commit 671b4b2ba9266cbcfe7210a704e9ea487dcaa988 upstream.

Many cards based on CY7C68300A/B/C use the USB ID 04b4:6830 but only the
B and C variants (EZ-USB AT2LP) support the ATA Command Block
functionality, according to the data sheets. The A variant (EZ-USB AT2)
locks up if ATACB is attempted, until a typical 30 seconds timeout runs
out and a USB reset is performed.

https://bugs.launchpad.net/bugs/428469

It seems that one way to spot a CY7C68300A (at least where the card
manufacturer left Cypress' EEPROM default vaules, against Cypress'
recommendations) is to look at the USB string descriptor indices.

A http://media.digikey.com/pdf/Data%20Sheets/Cypress%20PDFs/CY7C68300A.pdf
B http://www.farnell.com/datasheets/43456.pdf
C http://www.cypress.com/?rID=14189

Note that a CY7C68300B/C chip appears as CY7C68300A if it is running
in Backward Compatibility Mode, and if ATACB would be supported in this
case there is anyway no way to tell which chip it really is.

For 5 years my external USB drive has been locking up for half a minute
when plugged in and ata_id is run by udev, or anytime hdparm or similar
is run on it.

Finally looking at the /correct/ datasheet I think I found the reason. I
am aware the quirk in this patch is a bit hacky, but the hardware
manufacturers haven't made it easy for us.

Signed-off-by: Tormod Volden <debian.tormod@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 29f86e66428ee083aec106cca1748dc63d98ce23 upstream.

Device stucks on filesystem writes, unless following quirk is passed:
  echo 04e8:5136:m > /sys/module/usb_storage/parameters/quirks

Add corresponding entry to unusual_devs.h

Signed-off-by: Dmitry Artamonow <mad_soft@inbox.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit ab4b71644a26d1ab92b987b2fd30e17c25e89f85 upstream.

This reverts commit 200e0d99 ("USB: storage: optimize to match the
Huawei USB storage devices and support new switch command" and the
followup bugfix commit cd060956 ("USB: storage: properly handle
the endian issues of idProduct").

The commit effectively added a large number of Huawei devices to
the deprecated usb-storage mode switching logic.  Many of these
devices have been in use and supported by the userspace
usb_modeswitch utility for years.  Forcing the switching inside
the kernel causes a number of regressions as a result of ignoring
existing onfigurations, and also completely takes away the ability
to configure mode switching per device/system/user.

Known regressions caused by this:
 - Some of the devices support multiple modes, using different
  switching commands.  There are existing configurations taking
  advantage of this.

 - There is a real use case for disabling mode switching and
  instead mounting the exposed storage device. This becomes
  impossible with switching logic inside the usb-storage driver.

 - At least on device fail as a result of the usb-storage switching
  command, becoming completely unswitchable. This is possibly a
  firmware bug, but still a regression because the device work as
  expected using usb_modeswitch defaults.

In-kernel mode switching was deprecated years ago with the
development of the more user friendly userspace alternatives. The
existing list of devices in usb-storage was only kept to prevent
breaking already working systems.  The long term plan is to remove
the list, not to add to it. Ref:
http://permalink.gmane.org/gmane.linux.usb.general/28543

Signed-off-by: Bjørn Mork <bjorn@mork.no>
Cc: <fangxiaozhi@huawei.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 18e03310b5caa6d11c1a8c61b982c37047693fba upstream.

The current entry in unusual_cypress.h for the Super TOP SATA bridge devices
seems to be causing corruption on newer revisions of this device.  This has
been reported in Arch Linux and Fedora.  The original patch was tested on
devices with bcdDevice of 1.60, whereas the newer devices report bcdDevice
as 2.20.  Limit the UNUSUAL_DEV entry to devices less than 2.20.

This fixes https://bugzilla.redhat.com/show_bug.cgi?id=909591

The Arch Forum post on this is here:
	https://bbs.archlinux.org/viewtopic.php?id=152011

Reported-by: Carsten S. <carsteniq@yahoo.com>
Tested-by: Carsten S. <carsteniq@yahoo.com>
Signed-off-by: Josh Boyer <jwboyer@redhat.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit cd060956c5e97931c3909e4a808508469c0bb9f6 upstream.

1. The idProduct is little endian, so make sure its value to be
compatible with the current CPU. Make no break on big endian processors.

Signed-off-by: fangxiaozhi <huananhu@huawei.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

1. Optimize the match rules with new macro for Huawei USB storage devices,
   to avoid to load USB storage driver for the modem interface
   with Huawei devices.
2. Add to support new switch command for new Huawei USB dongles.

Signed-off-by: fangxiaozhi <huananhu@huawei.com>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

1. Define a new macro for USB storage match rules:
    matching with Vendor ID and interface descriptors.

Signed-off-by: fangxiaozhi <huananhu@huawei.com>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull trivial branch from Jiri Kosina:
 "Usual stuff -- comment/printk typo fixes, documentation updates, dead
  code elimination."

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial: (39 commits)
  HOWTO: fix double words typo
  x86 mtrr: fix comment typo in mtrr_bp_init
  propagate name change to comments in kernel source
  doc: Update the name of profiling based on sysfs
  treewide: Fix typos in various drivers
  treewide: Fix typos in various Kconfig
  wireless: mwifiex: Fix typo in wireless/mwifiex driver
  messages: i2o: Fix typo in messages/i2o
  scripts/kernel-doc: check that non-void fcts describe their return value
  Kernel-doc: Convention: Use a "Return" section to describe return values
  radeon: Fix typo and copy/paste error in comments
  doc: Remove unnecessary declarations from Documentation/accounting/getdelays.c
  various: Fix spelling of "asynchronous" in comments.
  Fix misspellings of "whether" in comments.
  eisa: Fix spelling of "asynchronous".
  various: Fix spelling of "registered" in comments.
  doc: fix quite a few typos within Documentation
  target: iscsi: fix comment typos in target/iscsi drivers
  treewide: fix typo of "suport" in various comments and Kconfig
  treewide: fix typo of "suppport" in various comments
  ...

Pull USB patches from Greg Kroah-Hartman:
 "Here's the big set of USB patches for 3.8-rc1.

  Lots of USB host driver cleanups in here, and a bit of a reorg of the
  EHCI driver to make it easier for the different EHCI platform drivers
  to all work together nicer, which was a reduction in overall code.  We
  also deleted some unused firmware files, and got rid of the very old
  file_storage usb gadget driver that had been broken for a long time.
  This means we ended up removing way more code than added, always a
  nice thing to see:
	 310 files changed, 3028 insertions(+), 10754 deletions(-)

  Other than that, the usual set of new device ids, driver fixes, gadget
  driver and controller updates and the like.

  All of these have been in the linux-next tree for a number of weeks.

  Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"

* tag 'usb-3.8-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb: (228 commits)
  USB: mark uas driver as BROKEN
  xhci: Add Lynx Point LP to list of Intel switchable hosts
  uwb: fix uwb_dev_unlock() missed at an error path in uwb_rc_cmd_async()
  USB: ftdi_sio: Add support for Newport AGILIS motor drivers
  MAINTAINERS: remove drivers/block/ub.c
  USB: chipidea: fix use after free bug
  ezusb: add dependency to USB
  usb: ftdi_sio: fixup BeagleBone A5+ quirk
  USB: cp210x: add Virtenio Preon32 device id
  usb: storage: remove redundant memset() in usb_probe_stor1()
  USB: option: blacklist network interface on Huawei E173
  USB: OHCI: workaround for hardware bug: retired TDs not added to the Done Queue
  USB: add new zte 3g-dongle's pid to option.c
  USB: opticon: switch to generic read implementation
  USB: opticon: refactor reab-urb processing
  USB: opticon: use usb-serial bulk-in urb
  USB: opticon: increase bulk-in size
  USB: opticon: use port as urb context
  USB: opticon: pass port to get_serial_info
  USB: opticon: make private data port specific
  ...

As reported https://bugzilla.kernel.org/show_bug.cgi?id=51031, the UAS
driver causes problems and has been asked to be not built into any of
the major distributions.  To prevent users from running into problems
with it, and for distros that were not notified, just mark the whole
thing as broken.

Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Acked-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>