linux-stable.git/drivers/net/phy/Makefile, branch linux-3.13.y

phy: Add MOXA MDIO driver

2013-11-07T20:37:09+00:00

The MOXA UC-711X hardware(s) has an ethernet controller that seem
to be developed internally. The IC used is "RTL8201CP".

This patch adds an MDIO driver which handles the MII bus.

Signed-off-by: Jonas Jensen 
Signed-off-by: David S. Miller

net: Add MDIO bus driver for the Allwinner EMAC

2013-06-01T00:23:07+00:00

This patch adds a separate driver for the MDIO interface of the
Allwinner ethernet controllers.

Signed-off-by: Maxime Ripard 
Tested-by: Richard Genoud 
Signed-off-by: David S. Miller

phy: add AT803x driver

2012-10-18T19:34:30+00:00

This driver add support for wake over lan on AT803x phys.

Signed-off-by: Matus Ujhelyi 
Signed-off-by: David S. Miller

netdev/phy: add MDIO bus multiplexer driven by a memory-mapped device

2012-08-30T16:54:48+00:00

Add support for an MDIO bus multiplexer controlled by a simple memory-mapped
device, like an FPGA.  The device must be memory-mapped and contain only
8-bit registers (which keeps things simple).

Tested on a Freescale P5020DS board which uses the "PIXIS" FPGA attached
to the localbus.

Signed-off-by: Timur Tabi 
Signed-off-by: David S. Miller

netdev/phy: Add driver for Broadcom BCM87XX 10G Ethernet PHYs

2012-06-28T04:23:25+00:00

Add a driver for BCM8706 and BCM8727 devices.  These are a 10Gig PHYs
which use MII_ADDR_C45 addressing.  They are always 10G full duplex, so
there is no autonegotiation.  All we do is report link state and send
interrupts when it changes.

If the PHY has a device tree of_node associated with it, the
"broadcom,c45-reg-init" property is used to supply register
initialization values when config_init() is called.

Signed-off-by: David Daney 
Signed-off-by: David S. Miller

netdev/of/phy: Add MDIO bus multiplexer driven by GPIO lines.

2012-05-08T02:58:09+00:00

The GPIO pins select which sub bus is connected to the master.

Initially tested with an sn74cbtlv3253 switch device wired into the
MDIO bus.

Signed-off-by: David Daney 
Signed-off-by: David S. Miller

netdev/of/phy: Add MDIO bus multiplexer support.

2012-05-08T02:58:09+00:00

This patch adds a somewhat generic framework for MDIO bus
multiplexers.  It is modeled on the I2C multiplexer.

The multiplexer is needed if there are multiple PHYs with the same
address connected to the same MDIO bus adepter, or if there is
insufficient electrical drive capability for all the connected PHY
devices.

Conceptually it could look something like this:

                   ------------------
                   | Control Signal |
                   --------+---------
                           |
 ---------------   --------+------
 | MDIO MASTER |---| Multiplexer |
 ---------------   --+-------+----
                     |       |
                     C       C
                     h       h
                     i       i
                     l       l
                     d       d
                     |       |
     ---------       A       B   ---------
     |       |       |       |   |       |
     | PHY@1 +-------+       +---+ PHY@1 |
     |       |       |       |   |       |
     ---------       |       |   ---------
     ---------       |       |   ---------
     |       |       |       |   |       |
     | PHY@2 +-------+       +---+ PHY@2 |
     |       |                   |       |
     ---------                   ---------

This framework configures the bus topology from device tree data.  The
mechanics of switching the multiplexer is left to device specific
drivers.

The follow-on patch contains a multiplexer driven by GPIO lines.

Signed-off-by: David Daney 
Signed-off-by: David S. Miller

phy: add am79c874 PHY support

2012-03-19T22:02:05+00:00

Signed-off-by: Heiko Schocher 
Signed-off-by: Anatolij Gustschin 
Signed-off-by: David S. Miller

phy: Micrel KS8995MA 5-ports 10/100 managed Ethernet switch support added

2011-12-19T21:30:40+00:00

Signed-off-by: Gabor Juhos 
Signed-off-by: Frederic Lambert 
Signed-off-by: David S. Miller

ptp: Added a clock driver for the National Semiconductor PHYTER.

2011-05-23T20:10:23+00:00

This patch adds support for the PTP clock found on the DP83640.
The basic clock operations and one external time stamp have
been implemented.

Signed-off-by: Richard Cochran 
Signed-off-by: John Stultz