Pull networking fixes from David Miller:
 "This looks like a lot but it's a mixture of regression fixes as well
  as fixes for longer standing issues.

   1) Fix on-channel cancellation in mac80211, from Johannes Berg.

   2) Handle CHECKSUM_COMPLETE properly in xt_TCPMSS netfilter xtables
      module, from Eric Dumazet.

   3) Avoid infinite loop in UDP SO_REUSEPORT logic, also from Eric
      Dumazet.

   4) Avoid a NULL deref if we try to set SO_REUSEPORT after a socket is
      bound, from Craig Gallek.

   5) GRO key comparisons don't take lightweight tunnels into account,
      from Jesse Gross.

   6) Fix struct pid leak via SCM credentials in AF_UNIX, from Eric
      Dumazet.

   7) We need to set the rtnl_link_ops of ipv6 SIT tunnels before we
      register them, otherwise the NEWLINK netlink message is missing
      the proper attributes.  From Thadeu Lima de Souza Cascardo.

   8) Several Spectrum chip bug fixes for mlxsw switch driver, from Ido
      Schimmel

   9) Handle fragments properly in ipv4 easly socket demux, from Eric
      Dumazet.

  10) Don't ignore the ifindex key specifier on ipv6 output route
      lookups, from Paolo Abeni"

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (128 commits)
  tcp: avoid cwnd undo after receiving ECN
  irda: fix a potential use-after-free in ircomm_param_request
  net: tg3: avoid uninitialized variable warning
  net: nb8800: avoid uninitialized variable warning
  net: vxge: avoid unused function warnings
  net: bgmac: clarify CONFIG_BCMA dependency
  net: hp100: remove unnecessary #ifdefs
  net: davinci_cpdma: use dma_addr_t for DMA address
  ipv6/udp: use sticky pktinfo egress ifindex on connect()
  ipv6: enforce flowi6_oif usage in ip6_dst_lookup_tail()
  netlink: not trim skb for mmaped socket when dump
  vxlan: fix a out of bounds access in __vxlan_find_mac
  net: dsa: mv88e6xxx: fix port VLAN maps
  fib_trie: Fix shift by 32 in fib_table_lookup
  net: moxart: use correct accessors for DMA memory
  ipv4: ipconfig: avoid unused ic_proto_used symbol
  bnxt_en: Fix crash in bnxt_free_tx_skbs() during tx timeout.
  bnxt_en: Exclude rx_drop_pkts hw counter from the stack's rx_dropped counter.
  bnxt_en: Ring free response from close path should use completion ring
  net_sched: drr: check for NULL pointer in drr_dequeue
  ...

Many AR913x based devices (maybe others too) do not have a valid EEPROM
magic in their calibration data partition.

Fixes: 6fa658fd5ab2 ("ath9k: Simplify and fix eeprom endianness swapping")
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Acked-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

Pull kbuild updates from Michal Marek:
 - Make <modname>-m in makefiles work like <modname>-y and fix the
   fallout
 - Minor genksyms fix
 - Fix race with make -j install modules_install
 - Move -Wsign-compare from make W=1 to W=2
 - Other minor fixes

* 'kbuild' of git://git.kernel.org/pub/scm/linux/kernel/git/mmarek/kbuild:
  kbuild: Demote 'sign-compare' warning to W=2
  Makefile: revert "Makefile: Document ability to make file.lst and file.S" partially
  kbuild: Do not run modules_install and install in paralel
  genksyms: Handle string literals with spaces in reference files
  fixdep: constify strrcmp arguments
  ath10k: Fix build with CONFIG_THERMAL=m
  Revert "drm: Hack around CONFIG_AGP=m build failures"
  kbuild: Allow to specify composite modules with modname-m
  staging/ad7606: Actually build the interface modules

Pull networking updates from Davic Miller:

 1) Support busy polling generically, for all NAPI drivers.  From Eric
    Dumazet.

 2) Add byte/packet counter support to nft_ct, from Floriani Westphal.

 3) Add RSS/XPS support to mvneta driver, from Gregory Clement.

 4) Implement IPV6_HDRINCL socket option for raw sockets, from Hannes
    Frederic Sowa.

 5) Add support for T6 adapter to cxgb4 driver, from Hariprasad Shenai.

 6) Add support for VLAN device bridging to mlxsw switch driver, from
    Ido Schimmel.

 7) Add driver for Netronome NFP4000/NFP6000, from Jakub Kicinski.

 8) Provide hwmon interface to mlxsw switch driver, from Jiri Pirko.

 9) Reorganize wireless drivers into per-vendor directories just like we
    do for ethernet drivers.  From Kalle Valo.

10) Provide a way for administrators "destroy" connected sockets via the
    SOCK_DESTROY socket netlink diag operation.  From Lorenzo Colitti.

11) Add support to add/remove multicast routes via netlink, from Nikolay
    Aleksandrov.

12) Make TCP keepalive settings per-namespace, from Nikolay Borisov.

13) Add forwarding and packet duplication facilities to nf_tables, from
    Pablo Neira Ayuso.

14) Dead route support in MPLS, from Roopa Prabhu.

15) TSO support for thunderx chips, from Sunil Goutham.

16) Add driver for IBM's System i/p VNIC protocol, from Thomas Falcon.

17) Rationalize, consolidate, and more completely document the checksum
    offloading facilities in the networking stack.  From Tom Herbert.

18) Support aborting an ongoing scan in mac80211/cfg80211, from
    Vidyullatha Kanchanapally.

19) Use per-bucket spinlock for bpf hash facility, from Tom Leiming.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1375 commits)
  net: bnxt: always return values from _bnxt_get_max_rings
  net: bpf: reject invalid shifts
  phonet: properly unshare skbs in phonet_rcv()
  dwc_eth_qos: Fix dma address for multi-fragment skbs
  phy: remove an unneeded condition
  mdio: remove an unneed condition
  mdio_bus: NULL dereference on allocation error
  net: Fix typo in netdev_intersect_features
  net: freescale: mac-fec: Fix build error from phy_device API change
  net: freescale: ucc_geth: Fix build error from phy_device API change
  bonding: Prevent IPv6 link local address on enslaved devices
  IB/mlx5: Add flow steering support
  net/mlx5_core: Export flow steering API
  net/mlx5_core: Make ipv4/ipv6 location more clear
  net/mlx5_core: Enable flow steering support for the IB driver
  net/mlx5_core: Initialize namespaces only when supported by device
  net/mlx5_core: Set priority attributes
  net/mlx5_core: Connect flow tables
  net/mlx5_core: Introduce modify flow table command
  net/mlx5_core: Managing root flow table
  ...

Per comments from Bjorn Andersson <bjorn.andersson@sonymobile.com>,
split DMA mask register writing as seperate patch in case we need
bi-sect in the furture.

Signed-off-by: Fengwei Yin <fengwei.yin@linaro.org>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

Lawrence reported that git clone could make system crash on a
Qualcomm ARM soc based device (DragonBoard, 1G memory without
swap) running 64bit Debian.

It's turned out the crash is related with rx skb allocation
failure. git could consume more than 600MB anonymous memory.
And system is in extremely memory shortage case.

But driver didn't handle the rx allocation failure case. This patch
doesn't submit skb to upper layer if rx skb allocation fails.
Instead, it reuse the old skb for rx DMA again. It's more like
drop the packets if system is in memory shortage case.

With this change, git clone is OOMed instead of system crash.

Reported-by: King, Lawrence <lking@qti.qualcomm.com>
Signed-off-by: Fengwei Yin <fengwei.yin@linaro.org>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

There is a type bug so it always returns success.

Fixes: 6fa658fd5ab2 ('ath9k: Simplify and fix eeprom endianness swapping')
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

Ath9k driver does not modify tx skbs, so SUPPORTS_CLONED_SKBS
flag can be set. Enabling this flag significant reduce number
of copy operation during TCP Tx. This is especially noticeable
on platforms with slower CPU (lower CPU usage brings
profits in better TCP Tx troughput results).

Tested on MIPS with 560 MHz clock
Without CLONED_SKBS flag:
TCP Tx 145 Mb/s (iperf result)
__copy_user_common consumes 12.9% of CPU (result from perf tool)
0% CPU Idle

With CLONED_SKBS flag:
TCP Tx 170 Mb/s (iperf result)
__copy_user_common consumes 1.8% of CPU (result from perf tool)
12% CPU Idle

Signed-off-by: Pawel Kulakowski <pawel.kulakowski@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

Added a simple interface for platform to perform crash
recovery.
When firmware crashes, wil driver can notify the platform
which can trigger a crash recovery process. During
the process the platform can request a ram dump
from the wil driver as well as control when firmware
recovery will start. This interface allows the platform
to implement a more advanced crash recovery, for
example to reset dependent subsystems in proper order, or
to provide its own notifications during the recovery process.

Signed-off-by: Lior David <qca_liord@qca.qualcomm.com>
Signed-off-by: Maya Erez <qca_merez@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

When network interface is stopping, some resources may
be already released by the network stack, and Rx frames
cause kernel OOPS (observed one is in netfilter code)

Proper solution is to drop packets pending in reorder buffer.

Signed-off-by: Hamad Kadmany <qca_hkadmany@qca.qualcomm.com>
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: Maya Erez <qca_merez@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>