This patch (as1444) adds an unusual_devs entry for an MP3 player from
Coby electronics.  The device has two nasty bugs.

Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Tested-by: Jasper Mackenzie <scarletpimpernal@hotmail.com>
Cc: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This device suffers from the off-by-one error when reporting the capacity,
so add entry with US_FL_FIX_CAPACITY.

Signed-off-by: Nick Holloway <Nick.Holloway@pyrites.org.uk>
Cc: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This patch (as1438) adds an unusual_devs entry for the MagicPixel
FW_Omega2 chip, used in the CamSport Evo camera.  The firmware
incorrectly reports a vendor-specific bDeviceClass.

Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Reported-by: <ttkspam@free.fr>
Cc: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

The TrekStor DataStation maxi g.u external hard drive enclosure uses a
JMicron USB to SATA chip which needs the US_FL_IGNORE_RESIDUE flag to work
properly.

Signed-off-by: Richard Schütz <r.schtz@t-online.de>
Cc: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

New device ID added for unusual Cypress ATACB device.

Signed-off-by: Richard Schütz <r.schtz@t-online.de>
Cc: stable <stable@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

This is to resolve the conflict in the file,
drivers/usb/gadget/composite.c that was due to a revert in Linus's tree
needed for the 2.6.37 release.

Reported-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

Add an unusual_devs entry for the Samsung YP-CP3 MP4 player.

User was getting the following errors in dmesg:
 usb 2-6: reset high speed USB device using ehci_hcd and address 2
 usb 2-6: reset high speed USB device using ehci_hcd and address 2
 usb 2-6: reset high speed USB device using ehci_hcd and address 2
 usb 2-6: USB disconnect, address 2
 sd 3:0:0:0: [sdb] Assuming drive cache: write through
 sdb:<2>ldm_validate_partition_table(): Disk read failed.
 Dev sdb: unable to read RDB block 0
  unable to read partition table

Signed-off-by: Vitaly Kuznetsov <vitty@altlinux.ru>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
CC: Matthew Dharm <mdharm-usb@one-eyed-alien.net>
CC: stable@kernel.org
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

* usb-next: (132 commits)
  USB: uas: Use GFP_NOIO instead of GFP_KERNEL in I/O submission path
  USB: uas: Ensure we only bind to a UAS interface
  USB: uas: Rename sense pipe and sense urb to status pipe and status urb
  USB: uas: Use kzalloc instead of kmalloc
  USB: uas: Fix up the Sense IU
  usb: musb: core: kill unneeded #include's
  DA8xx: assign name to MUSB IRQ resource
  usb: gadget: g_ncm added
  usb: gadget: f_ncm.c added
  usb: gadget: u_ether: prepare for NCM
  usb: pch_udc: Fix setup transfers with data out
  usb: pch_udc: Fix compile error, warnings and checkpatch warnings
  usb: add ab8500 usb transceiver driver
  USB: gadget: Implement runtime PM for MSM bus glue driver
  USB: gadget: Implement runtime PM for ci13xxx gadget
  USB: gadget: Add USB controller driver for MSM SoC
  USB: gadget: Introduce ci13xxx_udc_driver struct
  USB: gadget: Initialize ci13xxx gadget device's coherent DMA mask
  USB: gadget: Fix "scheduling while atomic" bugs in ci13xxx_udc
  USB: gadget: Separate out PCI bus code from ci13xxx_udc
  ...

If swap is on a UAS device, we could recurse into the driver by using
GFP_KERNEL.  Using GFP_NOIO ensures we won't.

Reported-by: James Bottomley <James.Bottomley@suse.de>
Signed-off-by: Matthew Wilcox <willy@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

While all existing UAS devices use alternate interface 1, this is not
guaranteed, and it has caused confusion with people trying to bind the
uas driver to non-uas devices.

Signed-off-by: Matthew Wilcox <willy@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>