linux-stable.git/net/ipv4/tcp_timer.c, branch linux-3.16.y

tcp: enforce tcp_min_snd_mss in tcp_mtu_probing()

2019-06-20T17:11:29+00:00

commit 967c05aee439e6e5d7d805e195b3a20ef5c433d6 upstream.

If mtu probing is enabled tcp_mtu_probing() could very well end up
with a too small MSS.

Use the new sysctl tcp_min_snd_mss to make sure MSS search
is performed in an acceptable range.

CVE-2019-11479 -- tcp mss hardcoded to 48

Signed-off-by: Eric Dumazet 
Reported-by: Jonathan Lemon 
Cc: Jonathan Looney 
Acked-by: Neal Cardwell 
Cc: Yuchung Cheng 
Cc: Tyler Hicks 
Cc: Bruce Curtis 
Signed-off-by: David S. Miller 
[Salvatore Bonaccorso: Backport for context changes in 4.9.168]
[bwh: Backported to 3.16: The sysctl is global]
Signed-off-by: Ben Hutchings

tcp: snmp stats for Fast Open, SYN rtx, and data pkts

2014-03-03T20:58:03+00:00

Add the following snmp stats:

TCPFastOpenActiveFail: Fast Open attempts (SYN/data) failed beacuse
the remote does not accept it or the attempts timed out.

TCPSynRetrans: number of SYN and SYN/ACK retransmits to break down
retransmissions into SYN, fast-retransmits, timeout retransmits, etc.

TCPOrigDataSent: number of outgoing packets with original data (excluding
retransmission but including data-in-SYN). This counter is different from
TcpOutSegs because TcpOutSegs also tracks pure ACKs. TCPOrigDataSent is
more useful to track the TCP retransmission rate.

Change TCPFastOpenActive to track only successful Fast Opens to be symmetric to
TCPFastOpenPassive.

Signed-off-by: Yuchung Cheng 
Signed-off-by: Eric Dumazet 
Signed-off-by: Nandita Dukkipati 
Signed-off-by: Lawrence Brakmo 
Signed-off-by: David S. Miller

tcp: temporarily disable Fast Open on SYN timeout

2013-10-30T02:50:41+00:00

Fast Open currently has a fall back feature to address SYN-data being
dropped but it requires the middle-box to pass on regular SYN retry
after SYN-data. This is implemented in commit aab487435 ("net-tcp:
Fast Open client - detecting SYN-data drops")

However some NAT boxes will drop all subsequent packets after first
SYN-data and blackholes the entire connections.  An example is in
commit 356d7d8 "netfilter: nf_conntrack: fix tcp_in_window for Fast
Open".

The sender should note such incidents and fall back to use the regular
TCP handshake on subsequent attempts temporarily as well: after the
second SYN timeouts the original Fast Open SYN is most likely lost.
When such an event recurs Fast Open is disabled based on the number of
recurrences exponentially.

Signed-off-by: Yuchung Cheng 
Signed-off-by: Neal Cardwell 
Signed-off-by: Eric Dumazet 
Signed-off-by: David S. Miller

ipv6: make lookups simpler and faster

2013-10-09T04:01:25+00:00

TCP listener refactoring, part 4 :

To speed up inet lookups, we moved IPv4 addresses from inet to struct
sock_common

Now is time to do the same for IPv6, because it permits us to have fast
lookups for all kind of sockets, including upcoming SYN_RECV.

Getting IPv6 addresses in TCP lookups currently requires two extra cache
lines, plus a dereference (and memory stall).

inet6_sk(sk) does the dereference of inet_sk(__sk)->pinet6

This patch is way bigger than its IPv4 counter part, because for IPv4,
we could add aliases (inet_daddr, inet_rcv_saddr), while on IPv6,
it's not doable easily.

inet6_sk(sk)->daddr becomes sk->sk_v6_daddr
inet6_sk(sk)->rcv_saddr becomes sk->sk_v6_rcv_saddr

And timewait socket also have tw->tw_v6_daddr & tw->tw_v6_rcv_saddr
at the same offset.

We get rid of INET6_TW_MATCH() as INET6_MATCH() is now the generic
macro.

Signed-off-by: Eric Dumazet 
Signed-off-by: David S. Miller

tcp: refactor F-RTO

2013-03-21T15:47:50+00:00

The patch series refactor the F-RTO feature (RFC4138/5682).

This is to simplify the loss recovery processing. Existing F-RTO
was developed during the experimental stage (RFC4138) and has
many experimental features.  It takes a separate code path from
the traditional timeout processing by overloading CA_Disorder
instead of using CA_Loss state. This complicates CA_Disorder state
handling because it's also used for handling dubious ACKs and undos.
While the algorithm in the RFC does not change the congestion control,
the implementation intercepts congestion control in various places
(e.g., frto_cwnd in tcp_ack()).

The new code implements newer F-RTO RFC5682 using CA_Loss processing
path.  F-RTO becomes a small extension in the timeout processing
and interfaces with congestion control and Eifel undo modules.
It lets congestion control (module) determines how many to send
independently.  F-RTO only chooses what to send in order to detect
spurious retranmission. If timeout is found spurious it invokes
existing Eifel undo algorithms like DSACK or TCP timestamp based
detection.

The first patch removes all F-RTO code except the sysctl_tcp_frto is
left for the new implementation.  Since CA_EVENT_FRTO is removed, TCP
westwood now computes ssthresh on regular timeout CA_EVENT_LOSS event.

Signed-off-by: Yuchung Cheng 
Acked-by: Neal Cardwell 
Acked-by: Eric Dumazet 
Signed-off-by: David S. Miller

tcp: TLP loss detection.

2013-03-12T12:30:34+00:00

This is the second of the TLP patch series; it augments the basic TLP
algorithm with a loss detection scheme.

This patch implements a mechanism for loss detection when a Tail
loss probe retransmission plugs a hole thereby masking packet loss
from the sender. The loss detection algorithm relies on counting
TLP dupacks as outlined in Sec. 3 of:
http://tools.ietf.org/html/draft-dukkipati-tcpm-tcp-loss-probe-01

The basic idea is: Sender keeps track of TLP "episode" upon
retransmission of a TLP packet. An episode ends when the sender receives
an ACK above the SND.NXT (tracked by tlp_high_seq) at the time of the
episode. We want to make sure that before the episode ends the sender
receives a "TLP dupack", indicating that the TLP retransmission was
unnecessary, so there was no loss/hole that needed plugging. If the
sender gets no TLP dupack before the end of the episode, then it reduces
ssthresh and the congestion window, because the TLP packet arriving at
the receiver probably plugged a hole.

Signed-off-by: Nandita Dukkipati 
Acked-by: Neal Cardwell 
Signed-off-by: David S. Miller

tcp: Tail loss probe (TLP)

2013-03-12T12:30:34+00:00

This patch series implement the Tail loss probe (TLP) algorithm described
in http://tools.ietf.org/html/draft-dukkipati-tcpm-tcp-loss-probe-01. The
first patch implements the basic algorithm.

TLP's goal is to reduce tail latency of short transactions. It achieves
this by converting retransmission timeouts (RTOs) occuring due
to tail losses (losses at end of transactions) into fast recovery.
TLP transmits one packet in two round-trips when a connection is in
Open state and isn't receiving any ACKs. The transmitted packet, aka
loss probe, can be either new or a retransmission. When there is tail
loss, the ACK from a loss probe triggers FACK/early-retransmit based
fast recovery, thus avoiding a costly RTO. In the absence of loss,
there is no change in the connection state.

PTO stands for probe timeout. It is a timer event indicating
that an ACK is overdue and triggers a loss probe packet. The PTO value
is set to max(2*SRTT, 10ms) and is adjusted to account for delayed
ACK timer when there is only one oustanding packet.

TLP Algorithm

On transmission of new data in Open state:
  -> packets_out > 1: schedule PTO in max(2*SRTT, 10ms).
  -> packets_out == 1: schedule PTO in max(2*RTT, 1.5*RTT + 200ms)
  -> PTO = min(PTO, RTO)

Conditions for scheduling PTO:
  -> Connection is in Open state.
  -> Connection is either cwnd limited or no new data to send.
  -> Number of probes per tail loss episode is limited to one.
  -> Connection is SACK enabled.

When PTO fires:
  new_segment_exists:
    -> transmit new segment.
    -> packets_out++. cwnd remains same.

  no_new_packet:
    -> retransmit the last segment.
       Its ACK triggers FACK or early retransmit based recovery.

ACK path:
  -> rearm RTO at start of ACK processing.
  -> reschedule PTO if need be.

In addition, the patch includes a small variation to the Early Retransmit
(ER) algorithm, such that ER and TLP together can in principle recover any
N-degree of tail loss through fast recovery. TLP is controlled by the same
sysctl as ER, tcp_early_retrans sysctl.
tcp_early_retrans==0; disables TLP and ER.
		 ==1; enables RFC5827 ER.
		 ==2; delayed ER.
		 ==3; TLP and delayed ER. [DEFAULT]
		 ==4; TLP only.

The TLP patch series have been extensively tested on Google Web servers.
It is most effective for short Web trasactions, where it reduced RTOs by 15%
and improved HTTP response time (average by 6%, 99th percentile by 10%).
The transmitted probes account for <0.5% of the overall transmissions.

Signed-off-by: Nandita Dukkipati 
Acked-by: Neal Cardwell 
Acked-by: Yuchung Cheng 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2012-11-10T23:32:51+00:00

Conflicts:
	drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c

Minor conflict between the BCM_CNIC define removal in net-next
and a bug fix added to net.  Based upon a conflict resolution
patch posted by Stephen Rothwell.

Signed-off-by: David S. Miller

tcp: better retrans tracking for defer-accept

2012-11-03T18:45:00+00:00

For passive TCP connections using TCP_DEFER_ACCEPT facility,
we incorrectly increment req->retrans each time timeout triggers
while no SYNACK is sent.

SYNACK are not sent for TCP_DEFER_ACCEPT that were established (for
which we received the ACK from client). Only the last SYNACK is sent
so that we can receive again an ACK from client, to move the req into
accept queue. We plan to change this later to avoid the useless
retransmit (and potential problem as this SYNACK could be lost)

TCP_INFO later gives wrong information to user, claiming imaginary
retransmits.

Decouple req->retrans field into two independent fields :

num_retrans : number of retransmit
num_timeout : number of timeouts

num_timeout is the counter that is incremented at each timeout,
regardless of actual SYNACK being sent or not, and used to
compute the exponential timeout.

Introduce inet_rtx_syn_ack() helper to increment num_retrans
only if ->rtx_syn_ack() succeeded.

Use inet_rtx_syn_ack() from tcp_check_req() to increment num_retrans
when we re-send a SYNACK in answer to a (retransmitted) SYN.
Prior to this patch, we were not counting these retransmits.

Change tcp_v[46]_rtx_synack() to increment TCP_MIB_RETRANSSEGS
only if a synack packet was successfully queued.

Reported-by: Yuchung Cheng 
Signed-off-by: Eric Dumazet 
Cc: Julian Anastasov 
Cc: Vijay Subramanian 
Cc: Elliott Hughes 
Cc: Neal Cardwell 
Signed-off-by: David S. Miller

tcp: Reject invalid ack_seq to Fast Open sockets

2012-10-23T06:42:56+00:00

A packet with an invalid ack_seq may cause a TCP Fast Open socket to switch
to the unexpected TCP_CLOSING state, triggering a BUG_ON kernel panic.

When a FIN packet with an invalid ack_seq# arrives at a socket in
the TCP_FIN_WAIT1 state, rather than discarding the packet, the current
code will accept the FIN, causing state transition to TCP_CLOSING.

This may be a small deviation from RFC793, which seems to say that the
packet should be dropped. Unfortunately I did not expect this case for
Fast Open hence it will trigger a BUG_ON panic.

It turns out there is really nothing bad about a TFO socket going into
TCP_CLOSING state so I could just remove the BUG_ON statements. But after
some thought I think it's better to treat this case like TCP_SYN_RECV
and return a RST to the confused peer who caused the unacceptable ack_seq
to be generated in the first place.

Signed-off-by: H.K. Jerry Chu 
Cc: Neal Cardwell 
Cc: Yuchung Cheng 
Acked-by: Yuchung Cheng 
Acked-by: Eric Dumazet 
Acked-by: Neal Cardwell 
Signed-off-by: David S. Miller