Pull PCI updates from Bjorn Helgaas:

  - unify AER decoding for native and ACPI CPER sources (Alexandru
    Gagniuc)

  - add TLP header info to AER tracepoint (Thomas Tai)

  - add generic pcie_wait_for_link() interface (Oza Pawandeep)

  - handle AER ERR_FATAL by removing and re-enumerating devices, as
    Downstream Port Containment does (Oza Pawandeep)

  - factor out common code between AER and DPC recovery (Oza Pawandeep)

  - stop triggering DPC for ERR_NONFATAL errors (Oza Pawandeep)

  - share ERR_FATAL recovery path between AER and DPC (Oza Pawandeep)

  - disable ASPM L1.2 substate if we don't have LTR (Bjorn Helgaas)

  - respect platform ownership of LTR (Bjorn Helgaas)

  - clear interrupt status in top half to avoid interrupt storm (Oza
    Pawandeep)

  - neaten pci=earlydump output (Andy Shevchenko)

  - avoid errors when extended config space inaccessible (Gilles Buloz)

  - prevent sysfs disable of device while driver attached (Christoph
    Hellwig)

  - use core interface to report PCIe link properties in bnx2x, bnxt_en,
    cxgb4, ixgbe (Bjorn Helgaas)

  - remove unused pcie_get_minimum_link() (Bjorn Helgaas)

  - fix use-before-set error in ibmphp (Dan Carpenter)

  - fix pciehp timeouts caused by Command Completed errata (Bjorn
    Helgaas)

  - fix refcounting in pnv_php hotplug (Julia Lawall)

  - clear pciehp Presence Detect and Data Link Layer Status Changed on
    resume so we don't miss hotplug events (Mika Westerberg)

  - only request pciehp control if we support it, so platform can use
    ACPI hotplug otherwise (Mika Westerberg)

  - convert SHPC to be builtin only (Mika Westerberg)

  - request SHPC control via _OSC if we support it (Mika Westerberg)

  - simplify SHPC handoff from firmware (Mika Westerberg)

  - fix an SHPC quirk that mistakenly included *all* AMD bridges as well
    as devices from any vendor with device ID 0x7458 (Bjorn Helgaas)

  - assign a bus number even to non-native hotplug bridges to leave
    space for acpiphp additions, to fix a common Thunderbolt xHCI
    hot-add failure (Mika Westerberg)

  - keep acpiphp from scanning native hotplug bridges, to fix common
    Thunderbolt hot-add failures (Mika Westerberg)

  - improve "partially hidden behind bridge" messages from core (Mika
    Westerberg)

  - add macros for PCIe Link Control 2 register (Frederick Lawler)

  - replace IB/hfi1 custom macros with PCI core versions (Frederick
    Lawler)

  - remove dead microblaze and xtensa code (Bjorn Helgaas)

  - use dev_printk() when possible in xtensa and mips (Bjorn Helgaas)

  - remove unused pcie_port_acpi_setup() and portdrv_acpi.c (Bjorn
    Helgaas)

  - add managed interface to get PCI host bridge resources from OF (Jan
    Kiszka)

  - add support for unbinding generic PCI host controller (Jan Kiszka)

  - fix memory leaks when unbinding generic PCI host controller (Jan
    Kiszka)

  - request legacy VGA framebuffer only for VGA devices to avoid false
    device conflicts (Bjorn Helgaas)

  - turn on PCI_COMMAND_IO & PCI_COMMAND_MEMORY in pci_enable_device()
    like everybody else, not in pcibios_fixup_bus() (Bjorn Helgaas)

  - add generic enable function for simple SR-IOV hardware (Alexander
    Duyck)

  - use generic SR-IOV enable for ena, nvme (Alexander Duyck)

  - add ACS quirk for Intel 7th & 8th Gen mobile (Alex Williamson)

  - add ACS quirk for Intel 300 series (Mika Westerberg)

  - enable register clock for Armada 7K/8K (Gregory CLEMENT)

  - reduce Keystone "link already up" log level (Fabio Estevam)

  - move private DT functions to drivers/pci/ (Rob Herring)

  - factor out dwc CONFIG_PCI Kconfig dependencies (Rob Herring)

  - add DesignWare support to the endpoint test driver (Gustavo
    Pimentel)

  - add DesignWare support for endpoint mode (Gustavo Pimentel)

  - use devm_ioremap_resource() instead of devm_ioremap() in dra7xx and
    artpec6 (Gustavo Pimentel)

  - fix Qualcomm bitwise NOT issue (Dan Carpenter)

  - add Qualcomm runtime PM support (Srinivas Kandagatla)

  - fix DesignWare enumeration below bridges (Koen Vandeputte)

  - use usleep() instead of mdelay() in endpoint test (Jia-Ju Bai)

  - add configfs entries for pci_epf_driver device IDs (Kishon Vijay
    Abraham I)

  - clean up pci_endpoint_test driver (Gustavo Pimentel)

  - update Layerscape maintainer email addresses (Minghuan Lian)

  - add COMPILE_TEST to improve build test coverage (Rob Herring)

  - fix Hyper-V bus registration failure caused by domain/serial number
    confusion (Sridhar Pitchai)

  - improve Hyper-V refcounting and coding style (Stephen Hemminger)

  - avoid potential Hyper-V hang waiting for a response that will never
    come (Dexuan Cui)

  - implement Mediatek chained IRQ handling (Honghui Zhang)

  - fix vendor ID & class type for Mediatek MT7622 (Honghui Zhang)

  - add Mobiveil PCIe host controller driver (Subrahmanya Lingappa)

  - add Mobiveil MSI support (Subrahmanya Lingappa)

  - clean up clocks, MSI, IRQ mappings in R-Car probe failure paths
    (Marek Vasut)

  - poll more frequently (5us vs 5ms) while waiting for R-Car data link
    active (Marek Vasut)

  - use generic OF parsing interface in R-Car (Vladimir Zapolskiy)

  - add R-Car V3H (R8A77980) "compatible" string (Sergei Shtylyov)

  - add R-Car gen3 PHY support (Sergei Shtylyov)

  - improve R-Car PHYRDY polling (Sergei Shtylyov)

  - clean up R-Car macros (Marek Vasut)

  - use runtime PM for R-Car controller clock (Dien Pham)

  - update arm64 defconfig for Rockchip (Shawn Lin)

  - refactor Rockchip code to facilitate both root port and endpoint
    mode (Shawn Lin)

  - add Rockchip endpoint mode driver (Shawn Lin)

  - support VMD "membar shadow" feature (Jon Derrick)

  - support VMD bus number offsets (Jon Derrick)

  - add VMD "no AER source ID" quirk for more device IDs (Jon Derrick)

  - remove unnecessary host controller CONFIG_PCIEPORTBUS Kconfig
    selections (Bjorn Helgaas)

  - clean up quirks.c organization and whitespace (Bjorn Helgaas)

* tag 'pci-v4.18-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci: (144 commits)
  PCI/AER: Replace struct pcie_device with pci_dev
  PCI/AER: Remove unused parameters
  PCI: qcom: Include gpio/consumer.h
  PCI: Improve "partially hidden behind bridge" log message
  PCI: Improve pci_scan_bridge() and pci_scan_bridge_extend() doc
  PCI: Move resource distribution for single bridge outside loop
  PCI: Account for all bridges on bus when distributing bus numbers
  ACPI / hotplug / PCI: Drop unnecessary parentheses
  ACPI / hotplug / PCI: Mark stale PCI devices disconnected
  ACPI / hotplug / PCI: Don't scan bridges managed by native hotplug
  PCI: hotplug: Add hotplug_is_native()
  PCI: shpchp: Add shpchp_is_native()
  PCI: shpchp: Fix AMD POGO identification
  PCI: mobiveil: Add MSI support
  PCI: mobiveil: Add Mobiveil PCIe Host Bridge IP driver
  PCI/AER: Decode Error Source Requester ID
  PCI/AER: Remove aer_recover_work_func() forward declaration
  PCI/DPC: Use the generic pcie_do_fatal_recovery() path
  PCI/AER: Pass service type to pcie_do_fatal_recovery()
  PCI/DPC: Disable ERR_NONFATAL handling by DPC
  ...

  - add macros for PCIe Link Control 2 register (Frederick Lawler)

  - replace IB/hfi1 custom macros with PCI core versions (Frederick Lawler)

  - remove dead microblaze and xtensa code (Bjorn Helgaas)

  - use dev_printk() when possible in xtensa and mips (Bjorn Helgaas)

* pci/misc:
  MIPS: PCI: Use dev_printk() when possible
  xtensa/PCI: Use dev_printk() when possible
  xtensa/PCI: Make variables static
  xtensa/PCI: Remove dead code
  microblaze/PCI: Remove pcibios_claim_one_bus() dead code
  microblaze/PCI: Remove pcibios_finish_adding_to_bus() dead code
  IB/hfi1: Replace custom hfi1 macros with PCIe macros
  PCI: Add PCI_EXP_LNKCTL2_TLS* macros

PCIe ERR_NONFATAL errors mean a particular transaction is unreliable but
the Link is otherwise fully functional (PCIe r4.0, sec 6.2.2).

The AER driver handles these by logging the error details and calling
driver-supplied pci_error_handlers callbacks.  It does not reset downstream
devices, does not remove them from the PCI subsystem, does not re-enumerate
them, and does not call their driver .remove() or .probe() methods.

But DPC driver previously enabled DPC on ERR_NONFATAL, so if the hardware
supports DPC, these errors caused a Link reset (performed automatically by
the hardware), followed by the DPC driver removing affected devices (which
calls their .remove() methods), bringing the Link back up, and
re-enumerating (which calls driver .probe() methods).

Disable ERR_NONFATAL DPC triggering so these errors will only be handled by
AER.  This means drivers won't have to deal with different usage of their
pci_error_handlers callbacks and .probe() and .remove() methods based on
whether the platform has DPC support.

Signed-off-by: Oza Pawandeep <poza@codeaurora.org>
[bhelgaas: changelog]
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>

The Link Control 2 register is missing macros for Target Link Speeds.  Add
those in.

Signed-off-by: Frederick Lawler <fred@fredlawl.com>
[bhelgaas: use "GT" instead of "GB"]
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>

This patch adds missing values for the max read request size.
E.g. network driver r8169 uses a value of 4K.

Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Acked-by: Bjorn Helgaas <bhelgaas@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

PCIe 4.0 defines the 16.0 GT/s link speed.  Links can run at that speed
without any Linux changes, but previously their sysfs "max_link_speed" and
"current_link_speed" files contained "Unknown speed", not the expected
"16.0 GT/s".

Add decoding for the new 16 GT/s link speed.

Signed-off-by: Jay Fang <f.fangjian@huawei.com>
[bhelgaas: add PCI_EXP_LNKCAP2_SLS_16_0GB]
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Reviewed-by: Dongdong Liu <liudongdong3@huawei.com>

* pci/misc:
  PCI: Add dummy pci_irqd_intx_xlate() for CONFIG_PCI=n build
  PCI: Add wrappers for dev_printk()
  PCI: Remove unnecessary messages for memory allocation failures
  PCI: Add #defines for Completion Timeout Disable feature
  hinic: Replace PCI pool old API
  net: e100: Replace PCI pool old API
  block: DAC960: Replace PCI pool old API
  MAINTAINERS: Include more PCI files
  PCI: Remove unneeded kallsyms include
  powerpc/pci: Unroll two pass loop when scanning bridges
  powerpc/pci: Use for_each_pci_bridge() helper

* pci/enumeration:
  RDMA/qedr: Use pci_enable_atomic_ops_to_root()
  PCI: Add pci_enable_atomic_ops_to_root()
  PCI: Make PCI_SCAN_ALL_PCIE_DEVS work for Root as well as Downstream Ports

Reformat DPC register definitions to follow the convention that register
field masks indicate the register width, e.g., a field of a 16-bit register
uses a mask of 4 hex digits, with leading zeros included as needed.
No functional change intended.

Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Reviewed-by: Keith Busch <keith.busch@intel.com>
Reviewed-by: Sinan Kaya <okaya@codeaurora.org>

Add definitions for DPC Status register fields and use them in the code.
No functional change intended.

Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Reviewed-by: Keith Busch <keith.busch@intel.com>
Reviewed-by: Sinan Kaya <okaya@codeaurora.org>