet, and did an initial spot review of a few 1000 files.

The 4.13 kernel was the starting point of the analysis with 60,537 files
assessed.  Kate Stewart did a file by file comparison of the scanner
results in the spreadsheet to determine which SPDX license identifier(s)
to be applied to the file. She confirmed any determination that was not
immediately clear with lawyers working with the Linux Foundation.

Criteria used to select files for SPDX license identifier tagging was:
 - Files considered eligible had to be source code files.
 - Make and config files were included as candidates if they contained >5
   lines of source
 - File already had some variant of a license header in it (even if <5
   lines).

All documentation files were explicitly excluded.

The following heuristics were used to determine which SPDX license
identifiers to apply.

 - when both scanners couldn't find any license traces, file was
   considered to have no license information in it, and the top level
   COPYING file license applied.

   For non */uapi/* files that summary was:

   SPDX license identifier                            # files
   ---------------------------------------------------|-------
   GPL-2.0                                              11139

   and resulted in the first patch in this series.

   If that file was a */uapi/* path one, it was "GPL-2.0 WITH
   Linux-syscall-note" otherwise it was "GPL-2.0".  Results of that was:

   SPDX license identifier                            # files
   ---------------------------------------------------|-------
   GPL-2.0 WITH Linux-syscall-note                        930

   and resulted in the second patch in this series.

 - if a file had some form of licensing information in it, and was one
   of the */uapi/* ones, it was denoted with the Linux-syscall-note if
   any GPL family license was found in the file or had no licensing in
   it (per prior point).  Results summary:

   SPDX license identifier                            # files
   ---------------------------------------------------|------
   GPL-2.0 WITH Linux-syscall-note                       270
   GPL-2.0+ WITH Linux-syscall-note                      169
   ((GPL-2.0 WITH Linux-syscall-note) OR BSD-2-Clause)    21
   ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause)    17
   LGPL-2.1+ WITH Linux-syscall-note                      15
   GPL-1.0+ WITH Linux-syscall-note                       14
   ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause)    5
   LGPL-2.0+ WITH Linux-syscall-note                       4
   LGPL-2.1 WITH Linux-syscall-note                        3
   ((GPL-2.0 WITH Linux-syscall-note) OR MIT)              3
   ((GPL-2.0 WITH Linux-syscall-note) AND MIT)             1

   and that resulted in the third patch in this series.

 - when the two scanners agreed on the detected license(s), that became
   the concluded license(s).

 - when there was disagreement between the two scanners (one detected a
   license but the other didn't, or they both detected different
   licenses) a manual inspection of the file occurred.

 - In most cases a manual inspection of the information in the file
   resulted in a clear resolution of the license that should apply (and
   which scanner probably needed to revisit its heuristics).

 - When it was not immediately clear, the license identifier was
   confirmed with lawyers working with the Linux Foundation.

 - If there was any question as to the appropriate license identifier,
   the file was flagged for further research and to be revisited later
   in time.

In total, over 70 hours of logged manual review was done on the
spreadsheet to determine the SPDX license identifiers to apply to the
source files by Kate, Philippe, Thomas and, in some cases, confirmation
by lawyers working with the Linux Foundation.

Kate also obtained a third independent scan of the 4.13 code base from
FOSSology, and compared selected files where the other two scanners
disagreed against that SPDX file, to see if there was new insights.  The
Windriver scanner is based on an older version of FOSSology in part, so
they are related.

Thomas did random spot checks in about 500 files from the spreadsheets
for the uapi headers and agreed with SPDX license identifier in the
files he inspected. For the non-uapi files Thomas did random spot checks
in about 15000 files.

In initial set of patches against 4.14-rc6, 3 files were found to have
copy/paste license identifier errors, and have been fixed to reflect the
correct identifier.

Additionally Philippe spent 10 hours this week doing a detailed manual
inspection and review of the 12,461 patched files from the initial patch
version early this week with:
 - a full scancode scan run, collecting the matched texts, detected
   license ids and scores
 - reviewing anything where there was a license detected (about 500+
   files) to ensure that the applied SPDX license was correct
 - reviewing anything where there was no detection but the patch license
   was not GPL-2.0 WITH Linux-syscall-note to ensure that the applied
   SPDX license was correct

This produced a worksheet with 20 files needing minor correction.  This
worksheet was then exported into 3 different .csv files for the
different types of files to be modified.

These .csv files were then reviewed by Greg.  Thomas wrote a script to
parse the csv files and add the proper SPDX tag to the file, in the
format that the file expected.  This script was further refined by Greg
based on the output to detect more types of files automatically and to
distinguish between header and source .c files (which need different
comment types.)  Finally Greg ran the script using the .csv files to
generate the patches.

Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org>
Reviewed-by: Philippe Ombredanne <pombredanne@nexb.com>
Reviewed-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Add fib expression support for netdev family. Like inet family, netdev
delegates the actual decision to the corresponding backend, either ipv4
or ipv6.

This allows to perform very early reverse path filtering, among other
things.

You can find more information about fib expression in the f6d0cbcf09c5
("<netfilter: nf_tables: add fib expression>") commit message.

Signed-off-by: Pablo M. Bermudo Garay <pablombg@gmail.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

Should use ":=" instead of "+=".

Signed-off-by: Jike Song <jike.song@intel.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>

This patch adds a new bitmap set type. This bitmap uses two bits to
represent one element. These two bits determine the element state in the
current and the future generation that fits into the nf_tables commit
protocol. When dumping elements back to userspace, the two bits are
expanded into a struct nft_set_ext object.

If no NFTA_SET_DESC_SIZE is specified, the existing automatic set
backend selection prefers bitmap over hash in case of keys whose size is
<= 16 bit. If the set size is know, the bitmap set type is selected if
with 16 bit kets and more than 390 elements in the set, otherwise the
hash table set implementation is used.

For 8 bit keys, the bitmap consumes 66 bytes. For 16 bit keys, the
bitmap takes 16388 bytes.

Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>