linux-stable.git/drivers/pci, branch v3.13

Merge branches 'acpi-pci-pm' and 'acpi-pci-hotplug'

2013-12-31T21:03:37+00:00

* acpi-pci-pm:
  PCI / ACPI: Install wakeup notify handlers for all PCI devs with ACPI

* acpi-pci-hotplug:
  ACPIPHP / radeon / nouveau: Fix VGA switcheroo problem related to hotplug
  ACPI / PCI / hotplug: Avoid warning when _ADR not present

ACPIPHP / radeon / nouveau: Fix VGA switcheroo problem related to hotplug

2013-12-31T12:39:42+00:00

The changes in the ACPI-based PCI hotplug (ACPIPHP) subsystem made
during the 3.12 development cycle uncovered a problem with VGA
switcheroo that on some systems, when the device-specific method
(ATPX in the radeon case, _DSM in the nouveau case) is used to turn
off the discrete graphics, the BIOS generates ACPI hotplug events for
that device and those events cause ACPIPHP to attempt to remove the
device from the system (they are events for a device that was present
previously and is not present any more, so that's what should be done
according to the spec).  Then, the system stops functioning correctly.

Since the hotplug events in question were simply silently ignored
previously, the least intrusive way to address that problem is to
make ACPIPHP ignore them again.  For this purpose, introduce a new
ACPI device flag, no_hotplug, and modify ACPIPHP to ignore hotplug
events for PCI devices whose ACPI companions have that flag set.
Next, make the radeon and nouveau switcheroo detection code set the
no_hotplug flag for the discrete graphics' ACPI companion.

Fixes: bbd34fcdd1b2 (ACPI / hotplug / PCI: Register all devices under the given bridge)
References: https://bugzilla.kernel.org/show_bug.cgi?id=61891
References: https://bugzilla.kernel.org/show_bug.cgi?id=64891
Reported-and-tested-by: Mike Lothian 
Reported-and-tested-by: 
Reported-and-tested-by: Joaquín Aramendía 
Cc: Alex Deucher 
Cc: Dave Airlie 
Cc: Takashi Iwai 
Signed-off-by: Rafael J. Wysocki 
Cc: 3.12+  # 3.12+

PCI / ACPI: Install wakeup notify handlers for all PCI devs with ACPI

2013-12-29T22:37:15+00:00

It turns out that some BIOSes don't report wakeup GPEs through
_PRW, but use them for signaling wakeup anyway, which causes GPE
storms to occur on some systems after resume from system suspend.
This issue has been uncovered by commit d2e5f0c16ad6 (ACPI / PCI:
Rework the setup and cleanup of device wakeup) during the 3.9
development cycle.

Work around the problem by installing wakeup notify handlers for all
PCI devices with ACPI support (i.e. having ACPI companions) regardless
of whether or not the BIOS reports ACPI wakeup support for them.  The
presence of the wakeup notify handlers alone is not harmful in any
way if there are no events for them to handle (they are simply never
executed then), but on some systems they are needed to take care of
spurious events.

Fixes: d2e5f0c16ad6 (ACPI / PCI: Rework the setup and cleanup of device wakeup)
References: https://bugzilla.kernel.org/show_bug.cgi?id=63021
Reported-and-tested-by: Agustin Barto 
Cc: Bjorn Helgaas 
Signed-off-by: Rafael J. Wysocki

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2013-12-15T19:56:47+00:00

Pull networking fixes from David Miller:

 1) Revert CHECKSUM_COMPLETE optimization in pskb_trim_rcsum(), I can't
    figure out why it breaks things.

 2) Fix comparison in netfilter ipset's hash_netnet4_data_equal(), it
    was basically doing "x == x", from Dave Jones.

 3) Freescale FEC driver was DMA mapping the wrong number of bytes, from
    Sebastian Siewior.

 4) Blackhole and prohibit routes in ipv6 were not doing the right thing
    because their ->input and ->output methods were not being assigned
    correctly.  Now they behave properly like their ipv4 counterparts.
    From Kamala R.

 5) Several drivers advertise the NETIF_F_FRAGLIST capability, but
    really do not support this feature and will send garbage packets if
    fed fraglist SKBs.  From Eric Dumazet.

 6) Fix long standing user triggerable BUG_ON over loopback in RDS
    protocol stack, from Venkat Venkatsubra.

 7) Several not so common code paths can potentially try to invoke
    packet scheduler actions that might be NULL without checking.  Shore
    things up by either 1) defining a method as mandatory and erroring
    on registration if that method is NULL 2) defininig a method as
    optional and the registration function hooks up a default
    implementation when NULL is seen.  From Jamal Hadi Salim.

 8) Fix fragment detection in xen-natback driver, from Paul Durrant.

 9) Kill dangling enter_memory_pressure method in cg_proto ops, from
    Eric W Biederman.

10) SKBs that traverse namespaces should have their local_df cleared,
    from Hannes Frederic Sowa.

11) IOCB file position is not being updated by macvtap_aio_read() and
    tun_chr_aio_read().  From Zhi Yong Wu.

12) Don't free virtio_net netdev before releasing all of the NAPI
    instances.  From Andrey Vagin.

13) Procfs entry leak in xt_hashlimit, from Sergey Popovich.

14) IPv6 routes that are no cached routes should not count against the
    garbage collection limits.  We had this almost right, but were
    missing handling addrconf generated routes properly.  From Hannes
    Frederic Sowa.

15) fib{4,6}_rule_suppress() have to consider potentially seeing NULL
    route info when they are called, from Stefan Tomanek.

16) TUN and MACVTAP have had truncated packet signalling for some time,
    fix from Jason Wang.

17) Fix use after frrr in __udp4_lib_rcv(), from Eric Dumazet.

18) xen-netback does not interpret the NAPI budget properly for TX work,
    fix from Paul Durrant.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (132 commits)
  igb: Fix for issue where values could be too high for udelay function.
  i40e: fix null dereference
  xen-netback: fix gso_prefix check
  net: make neigh_priv_len in struct net_device 16bit instead of 8bit
  drivers: net: cpsw: fix for cpsw crash when build as modules
  xen-netback: napi: don't prematurely request a tx event
  xen-netback: napi: fix abuse of budget
  sch_tbf: use do_div() for 64-bit divide
  udp: ipv4: must add synchronization in udp_sk_rx_dst_set()
  net:fec: remove duplicate lines in comment about errata ERR006358
  Revert "8390 : Replace ei_debug with msg_enable/NETIF_MSG_* feature"
  8390 : Replace ei_debug with msg_enable/NETIF_MSG_* feature
  xen-netback: make sure skb linear area covers checksum field
  net: smc91x: Fix device tree based configuration so it's usable
  udp: ipv4: fix potential use after free in udp_v4_early_demux()
  macvtap: signal truncated packets
  tun: unbreak truncated packet signalling
  net: sched: htb: fix the calculation of quantum
  net: sched: tbf: fix the calculation of max_size
  micrel: add support for KSZ8041RNLI
  ...

Merge tag 'pci-v3.13-fixes-2' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci

2013-12-15T19:45:27+00:00

Pull PCI updates from Bjorn Helgaas:
 "PCI device hotplug
    - Move device_del() from pci_stop_dev() to pci_destroy_dev() (Rafael
      Wysocki)

  Host bridge drivers
    - Update maintainers for DesignWare, i.MX6, Armada, R-Car (Bjorn
      Helgaas)
    - mvebu: Return 'unsupported' for Interrupt Line and Interrupt Pin
      (Jason Gunthorpe)

  Miscellaneous
    - Avoid unnecessary CPU switch when calling .probe() (Alexander
      Duyck)
    - Revert "workqueue: allow work_on_cpu() to be called recursively"
      (Bjorn Helgaas)
    - Disable Bus Master only on kexec reboot (Khalid Aziz)
    - Omit PCI ID macro strings to shorten quirk names for LTO (Michal
      Marek)"

* tag 'pci-v3.13-fixes-2' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci:
  MAINTAINERS: Add DesignWare, i.MX6, Armada, R-Car PCI host maintainers
  PCI: Disable Bus Master only on kexec reboot
  PCI: mvebu: Return 'unsupported' for Interrupt Line and Interrupt Pin
  PCI: Omit PCI ID macro strings to shorten quirk names
  PCI: Move device_del() from pci_stop_dev() to pci_destroy_dev()
  Revert "workqueue: allow work_on_cpu() to be called recursively"
  PCI: Avoid unnecessary CPU switch when calling driver .probe() method

PCI: Disable Bus Master only on kexec reboot

2013-12-07T21:20:28+00:00

Add a flag to tell the PCI subsystem that kernel is shutting down in
preparation to kexec a kernel.  Add code in PCI subsystem to use this flag
to clear Bus Master bit on PCI devices only in case of kexec reboot.

This fixes a power-off problem on Acer Aspire V5-573G and likely other
machines and avoids any other issues caused by clearing Bus Master bit on
PCI devices in normal shutdown path.  The problem was introduced by
b566a22c2332 ("PCI: disable Bus Master on PCI device shutdown").

This patch is based on discussion at
http://marc.info/?l=linux-pci&m=138425645204355&w=2

Link: https://bugzilla.kernel.org/show_bug.cgi?id=63861
Reported-by: Chang Liu 
Signed-off-by: Khalid Aziz 
Signed-off-by: Bjorn Helgaas 
Acked-by: Konstantin Khlebnikov 
Cc: stable@vger.kernel.org	# v3.5+

PCI / tg3: Give up chip reset and carrier loss handling if PCI device is not present

2013-12-02T21:01:49+00:00

Modify tg3_chip_reset() and tg3_close() to check if the PCI network
adapter device is accessible at all in order to skip poking it or
trying to handle a carrier loss in vain when that's not the case.
Introduce a special PCI helper function pci_device_is_present()
for this purpose.

Of course, this uncovers the lack of the appropriate RTNL locking
in tg3_suspend() and tg3_resume(), so add that locking in there
too.

These changes prevent tg3 from burning a CPU at 100% load level for
solid several seconds after the Thunderbolt link is disconnected from
a Matrox DS1 docking station.

Signed-off-by: Rafael J. Wysocki 
Acked-by: Michael Chan 
Signed-off-by: David S. Miller

ACPI / PCI / hotplug: Avoid warning when _ADR not present

2013-11-28T13:19:29+00:00

acpiphp_enumerate_slots() walks ACPI namenamespace under
a PCI host bridge with callback register_slot().
register_slot() evaluates _ADR for all the device objects
and emits a warning message for any error.  Some platforms
have _HID device objects (such as HPET and IPMI), which
trigger unnecessary warning messages.

This patch avoids emitting a warning message when a target
device object does not have _ADR.

Signed-off-by: Toshi Kani 
Cc: 3.12+  # 3.12+
Signed-off-by: Rafael J. Wysocki

remove obsolete references to powertweak

2013-11-28T04:34:32+00:00

This tool hasn't been maintained in over a decade, and is pretty much
useless these days.  Let's pretend it never happened.

Also remove a long-dead email address.

Signed-off-by: Dave Jones 
Signed-off-by: Linus Torvalds

PCI: mvebu: Return 'unsupported' for Interrupt Line and Interrupt Pin

2013-11-26T18:27:28+00:00

The emulated bridge does not support interrupts, so it should return the
value 0 for Interrupt Line and Interrupt Pin.  This indicates that
interrupts are not supported.

Since Max_Lat and Min_Gnt are also in the same 32-bit word, we return
0 for them, which means "do not care."

This corrects an error message from the kernel:

  pci 0000:00:01.0: of_irq_parse_pci() failed with rc=135

Which is due to the default return of 0xFFFFFFFF indicating that
interrupts are supported.

The error message regression was caused by 16b84e5a505 ("of/irq: Create
of_irq_parse_and_map_pci() to consolidate arch code.")

Signed-off-by: Jason Gunthorpe 
Signed-off-by: Bjorn Helgaas 
Acked-by: Jason Cooper