commit a2fa6721c7237b5a666f16f732628c0c09c0b954 upstream.

The Elecom WDC-150SU2M uses this chip.

Reported-by: Hiroki Kondo <kompiro@gmail.com>
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 8626d524ef08f10fccc0c41e5f75aef8235edf47 upstream.

The stick is not recognized.
This dongle uses r8188eu but usb-id is missing.
3.16.0

Signed-off-by: Holger Paradies <retabell@gmx.de>
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit ec0a38bf8b28b036202070cf3ef271e343d9eafc upstream.

Fix two reported bugs, caused by et131x_adapter->phydev->addr being accessed
before it is initialised, by:

- letting et131x_mii_write() take a phydev address, instead of using the one
  stored in adapter by default. This is so et131x_mdio_write() can use it's own
  addr value.
- removing implementation of et131x_mdio_reset(), as it's not needed.
- moving a call to et131x_disable_phy_coma() in et131x_pci_setup(), which uses
  phydev->addr, until after the mdiobus has been registered.

Link: https://bugzilla.kernel.org/show_bug.cgi?id=80751
Link: https://bugzilla.kernel.org/show_bug.cgi?id=77121
Signed-off-by: Mark Einon <mark.einon@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit e409842a03b0c2c41c0959fef8a7563208af36c1 upstream.

The following patch fixes a build error on sparc32. I think it should go to
stable 3.16.

Remove a circular dependency on atomic.h header file which leads to compilation
failure on sparc32 as reported here:
http://kisskb.ellerman.id.au/kisskb/buildresult/11340509/

The specific dependency is as follows:

In file included from arch/sparc/include/asm/smp_32.h:24:0,
                 from arch/sparc/include/asm/smp.h:6,
                 from arch/sparc/include/asm/switch_to_32.h:4,
                 from arch/sparc/include/asm/switch_to.h:6,
                 from arch/sparc/include/asm/ptrace.h:84,
                 from arch/sparc/include/asm/processor_32.h:16,
                 from arch/sparc/include/asm/processor.h:6,
                 from arch/sparc/include/asm/barrier_32.h:4,
                 from arch/sparc/include/asm/barrier.h:6,
                 from arch/sparc/include/asm/atomic_32.h:17,
                 from arch/sparc/include/asm/atomic.h:6,
                 from drivers/staging/lustre/lustre/obdclass/class_obd.c:38

Signed-off-by: Pranith Kumar <bobby.prani@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull staging driver bugfixes from Greg KH:
 "Here are some tiny staging driver bugfixes that I've had in my tree
  for the past week that resolve some reported issues.  Nothing major at
  all, but it would be good to get them merged for 3.16-rc8 or -final"

* tag 'staging-3.16-rc8' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging:
  staging: vt6655: Fix disassociated messages every 10 seconds
  staging: vt6655: Fix Warning on boot handle_irq_event_percpu.
  staging: rtl8723au: rtw_resume(): release semaphore before exit on error
  iio:bma180: Missing check for frequency fractional part
  iio:bma180: Fix scale factors to report correct acceleration units
  iio: buffer: Fix demux table creation

byReAssocCount is incremented every second resulting in
disassociated message being send every 10 seconds whether
connection or not.

byReAssocCount should only advance while eCommandState
is in WLAN_ASSOCIATE_WAIT

Change existing scope to if condition.

Signed-off-by: Malcolm Priestley <tvboxspy@gmail.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

WARNING: CPU: 0 PID: 929 at /home/apw/COD/linux/kernel/irq/handle.c:147 handle_irq_event_percpu+0x1d1/0x1e0()
irq 17 handler device_intr+0x0/0xa80 [vt6655_stage] enabled interrupts

Using spin_lock_irqsave appears to fix this.

Signed-off-by: Malcolm Priestley <tvboxspy@gmail.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull media fixes from Mauro Carvalho Chehab:
 "A series of driver fixes:
   - fix DVB-S tuning with tda1071
   - fix tuner probe on af9035 when the device has a bad eeprom
   - some fixes for the new si2168/2157 drivers
   - one Kconfig build fix (for omap4iss)
   - fixes at vpif error path
   - don't lock saa7134 ioctl at driver's base core level, as it now
     uses V4L2 and VB2 locking schema
   - fix audio at hdpvr driver
   - fix the aspect ratio at the digital timings table
   - one new USB ID (at gspca_pac7302): Genius i-Look 317 webcam"

* 'v4l_for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media:
  [media] gspca_pac7302: Add new usb-id for Genius i-Look 317
  [media] tda10071: fix returned symbol rate calculation
  [media] tda10071: fix spec inversion reporting
  [media] tda10071: add missing DVB-S2/PSK-8 FEC AUTO
  [media] tda10071: force modulation to QPSK on DVB-S
  [media] hdpvr: fix two audio bugs
  [media] davinci: vpif: missing unlocks on error
  [media] af9035: override tuner id when bad value set into eeprom
  [media] saa7134: use unlocked_ioctl instead of ioctl
  [media] media: v4l2-core: v4l2-dv-timings.c: Cleaning up code wrong value used in aspect ratio
  [media] si2168: firmware download fix
  [media] si2157: add one missing parenthesis
  [media] si2168: add one missing parenthesis
  [media] staging: tighten omap4iss dependencies

Jonathan writes:

Second set of IIO fixes for the 3.16 cycle.

* A fix for a bug in setting threshold levels within the ad799x driver
  which prevents correct setting of the thresholds.
* In ad7291 fix an case where a ERR_PTR value was returned directly
  instead of having PTR_ERR applied.  Hence it would report success
  instead of failure.
* of_iio_channel_get_by_name returned a non null pointer if it fails
  and the callee was expecting NULL to indicate failure.  Fixed by
  returning NULL in the error cases.