linux-stable.git/drivers/net/usb, branch v5.0

r8152: Fix an error on RTL8153-BD MAC Address Passthrough support

2019-02-22T19:36:55+00:00

RTL8153-BD is used in Dell DA300 type-C dongle.
Added RTL8153-BD support to activate MAC address pass through on DA300.
Apply correction on previously submitted patch in net.git tree.

Signed-off-by: David Chen 
Signed-off-by: David S. Miller

r8152: Add support for MAC address pass through on RTL8153-BD

2019-02-19T00:37:40+00:00

RTL8153-BD is used in Dell DA300 type-C dongle.
It should be added to the whitelist of devices to activate MAC address
pass through.

Per confirming with Realtek all devices containing RTL8153-BD should
activate MAC pass through and there won't use pass through bit on efuse
like in RTL8153-AD.

Signed-off-by: David Chen 
Signed-off-by: David S. Miller

qmi_wwan: apply SET_DTR quirk to Sierra WP7607

2019-02-17T23:40:27+00:00

The 1199:68C0 USB ID is reused by Sierra WP7607 which requires the DTR
quirk to be detected. Apply QMI_QUIRK_SET_DTR unconditionally as
already done for other IDs shared between different devices.

Signed-off-by: Beniamino Galvani 
Acked-by: Bjørn Mork 
Signed-off-by: David S. Miller

net: usb: asix: ax88772_bind return error when hw_reset fail

2019-01-25T06:33:11+00:00

The ax88772_bind() should return error code immediately when the PHY
was not reset properly through ax88772a_hw_reset().
Otherwise, The asix_get_phyid() will block when get the PHY
Identifier from the PHYSID1 MII registers through asix_mdio_read()
due to the PHY isn't ready. Furthermore, it will produce a lot of
error message cause system crash.As follows:
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
 reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to send
 software reset: ffffffb9
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
 reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to enable
 software MII access
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to read
 reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
 reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to enable
 software MII access
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to read
 reg index 0x0000: -71
...

Signed-off-by: Zhang Run 
Reviewed-by: Yang Wei 
Tested-by: Marcel Ziswiler 
Signed-off-by: David S. Miller

net: usb: aqc111: Extend HWID table by TRENDnet device

2019-01-16T21:32:42+00:00

New device of TRENDnet based on aqc111u
Add this ID to blacklist of cdc_ether driver as well

Signed-off-by: Dmitry Bezrukov 
Signed-off-by: Igor Russkikh 
Signed-off-by: David S. Miller

cdc_ether: trivial whitespace readability fix

2019-01-07T16:33:18+00:00

This function is unreadable enough without indenting mismatches
and unnecessary line breaks.

Signed-off-by: Bjørn Mork 
Signed-off-by: David S. Miller

qmi_wwan: add MTU default to qmap network interface

2019-01-04T21:35:42+00:00

This patch adds MTU default value to qmap network interface in
order to avoid "RTNETLINK answers: No buffer space available"
error when setting an ipv6 address.

Signed-off-by: Daniele Palmas 
Acked-by: Bjørn Mork 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2018-12-21T23:06:20+00:00

qmi_wwan: Fix qmap header retrieval in qmimux_rx_fixup

2018-12-21T18:58:45+00:00

This patch fixes qmap header retrieval when modem is configured for
dl data aggregation.

Signed-off-by: Daniele Palmas 
Signed-off-by: David S. Miller

qmi_wwan: Add support for Fibocom NL678 series

2018-12-21T18:51:21+00:00

Added support for Fibocom NL678 series cellular module QMI interface.
Using QMI_QUIRK_SET_DTR required for Qualcomm MDM9x40 series chipsets.

Signed-off-by: Jörgen Storvist 
Signed-off-by: David S. Miller