linux-stable.git/drivers/spi, branch v5.2.20

spi: spi-fsl-dspi: Exit the ISR with IRQ_NONE when it's not ours

2019-10-05T11:14:05+00:00

commit d41f36a6464a85c06ad920703d878e4491d2c023 upstream.

The DSPI interrupt can be shared between two controllers at least on the
LX2160A. In that case, the driver for one controller might misbehave and
consume the other's interrupt. Fix this by actually checking if any of
the bits in the status register have been asserted.

Fixes: 13aed2392741 ("spi: spi-fsl-dspi: use IRQF_SHARED mode to request IRQ")
Signed-off-by: Vladimir Oltean 
Link: https://lore.kernel.org/r/20190822212450.21420-2-olteanv@gmail.com
Signed-off-by: Mark Brown 
Cc: stable@vger.kernel.org
Signed-off-by: Greg Kroah-Hartman

spi: dw-mmio: Clock should be shut when error occurs

2019-10-05T11:13:23+00:00

[ Upstream commit 3da9834d9381dd99273f2ad4e6d096c9187dc4f2 ]

When optional clock requesting fails, the main clock is still up and running,
we should shut it down in such caee.

Fixes: 560ee7e91009 ("spi: dw: Add support for an optional interface clock")
Cc: Phil Edworthy 
Cc: Gareth Williams 
Signed-off-by: Andy Shevchenko 
Reviewed-by: Gareth Williams 
Link: https://lore.kernel.org/r/20190710114243.30101-1-andriy.shevchenko@linux.intel.com
Signed-off-by: Mark Brown 
Signed-off-by: Sasha Levin

spi: pxa2xx: Add support for Intel Tiger Lake

2019-08-29T06:30:11+00:00

[ Upstream commit a4127952859a869cf3fc5a49547dbe2ffa2eac89 ]

Intel Tiger Lake -LP LPSS SPI controller is otherwise similar than
Cannon Lake but has more controllers and up to two chip selects per
controller.

Signed-off-by: Jarkko Nikula 
Link: https://lore.kernel.org/r/20190801134901.12635-1-jarkko.nikula@linux.intel.com
Signed-off-by: Mark Brown 
Signed-off-by: Sasha Levin

spi: pxa2xx: Balance runtime PM enable/disable on error

2019-08-29T06:29:53+00:00

[ Upstream commit 1274204542f683e1d8491ebe9cc86284d5a8ebcc ]

Don't undo the PM initialization if we error out before we managed to
initialize it. The call to pm_runtime_disable() without being preceded
by pm_runtime_enable() would disturb the balance of the Force.

In practice, this happens if we fail to allocate any of the GPIOS ("cs",
"ready") due to -EPROBE_DEFER because we're getting probled before the
GPIO driver.

Signed-off-by: Lubomir Rintel 
Link: https://lore.kernel.org/r/20190719122713.3444318-1-lkundrak@v3.sk
Signed-off-by: Mark Brown 
Signed-off-by: Sasha Levin

spi: bcm2835: Fix 3-wire mode if DMA is enabled

2019-08-09T15:51:49+00:00

commit 8d8bef50365847134b51c1ec46786bc2873e4e47 upstream.

Commit 6935224da248 ("spi: bcm2835: enable support of 3-wire mode")
added 3-wire support to the BCM2835 SPI driver by setting the REN bit
(Read Enable) in the CS register when receiving data.  The REN bit puts
the transmitter in high-impedance state.  The driver recognizes that
data is to be received by checking whether the rx_buf of a transfer is
non-NULL.

Commit 3ecd37edaa2a ("spi: bcm2835: enable dma modes for transfers
meeting certain conditions") subsequently broke 3-wire support because
it set the SPI_MASTER_MUST_RX flag which causes spi_map_msg() to replace
rx_buf with a dummy buffer if it is NULL.  As a result, rx_buf is
*always* non-NULL if DMA is enabled.

Reinstate 3-wire support by not only checking whether rx_buf is non-NULL,
but also checking that it is not the dummy buffer.

Fixes: 3ecd37edaa2a ("spi: bcm2835: enable dma modes for transfers meeting certain conditions")
Reported-by: Nuno Sá 
Signed-off-by: Lukas Wunner 
Cc: stable@vger.kernel.org # v4.2+
Cc: Martin Sperl 
Acked-by: Stefan Wahren 
Link: https://lore.kernel.org/r/328318841455e505370ef8ecad97b646c033dc8a.1562148527.git.lukas@wunner.de
Signed-off-by: Mark Brown 
Signed-off-by: Greg Kroah-Hartman

spi: fix ctrl->num_chipselect constraint

2019-07-26T07:10:31+00:00

[ Upstream commit f9481b08220d7dc1ff21e296a330ee8b721b44e4 ]

at91sam9g25ek showed the following error at probe:
atmel_spi f0000000.spi: Using dma0chan2 (tx) and dma0chan3 (rx)
for DMA transfers
atmel_spi: probe of f0000000.spi failed with error -22

Commit 0a919ae49223 ("spi: Don't call spi_get_gpio_descs() before device name is set")
moved the calling of spi_get_gpio_descs() after ctrl->dev is set,
but didn't move the !ctrl->num_chipselect check. When there are
chip selects in the device tree, the spi-atmel driver lets the
SPI core discover them when registering the SPI master.
The ctrl->num_chipselect is thus expected to be set by
spi_get_gpio_descs().

Move the !ctlr->num_chipselect after spi_get_gpio_descs() as it was
before the aforementioned commit. While touching this block, get rid
of the explicit comparison with 0 and update the commenting style.

Fixes: 0a919ae49223 ("spi: Don't call spi_get_gpio_descs() before device name is set")
Signed-off-by: Tudor Ambarus 
Signed-off-by: Mark Brown 
Signed-off-by: Sasha Levin

spi: rockchip: turn down tx dma bursts

2019-07-26T07:10:10+00:00

[ Upstream commit 47300728fb213486a830565d2af49da967c9d16a ]

This fixes tx and bi-directional dma transfers on rk3399-gru-kevin.

It seems the SPI fifo must have room for 2 bursts when the dma_tx_req
signal is generated or it might skip some words. This in turn makes
the rx dma channel never complete for bi-directional transfers.

Fix it by setting tx burst length to fifo_len / 4 and the dma
watermark to fifo_len / 2.

However the rk3399 TRM says (sic):
"DMAC support incrementing-address burst and fixed-address burst. But in
the case of access SPI and UART at byte or halfword size, DMAC only
support fixed-address burst and the address must be aligned to word."

So this relies on fifo_len being a multiple of 16 such that the
burst length (= fifo_len / 4) is a multiple of 4 and the addresses
will be word-aligned.

Fixes: dcfc861d24ec ("spi: rockchip: adjust dma watermark and burstlen")
Signed-off-by: Emil Renner Berthing 
Signed-off-by: Mark Brown 
Signed-off-by: Sasha Levin

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 500

2019-06-19T15:09:55+00:00

Based on 2 normalized pattern(s):

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license version 2 as
  published by the free software foundation

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license version 2 as
  published by the free software foundation #

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-only

has been chosen to replace the boilerplate/reference in 4122 file(s).

Signed-off-by: Thomas Gleixner 
Reviewed-by: Enrico Weigelt 
Reviewed-by: Kate Stewart 
Reviewed-by: Allison Randal 
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081206.933168790@linutronix.de
Signed-off-by: Greg Kroah-Hartman

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 489

2019-06-19T15:09:52+00:00

Based on 1 normalized pattern(s):

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license version 2 gpl
  v2 as published by the free software foundation this program is
  distributed in the hope that it will be useful but without any
  warranty without even the implied warranty of merchantability or
  fitness for a particular purpose see the gnu general public license
  for more details

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-only

has been chosen to replace the boilerplate/reference in 1 file(s).

Signed-off-by: Thomas Gleixner 
Reviewed-by: Allison Randal 
Reviewed-by: Enrico Weigelt 
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081205.495444859@linutronix.de
Signed-off-by: Greg Kroah-Hartman

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 459

2019-06-19T15:09:09+00:00

Based on 1 normalized pattern(s):

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license version 2 as
  published by the free software foundation the gpl this program is
  distributed in the hope that it will be useful but without any
  warranty without even the implied warranty of merchantability or
  fitness for a particular purpose see the gnu general public license
  version 2 gplv2 for more details you should have received a copy of
  the gnu general public license version 2 gplv2 along with this
  source code

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-only

has been chosen to replace the boilerplate/reference in 16 file(s).

Signed-off-by: Thomas Gleixner 
Reviewed-by: Enrico Weigelt 
Reviewed-by: Allison Randal 
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081201.771169395@linutronix.de
Signed-off-by: Greg Kroah-Hartman