Pull s390 fixes from Martin Schwidefsky:
 "A bug fix for the vdso code, the loadparm for booting from SCSI is
  added and the access permissions for the dasd module parameters are
  corrected"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/s390/linux:
  s390/vdso: remove NULL pointer check from clock_gettime
  s390/ipl: Add missing SCSI loadparm attributes to /sys/firmware
  s390/dasd: Make module parameter visible in sysfs

Pull networking fixes from David Miller:

 1) Fix skb leak in mac802154, from Martin Townsend

 2) Use select not depends on NF_NAT for NFT_NAT, from Pablo Neira
    Ayuso

 3) Fix union initializer bogosity in vxlan, from Gerhard Stenzel

 4) Fix RX checksum configuration in stmmac driver, from Giuseppe
    CAVALLARO

 5) Fix TSO with non-accelerated VLANs in e1000, e1000e, bna, ehea,
    i40e, i40evf, mvneta, and qlge, from Vlad Yasevich

 6) Fix capability checks in phy_init_eee(), from Giuseppe CAVALLARO

 7) Try high order allocations more sanely for SKBs, specifically if a
    high order allocation fails, fall back directly to zero order pages
    rather than iterating down one order at a time.  From Eric Dumazet

 8) Fix a memory leak in openvswitch, from Li RongQing

 9) amd-xgbe initializes wrong spinlock, from Thomas Lendacky

10) RTNL locking was busted in setsockopt for anycast and multicast, fix
    from Sabrina Dubroca

11) Fix peer address refcount leak in ipv6, from Nicolas Dichtel

12) DocBook typo fixes, from Masanari Iida

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (101 commits)
  ipv6: restore the behavior of ipv6_sock_ac_drop()
  amd-xgbe: Enable interrupts for all management counters
  amd-xgbe: Treat certain counter registers as 64 bit
  greth: moved TX ring cleaning to NAPI rx poll func
  cnic : Cleanup CONFIG_IPV6 & VLAN check
  net: treewide: Fix typo found in DocBook/networking.xml
  bnx2x: Fix link problems for 1G SFP RJ45 module
  3c59x: avoid panic in boomerang_start_xmit when finding page address:
  netfilter: add explicit Kconfig for NETFILTER_XT_NAT
  ipv6: use addrconf_get_prefix_route() to remove peer addr
  ipv6: fix a refcnt leak with peer addr
  net-timestamp: only report sw timestamp if reporting bit is set
  drivers/net/fddi/skfp/h/skfbi.h: Remove useless PCI_BASE_2ND macros
  l2tp: fix race while getting PMTU on PPP pseudo-wire
  ipv6: fix rtnl locking in setsockopt for anycast and multicast
  VMXNET3: Check for map error in vmxnet3_set_mc
  openvswitch: distinguish between the dropped and consumed skb
  amd-xgbe: Fix initialization of the wrong spin lock
  openvswitch: fix a memory leak
  netfilter: fix missing dependencies in NETFILTER_XT_TARGET_LOG
  ...

When qeth device is queried for ethtool data, hardware operation
is performed to extract the necessary information from the card.
If the card is not online at the moment (e.g. it is undergoing
recovery), this operation produces undesired effects like
temporarily freezing the system. This patch prevents execution
of the hardware query operation when the card is not online.
In such case, ioctl() operation returns error with errno ENODEV.

Reviewed-by: Ursula Braun <ursula.braun@de.ibm.com>
Signed-off-by: Eugene Crosser <Eugene.Crosser@ru.ibm.com>
Signed-off-by: Frank Blaschka <blaschka@linux.vnet.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Change the visibility of the dasd parameter of kernel module dasd_mod
to be consistent with the eer_pages parameter.

Signed-off-by: Peter Oberparleiter <oberpar@linux.vnet.ibm.com>
Acked-by: Stefan Weinhuber <wein@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>

The sclp line mode terminal driver scans the tty output for '\t',
there is no need to set the XTABS flag in c_oflag.

Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>

git commit 37f81fa1f63ad38e16125526bb2769ae0ea8d332
"n_tty: do O_ONLCR translation as a single write"
surfaced a bug in the 3215 device driver. In combination this
broke tab expansion for tty ouput.

The cause is an asymmetry in the behaviour of tty3215_ops->write
vs tty3215_ops->put_char. The put_char function scans for '\t'
but the write function does not.

As the driver has logic for the '\t' expansion remove XTABS
from c_oflag of the initial termios as well.

Reported-by: Stephen Powell <zlinuxman@wowway.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>

Pull s390 updates from Martin Schwidefsky:
 "Mostly cleanups and bug-fixes, with two exceptions.

  The first is lazy flushing of I/O-TLBs for PCI to improve performance,
  the second is software dirty bits in the pmd for the madvise-free
  implementation"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/s390/linux: (24 commits)
  s390/locking: Reenable optimistic spinning
  s390/mm: implement dirty bits for large segment table entries
  KVM: s390/mm: Fix page table locking vs. split pmd lock
  s390/dasd: fix camel case
  s390/3215: fix hanging console issue
  s390/irq: improve displayed interrupt order in /proc/interrupts
  s390/seccomp: fix error return for filtered system calls
  s390/pci: introduce lazy IOTLB flushing for DMA unmap
  dasd: fix error recovery for alias devices during format
  dasd: fix list_del corruption during format
  dasd: fix unresponsive device during format
  dasd: use aliases for formatted devices during format
  s390/pci: fix kmsg component
  s390/kdump: Return NOTIFY_OK for all actions other than MEM_GOING_OFFLINE
  s390/watchdog: Fix module name in Kconfig help text
  s390/dasd: replace seq_printf by seq_puts
  s390/dasd: replace pr_warning by pr_warn
  s390/dasd: Move EXPORT_SYMBOL after function/variable
  s390/dasd: remove unnecessary null test before debugfs_remove
  s390/zfcp: use qdio buffer helpers
  ...

Pull SCSI updates from James Bottomley:
 "This patch set consists of the usual driver updates (ufs, storvsc,
  pm8001 hpsa).  It also has removal of the user space target driver
  code (everyone is using LIO now), a partial PCI MSI-X update, more
  multi-queue updates, conversion to 64 bit LUNs (so we could
  theoretically cope with any LUN returned by a device) and placeholder
  support for the ZBC device type (Shingle drives), plus an assortment
  of minor updates and bug fixes"

* tag 'scsi-misc' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi: (143 commits)
  scsi: do not issue SCSI RSOC command to Promise Vtrak E610f
  vmw_pvscsi: Use pci_enable_msix_exact() instead of pci_enable_msix()
  pm8001: Fix invalid return when request_irq() failed
  lpfc: Remove superfluous call to pci_disable_msix()
  isci: Use pci_enable_msix_exact() instead of pci_enable_msix()
  bfa: Use pci_enable_msix_exact() instead of pci_enable_msix()
  bfa: Cleanup bfad_setup_intr() function
  bfa: Do not call pci_enable_msix() after it failed once
  fnic: Use pci_enable_msix_exact() instead of pci_enable_msix()
  scsi: use short driver name for per-driver cmd slab caches
  scsi_debug: support scsi-mq, queues and locks
  Drivers: add blist flags
  scsi: ufs: fix endianness sparse warnings
  scsi: ufs: make undeclared functions static
  bnx2i: Update driver version to 2.7.10.1
  pm8001: fix a memory leak in nvmd_resp
  pm8001: fix update_flash
  pm8001: fix a memory leak in flash_update
  pm8001: Cleaning up uninitialized variables
  pm8001: Fix to remove null pointer checks that could never happen
  ...

Rename enable_PAV to enable_pav.

Signed-off-by: Stefan Haberland <stefan.haberland@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>

The ccw_device_start in raw3215_start_io can fail. raw3215_try_io
does not check if the request could be started and removes any
pending timer. This can leave the system in a hanging state.
Check for pending request after raw3215_start_io and start a
timer if necessary.

Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>