linux-stable.git/include/linux/mlx4/device.h, branch v3.12.2

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next

2013-09-05T21:54:29+00:00

Pull networking changes from David Miller:
 "Noteworthy changes this time around:

   1) Multicast rejoin support for team driver, from Jiri Pirko.

   2) Centralize and simplify TCP RTT measurement handling in order to
      reduce the impact of bad RTO seeding from SYN/ACKs.  Also, when
      both timestamps and local RTT measurements are available prefer
      the later because there are broken middleware devices which
      scramble the timestamp.

      From Yuchung Cheng.

   3) Add TCP_NOTSENT_LOWAT socket option to limit the amount of kernel
      memory consumed to queue up unsend user data.  From Eric Dumazet.

   4) Add a "physical port ID" abstraction for network devices, from
      Jiri Pirko.

   5) Add a "suppress" operation to influence fib_rules lookups, from
      Stefan Tomanek.

   6) Add a networking development FAQ, from Paul Gortmaker.

   7) Extend the information provided by tcp_probe and add ipv6 support,
      from Daniel Borkmann.

   8) Use RCU locking more extensively in openvswitch data paths, from
      Pravin B Shelar.

   9) Add SCTP support to openvswitch, from Joe Stringer.

  10) Add EF10 chip support to SFC driver, from Ben Hutchings.

  11) Add new SYNPROXY netfilter target, from Patrick McHardy.

  12) Compute a rate approximation for sending in TCP sockets, and use
      this to more intelligently coalesce TSO frames.  Furthermore, add
      a new packet scheduler which takes advantage of this estimate when
      available.  From Eric Dumazet.

  13) Allow AF_PACKET fanouts with random selection, from Daniel
      Borkmann.

  14) Add ipv6 support to vxlan driver, from Cong Wang"

Resolved conflicts as per discussion.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1218 commits)
  openvswitch: Fix alignment of struct sw_flow_key.
  netfilter: Fix build errors with xt_socket.c
  tcp: Add missing braces to do_tcp_setsockopt
  caif: Add missing braces to multiline if in cfctrl_linkup_request
  bnx2x: Add missing braces in bnx2x:bnx2x_link_initialize
  vxlan: Fix kernel panic on device delete.
  net: mvneta: implement ->ndo_do_ioctl() to support PHY ioctls
  net: mvneta: properly disable HW PHY polling and ensure adjust_link() works
  icplus: Use netif_running to determine device state
  ethernet/arc/arc_emac: Fix huge delays in large file copies
  tuntap: orphan frags before trying to set tx timestamp
  tuntap: purge socket error queue on detach
  qlcnic: use standard NAPI weights
  ipv6:introduce function to find route for redirect
  bnx2x: VF RSS support - VF side
  bnx2x: VF RSS support - PF side
  vxlan: Notify drivers for listening UDP port changes
  net: usbnet: update addr_assign_type if appropriate
  driver/net: enic: update enic maintainers and driver
  driver/net: enic: Exposing symbols for Cisco's low latency driver
  ...

IB/mlx4: Add receive flow steering support

2013-08-28T16:53:56+00:00

Implement ib_create_flow() and ib_destroy_flow().

Translate the verbs structures provided by the user to HW structures
and call the MLX4_QP_FLOW_STEERING_ATTACH/DETACH firmware commands.

On the ATTACH command completion, the firmware provides a 64-bit
registration ID, which is placed into struct mlx4_ib_flow that wraps
the instance of struct ib_flow which is retuned to caller.  Later,
this reg ID is used for detaching that flow from the firmware.

Signed-off-by: Hadar Hen Zion 
Signed-off-by: Or Gerlitz 
Signed-off-by: Roland Dreier

include: Convert ethernet mac address declarations to use ETH_ALEN

2013-08-02T19:33:54+00:00

It's convenient to have ethernet mac addresses use
ETH_ALEN to be able to grep for them a bit easier and
also to ensure that the addresses are __aligned(2).

Add #include  as necessary.

Signed-off-by: Joe Perches 
Acked-by: Mauro Carvalho Chehab 
Signed-off-by: David S. Miller

net/mlx4_core: Respond to operation request by firmware

2013-07-29T08:12:40+00:00

This commit adds new firmware command and new firmware event.  The firmware
raises the MLX4_EVENT_TYPE_OP_REQUIRED event in order to signal the driver it
needs to perform an administrative operation throughout the MLX4_CMD_GET_OP_REQ
command. At the moment the supported operation is adding/removing multicast
entries which are used by the firmware for handling NCSI traffic in B0
steering mode.

Also, had to swap the order of mlx4_init_mcg_table() and
mlx4_init_eq_table() to make sure that driver will get events only after
resources are initialized to handle it.

Signed-off-by: Yevgeny Petrilin 
Signed-off-by: Jack Morgenstein 
Signed-off-by: Eugenia Emantayev 
Signed-off-by: Amir Vadai 
Signed-off-by: David S. Miller

net/mlx4_core: Dynamic VST to VST vlan/qos changes

2013-07-01T20:10:22+00:00

Within VST mode, enable modifying the vlan and/or qos
for a VF without requiring unbind/rebind.

This requires firmware which supports the UPDATE_QP command.
(If the command is not available, we fall back to requiring
unbind/bind to activate these changes).

To avoid race conditions with modify-qp on QPs that are affected
by update-qp, this operation is performed on the comm_wq.

If the update operation succeeds for all the necessary QPs, a
vlan_unregister is performed for the abandoned vlan id.

Signed-off-by: Jack Morgenstein 
Signed-off-by: Or Gerlitz 
Signed-off-by: David S. Miller

Merge tag 'rdma-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband

2013-05-08T22:29:48+00:00

Pull InfiniBand/RDMA changes from Roland Dreier:
 - XRC transport fixes
 - Fix DHCP on IPoIB
 - mlx4 preparations for flow steering
 - iSER fixes
 - miscellaneous other fixes

* tag 'rdma-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband: (23 commits)
  IB/iser: Add support for iser CM REQ additional info
  IB/iser: Return error to upper layers on EAGAIN registration failures
  IB/iser: Move informational messages from error to info level
  IB/iser: Add module version
  mlx4_core: Expose a few helpers to fill DMFS HW strucutures
  mlx4_core: Directly expose fields of DMFS HW rule control segment
  mlx4_core: Change a few DMFS fields names to match firmare spec
  mlx4: Match DMFS promiscuous field names to firmware spec
  mlx4_core: Move DMFS HW structs to common header file
  IB/mlx4: Set link type for RAW PACKET QPs in the QP context
  IB/mlx4: Disable VLAN stripping for RAW PACKET QPs
  mlx4_core: Reduce warning message for SRQ_LIMIT event to debug level
  RDMA/iwcm: Don't touch cmid after dropping reference
  IB/qib: Correct qib_verbs_register_sysfs() error handling
  IB/ipath: Correct ipath_verbs_register_sysfs() error handling
  RDMA/cxgb4: Fix SQ allocation when on-chip SQ is disabled
  SRPT: Fix odd use of WARN_ON()
  IPoIB: Fix ipoib_hard_header() return value
  RDMA: Rename random32() to prandom_u32()
  RDMA/cxgb3: Fix uninitialized variable
  ...

net/mlx4: Add VF MAC spoof checking support

2013-04-27T03:29:14+00:00

Add ndo_set_vf_spoofchk support

Signed-off-by: Rony Efraim 
Signed-off-by: Or Gerlitz 
Signed-off-by: David S. Miller

net/mlx4: Add set VF default vlan ID and priority support

2013-04-27T03:29:13+00:00

Add support to ndo_set_vf_vlan in the driver. Once this call is used the vport
is considered to be in VST mode. In this mode, the PPF driver configures
Ethernet QPs created by this VF to use this vlan id and priority. Currently
RoCE isn't supported on that mode.

The special values of VID=4095 or VID=0,UP=0 are considered as VGT.

Signed-off-by: Rony Efraim 
Signed-off-by: Or Gerlitz 
Signed-off-by: David S. Miller

mlx4_core: Expose a few helpers to fill DMFS HW strucutures

2013-04-25T00:51:30+00:00

Re-arrange some of code which fills DMFS HW structures so we can use
it from within the core driver and from the IB driver too, e.g when
verbs DMFS structures are transformed into mlx4 hardware structs.

Also, add struct mlx4_flow_handle struct which will be of use by the
DMFS verbs flow in the IB driver.

Signed-off-by: Hadar Hen Zion 
Signed-off-by: Or Gerlitz 
Signed-off-by: Roland Dreier

mlx4_core: Directly expose fields of DMFS HW rule control segment

2013-04-25T00:51:29+00:00

Some of struct mlx4_net_trans_rule_hw_ctrl fields were packed into u32
and accessed through bit field operations.  Expose and access them
directly as u8 or u16.

Signed-off-by: Hadar Hen Zion 
Signed-off-by: Or Gerlitz 
Signed-off-by: Roland Dreier