linux-stable.git/drivers/net/usb, branch v5.5

r8152: disable DelayPhyPwrChg

2020-01-23T10:20:57+00:00

When enabling this, the device would wait an internal signal which
wouldn't be triggered. Then, the device couldn't enter P3 mode, so
the power consumption is increased.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: avoid the MCU to clear the lanwake

2020-01-23T10:20:57+00:00

Avoid the MCU to clear the lanwake after suspending. It may cause the
WOL fail. Disable LANWAKE_CLR_EN before suspending. Besides,enable it
and reset the lanwake status when resuming or initializing.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: don't enable U1U2 with USB_SPEED_HIGH for RTL8153B

2020-01-23T10:20:57+00:00

For certain platforms, it causes USB reset periodically.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: disable test IO for RTL8153B

2020-01-23T10:20:57+00:00

For RTL8153B with QFN32, disable test IO. Otherwise, it may cause
abnormal behavior for the device randomly.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: Disable PLA MCU clock speed down

2020-01-23T10:20:57+00:00

PLA MCU clock speed down could only be enabled when tx/rx are disabled.
Otherwise, the packet loss may occur.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: disable U2P3 for RTL8153B

2020-01-23T10:20:57+00:00

Enable U2P3 may miss zero packet for bulk-in.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: get default setting of WOL before initializing

2020-01-23T10:20:57+00:00

Initailization would reset runtime suspend by tp->saved_wolopts, so
the tp->saved_wolopts should be set before initializing.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: reset flow control patch when linking on for RTL8153B

2020-01-23T10:20:57+00:00

When linking ON, the patch of flow control has to be reset. This
makes sure the patch works normally.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

r8152: fix runtime resume for linking change

2020-01-23T10:20:57+00:00

Fix the runtime resume doesn't work normally for linking change.

1. Reset the settings and status of runtime suspend.
2. Sync the linking status.
3. Poll the linking change.

Signed-off-by: Hayes Wang 
Signed-off-by: David S. Miller

net: usb: lan78xx: Add .ndo_features_check

2020-01-21T09:46:51+00:00

As reported by Eric Dumazet, there are still some outstanding
cases where the driver does not handle TSO correctly when skb's
are over a certain size. Most cases have been fixed, this patch
should ensure that forwarded SKB's that are greater than
MAX_SINGLE_PACKET_SIZE - TX_OVERHEAD are software segmented
and handled correctly.

Signed-off-by: James Hughes 
Reviewed-by: Eric Dumazet 
Signed-off-by: David S. Miller