linux-stable.git/include/net, branch v6.9.6

Bluetooth: L2CAP: Fix rejecting L2CAP_CONN_PARAM_UPDATE_REQ

2024-06-21T12:40:22+00:00

[ Upstream commit 806a5198c05987b748b50f3d0c0cfb3d417381a4 ]

This removes the bogus check for max > hcon->le_conn_max_interval since
the later is just the initial maximum conn interval not the maximum the
stack could support which is really 3200=4000ms.

In order to pass GAP/CONN/CPUP/BV-05-C one shall probably enter values
of the following fields in IXIT that would cause hci_check_conn_params
to fail:

TSPX_conn_update_int_min
TSPX_conn_update_int_max
TSPX_conn_update_peripheral_latency
TSPX_conn_update_supervision_timeout

Link: https://github.com/bluez/bluez/issues/847
Fixes: e4b019515f95 ("Bluetooth: Enforce validation on max value of connection interval")
Signed-off-by: Luiz Augusto von Dentz 
Signed-off-by: Sasha Levin

geneve: Fix incorrect inner network header offset when innerprotoinherit is set

2024-06-21T12:40:22+00:00

[ Upstream commit c6ae073f5903f6c6439d0ac855836a4da5c0a701 ]

When innerprotoinherit is set, the tunneled packets do not have an inner
Ethernet header.
Change 'maclen' to not always assume the header length is ETH_HLEN, as
there might not be a MAC header.

This resolves issues with drivers (e.g. mlx5, in
mlx5e_tx_tunnel_accel()) who rely on the skb inner network header offset
to be correct, and use it for TX offloads.

Fixes: d8a6213d70ac ("geneve: fix header validation in geneve[6]_xmit_skb")
Signed-off-by: Gal Pressman 
Signed-off-by: Tariq Toukan 
Reviewed-by: Wojciech Drewek 
Signed-off-by: David S. Miller 
Signed-off-by: Sasha Levin

rtnetlink: make the "split" NLM_DONE handling generic

2024-06-21T12:40:06+00:00

[ Upstream commit 5b4b62a169e10401cca34a6e7ac39161986f5605 ]

Jaroslav reports Dell's OMSA Systems Management Data Engine
expects NLM_DONE in a separate recvmsg(), both for rtnl_dump_ifinfo()
and inet_dump_ifaddr(). We already added a similar fix previously in
commit 460b0d33cf10 ("inet: bring NLM_DONE out to a separate recv() again")

Instead of modifying all the dump handlers, and making them look
different than modern for_each_netdev_dump()-based dump handlers -
put the workaround in rtnetlink code. This will also help us move
the custom rtnl-locking from af_netlink in the future (in net-next).

Note that this change is not touching rtnl_dump_all(). rtnl_dump_all()
is different kettle of fish and a potential problem. We now mix families
in a single recvmsg(), but NLM_DONE is not coalesced.

Tested:

  ./cli.py --dbg-small-recv 4096 --spec netlink/specs/rt_addr.yaml \
           --dump getaddr --json '{"ifa-family": 2}'

  ./cli.py --dbg-small-recv 4096 --spec netlink/specs/rt_route.yaml \
           --dump getroute --json '{"rtm-family": 2}'

  ./cli.py --dbg-small-recv 4096 --spec netlink/specs/rt_link.yaml \
           --dump getlink

Fixes: 3e41af90767d ("rtnetlink: use xarray iterator to implement rtnl_dump_ifinfo()")
Fixes: cdb2f80f1c10 ("inet: use xa_array iterator to implement inet_dump_ifaddr()")
Reported-by: Jaroslav Pulchart 
Link: https://lore.kernel.org/all/CAK8fFZ7MKoFSEzMBDAOjoUt+vTZRRQgLDNXEOfdCCXSoXXKE0g@mail.gmail.com
Signed-off-by: Jakub Kicinski 
Reviewed-by: Eric Dumazet 
Signed-off-by: David S. Miller 
Signed-off-by: Sasha Levin

net/tcp: Don't consider TCP_CLOSE in TCP_AO_ESTABLISHED

2024-06-16T11:51:05+00:00

commit 33700a0c9b562700c28d31360a5f04508f459a45 upstream.

TCP_CLOSE may or may not have current/rnext keys and should not be
considered "established". The fast-path for TCP_CLOSE is
SKB_DROP_REASON_TCP_CLOSE. This is what tcp_rcv_state_process() does
anyways. Add an early drop path to not spend any time verifying
segment signatures for sockets in TCP_CLOSE state.

Cc: stable@vger.kernel.org # v6.7
Fixes: 0a3a809089eb ("net/tcp: Verify inbound TCP-AO signed segments")
Signed-off-by: Dmitry Safonov <0x7f454c46@gmail.com>
Link: https://lore.kernel.org/r/20240529-tcp_ao-sk_state-v1-1-d69b5d323c52@gmail.com
Signed-off-by: Jakub Kicinski 
Signed-off-by: Greg Kroah-Hartman

net: fix __dst_negative_advice() race

2024-06-12T09:39:55+00:00

[ Upstream commit 92f1655aa2b2294d0b49925f3b875a634bd3b59e ]

__dst_negative_advice() does not enforce proper RCU rules when
sk->dst_cache must be cleared, leading to possible UAF.

RCU rules are that we must first clear sk->sk_dst_cache,
then call dst_release(old_dst).

Note that sk_dst_reset(sk) is implementing this protocol correctly,
while __dst_negative_advice() uses the wrong order.

Given that ip6_negative_advice() has special logic
against RTF_CACHE, this means each of the three ->negative_advice()
existing methods must perform the sk_dst_reset() themselves.

Note the check against NULL dst is centralized in
__dst_negative_advice(), there is no need to duplicate
it in various callbacks.

Many thanks to Clement Lecigne for tracking this issue.

This old bug became visible after the blamed commit, using UDP sockets.

Fixes: a87cb3e48ee8 ("net: Facility to report route quality of connected sockets")
Reported-by: Clement Lecigne 
Diagnosed-by: Clement Lecigne 
Signed-off-by: Eric Dumazet 
Cc: Tom Herbert 
Reviewed-by: David Ahern 
Link: https://lore.kernel.org/r/20240528114353.1794151-1-edumazet@google.com
Signed-off-by: Jakub Kicinski 
Signed-off-by: Sasha Levin

inet: introduce dst_rtable() helper

2024-06-12T09:39:55+00:00

[ Upstream commit 05d6d492097c55f2d153fc3fd33cbe78e1e28e0a ]

I added dst_rt6_info() in commit
e8dfd42c17fa ("ipv6: introduce dst_rt6_info() helper")

This patch does a similar change for IPv4.

Instead of (struct rtable *)dst casts, we can use :

 #define dst_rtable(_ptr) \
             container_of_const(_ptr, struct rtable, dst)

Patch is smaller than IPv6 one, because IPv4 has skb_rtable() helper.

Signed-off-by: Eric Dumazet 
Reviewed-by: David Ahern 
Reviewed-by: Sabrina Dubroca 
Link: https://lore.kernel.org/r/20240429133009.1227754-1-edumazet@google.com
Signed-off-by: Jakub Kicinski 
Stable-dep-of: 92f1655aa2b2 ("net: fix __dst_negative_advice() race")
Signed-off-by: Sasha Levin

ipv6: introduce dst_rt6_info() helper

2024-06-12T09:39:54+00:00

[ Upstream commit e8dfd42c17faf183415323db1ef0c977be0d6489 ]

Instead of (struct rt6_info *)dst casts, we can use :

 #define dst_rt6_info(_ptr) \
         container_of_const(_ptr, struct rt6_info, dst)

Some places needed missing const qualifiers :

ip6_confirm_neigh(), ipv6_anycast_destination(),
ipv6_unicast_destination(), has_gateway()

v2: added missing parts (David Ahern)

Signed-off-by: Eric Dumazet 
Reviewed-by: David Ahern 
Signed-off-by: David S. Miller 
Stable-dep-of: 92f1655aa2b2 ("net: fix __dst_negative_advice() race")
Signed-off-by: Sasha Levin

Bluetooth: ISO: Handle PA sync when no BIGInfo reports are generated

2024-06-12T09:39:36+00:00

[ Upstream commit d356c924e7a3adbea1e3e4ff4e098bcd9b99a82d ]

In case of a Broadcast Source that has PA enabled but no active BIG,
a Broadcast Sink needs to establish PA sync and parse BASE from PA
reports.

This commit moves the allocation of a PA sync hcon from the BIGInfo
advertising report event to the PA sync established event. After the
first complete PA report, the hcon is notified to the ISO layer. A
child socket is allocated and enqueued in the parent's accept queue.

BIGInfo reports also need to be processed, to extract the encryption
field and inform userspace. After the first BIGInfo report is received,
the PA sync hcon is notified again to the ISO layer. Since a socket will
be found this time, the socket state will transition to BT_CONNECTED and
the userspace will be woken up using sk_state_change.

Signed-off-by: Iulia Tanasescu 
Signed-off-by: Luiz Augusto von Dentz 
Stable-dep-of: a5b862c6a221 ("Bluetooth: L2CAP: Fix div-by-zero in l2cap_le_flowctl_init()")
Signed-off-by: Sasha Levin

Bluetooth: hci_core: Fix not handling hdev->le_num_of_adv_sets=1

2024-05-30T07:44:41+00:00

[ Upstream commit e77f43d531af41e9ce299eab10dcae8fa5dbc293 ]

If hdev->le_num_of_adv_sets is set to 1 it means that only handle 0x00
can be used, but since the MGMT interface instances start from 1
(instance 0 means all instances in case of MGMT_OP_REMOVE_ADVERTISING)
the code needs to map the instance to handle otherwise users will not be
able to advertise as instance 1 would attempt to use handle 0x01.

Fixes: 1d0fac2c38ed ("Bluetooth: Use controller sets when available")
Signed-off-by: Luiz Augusto von Dentz 
Signed-off-by: Sasha Levin

Bluetooth: hci_conn, hci_sync: Use __counted_by() to avoid -Wfamnae warnings

2024-05-30T07:44:41+00:00

[ Upstream commit c4585edf708edb5277a3cc4b8581ccb833f3307d ]

Prepare for the coming implementation by GCC and Clang of the
__counted_by attribute. Flexible array members annotated with
__counted_by can have their accesses bounds-checked at run-time
via CONFIG_UBSAN_BOUNDS (for array indexing) and CONFIG_FORTIFY_SOURCE
(for strcpy/memcpy-family functions).

Also, -Wflex-array-member-not-at-end is coming in GCC-14, and we are
getting ready to enable it globally.

So, use the `DEFINE_FLEX()` helper for multiple on-stack definitions
of a flexible structure where the size of the flexible-array member
is known at compile-time, and refactor the rest of the code,
accordingly.

Notice that, due to the use of `__counted_by()` in `struct
hci_cp_le_create_cis`, the for loop in function `hci_cs_le_create_cis()`
had to be modified. Once the index `i`, through which `cp->cis[i]` is
accessed, falls in the interval [0, cp->num_cis), `cp->num_cis` cannot
be decremented all the way down to zero while accessing `cp->cis[]`:

net/bluetooth/hci_event.c:4310:
4310    for (i = 0; cp->num_cis; cp->num_cis--, i++) {
                ...
4314            handle = __le16_to_cpu(cp->cis[i].cis_handle);

otherwise, only half (one iteration before `cp->num_cis == i`) or half
plus one (one iteration before `cp->num_cis < i`) of the items in the
array will be accessed before running into an out-of-bounds issue. So,
in order to avoid this, set `cp->num_cis` to zero just after the for
loop.

Also, make use of `aux_num_cis` variable to update `cmd->num_cis` after
a `list_for_each_entry_rcu()` loop.

With these changes, fix the following warnings:
net/bluetooth/hci_sync.c:1239:56: warning: structure containing a flexible
array member is not at the end of another structure
[-Wflex-array-member-not-at-end]
net/bluetooth/hci_sync.c:1415:51: warning: structure containing a flexible
array member is not at the end of another structure
[-Wflex-array-member-not-at-end]
net/bluetooth/hci_sync.c:1731:51: warning: structure containing a flexible
array member is not at the end of another structure
[-Wflex-array-member-not-at-end]
net/bluetooth/hci_sync.c:6497:45: warning: structure containing a flexible
array member is not at the end of another structure
[-Wflex-array-member-not-at-end]

Link: https://github.com/KSPP/linux/issues/202
Signed-off-by: Gustavo A. R. Silva 
Signed-off-by: Luiz Augusto von Dentz 
Stable-dep-of: e77f43d531af ("Bluetooth: hci_core: Fix not handling hdev->le_num_of_adv_sets=1")
Signed-off-by: Sasha Levin