linux-stable.git/drivers/net/bonding, branch v4.2.4

bonding: Gratuitous ARP gets dropped when first slave added

2015-08-12T21:37:33+00:00

When the first slave is added (such as during bootup) the first
gratuitous ARP gets dropped. We don't see this drop during a failover.
The packet gets dropped in qdisc (noop_enqueue).

The fix is to delay the sending of gratuitous ARPs till the bond dev's
carrier is present.

It can also be worked around by setting num_grat_arp to more than 1.

Signed-off-by: Venkat Venkatsubra 
Signed-off-by: David S. Miller

bonding: correct the MAC address for "follow" fail_over_mac policy

2015-07-21T03:29:40+00:00

The "follow" fail_over_mac policy is useful for multiport devices that
either become confused or incur a performance penalty when multiple
ports are programmed with the same MAC address, but the same MAC
address still may happened by this steps for this policy:

1) echo +eth0 > /sys/class/net/bond0/bonding/slaves
   bond0 has the same mac address with eth0, it is MAC1.

2) echo +eth1 > /sys/class/net/bond0/bonding/slaves
   eth1 is backup, eth1 has MAC2.

3) ifconfig eth0 down
   eth1 became active slave, bond will swap MAC for eth0 and eth1,
   so eth1 has MAC1, and eth0 has MAC2.

4) ifconfig eth1 down
   there is no active slave, and eth1 still has MAC1, eth2 has MAC2.

5) ifconfig eth0 up
   the eth0 became active slave again, the bond set eth0 to MAC1.

Something wrong here, then if you set eth1 up, the eth0 and eth1 will have the same
MAC address, it will break this policy for ACTIVE_BACKUP mode.

This patch will fix this problem by finding the old active slave and
swap them MAC address before change active slave.

Signed-off-by: Ding Tianhong 
Tested-by: Nikolay Aleksandrov 
Signed-off-by: David S. Miller

bonding: correctly handle bonding type change on enslave failure

2015-07-20T23:23:06+00:00

If the bond is enslaving a device with different type it will be setup
by it, but if after being setup the enslave fails the bond doesn't
switch back its type and also keeps pointers to foreign structures that can
be long gone. Thus revert back any type changes if the enslave failed and
the bond had to change its type.
Example:
 Before patch:
$ echo lo > bond0/bonding/slaves
-bash: echo: write error: Cannot assign requested address
$ ip l sh bond0
20: bond0:  mtu 1500 qdisc noop state DOWN
mode DEFAULT group default
    link/loopback 16:54:78:34:bd:41 brd 00:00:00:00:00:00
$ echo +eth1 > bond0/bonding/slaves
$ ip l sh bond0
20: bond0:  mtu 1500 qdisc noop state DOWN mode
DEFAULT group default qlen 1000
    link/ether 52:54:00:3f:47:69 brd ff:ff:ff:ff:ff:ff
(notice the MASTER flag is gone)

 After patch:
$ echo lo > bond0/bonding/slaves
-bash: echo: write error: Cannot assign requested address
$ ip l sh bond0
21: bond0:  mtu 1500 qdisc noop state DOWN
mode DEFAULT group default qlen 1000
    link/ether 6e:66:94:f6:07:fc brd ff:ff:ff:ff:ff:ff
$ echo +eth1 > bond0/bonding/slaves
$ ip l sh bond0
21: bond0:  mtu 1500 qdisc noop state DOWN
mode DEFAULT group default qlen 1000
    link/ether 52:54:00:3f:47:69 brd ff:ff:ff:ff:ff:ff

Signed-off-by: Nikolay Aleksandrov 
Fixes: e36b9d16c6a6 ("bonding: clean muticast addresses when device changes type")
Signed-off-by: David S. Miller

bonding: fix destruction of bond with devices different from arphrd_ether

2015-07-20T19:56:11+00:00

When the bonding is being unloaded and the netdevice notifier is
unregistered it executes NETDEV_UNREGISTER for each device which should
remove the bond's proc entry but if the device enslaved is not of
ARPHRD_ETHER type and is in front of the bonding, it may execute
bond_release_and_destroy() first which would release the last slave and
destroy the bond device leaving the proc entry and thus we will get the
following error (with dynamic debug on for bond_netdev_event to see the
events order):
[  908.963051] eql: event: 9
[  908.963052] eql: IFF_SLAVE
[  908.963054] eql: event: 2
[  908.963056] eql: IFF_SLAVE
[  908.963058] eql: event: 6
[  908.963059] eql: IFF_SLAVE
[  908.963110] bond0: Releasing active interface eql
[  908.976168] bond0: Destroying bond bond0
[  908.976266] bond0 (unregistering): Released all slaves
[  908.984097] ------------[ cut here ]------------
[  908.984107] WARNING: CPU: 0 PID: 1787 at fs/proc/generic.c:575
remove_proc_entry+0x112/0x160()
[  908.984110] remove_proc_entry: removing non-empty directory
'net/bonding', leaking at least 'bond0'
[  908.984111] Modules linked in: bonding(-) eql(O) 9p nfsd auth_rpcgss
oid_registry nfs_acl nfs lockd grace fscache sunrpc crct10dif_pclmul
crc32_pclmul crc32c_intel ghash_clmulni_intel ppdev qxl drm_kms_helper
snd_hda_codec_generic aesni_intel ttm aes_x86_64 glue_helper pcspkr lrw
gf128mul ablk_helper cryptd snd_hda_intel virtio_console snd_hda_codec
psmouse serio_raw snd_hwdep snd_hda_core 9pnet_virtio 9pnet evdev joydev
drm virtio_balloon snd_pcm snd_timer snd soundcore i2c_piix4 i2c_core
pvpanic acpi_cpufreq parport_pc parport processor thermal_sys button
autofs4 ext4 crc16 mbcache jbd2 hid_generic usbhid hid sg sr_mod cdrom
ata_generic virtio_blk virtio_net floppy ata_piix e1000 libata ehci_pci
virtio_pci scsi_mod uhci_hcd ehci_hcd virtio_ring virtio usbcore
usb_common [last unloaded: bonding]

[  908.984168] CPU: 0 PID: 1787 Comm: rmmod Tainted: G        W  O
4.2.0-rc2+ #8
[  908.984170] Hardware name: Bochs Bochs, BIOS Bochs 01/01/2011
[  908.984172]  0000000000000000 ffffffff81732d41 ffffffff81525b34
ffff8800358dfda8
[  908.984175]  ffffffff8106c521 ffff88003595af78 ffff88003595af40
ffff88003e3a4280
[  908.984178]  ffffffffa058d040 0000000000000000 ffffffff8106c59a
ffffffff8172ebd0
[  908.984181] Call Trace:
[  908.984188]  [] ? dump_stack+0x40/0x50
[  908.984193]  [] ? warn_slowpath_common+0x81/0xb0
[  908.984196]  [] ? warn_slowpath_fmt+0x4a/0x50
[  908.984199]  [] ? remove_proc_entry+0x112/0x160
[  908.984205]  [] ? bond_destroy_proc_dir+0x26/0x30
[bonding]
[  908.984208]  [] ? bond_net_exit+0x8e/0xa0 [bonding]
[  908.984217]  [] ? ops_exit_list.isra.4+0x37/0x70
[  908.984225]  [] ?
unregister_pernet_operations+0x8d/0xd0
[  908.984228]  [] ?
unregister_pernet_subsys+0x1d/0x30
[  908.984232]  [] ? bonding_exit+0x23/0xdba [bonding]
[  908.984236]  [] ? SyS_delete_module+0x18a/0x250
[  908.984241]  [] ? task_work_run+0x89/0xc0
[  908.984244]  [] ?
entry_SYSCALL_64_fastpath+0x16/0x75
[  908.984247] ---[ end trace 7c006ed4abbef24b ]---

Thus remove the proc entry manually if bond_release_and_destroy() is
used. Because of the checks in bond_remove_proc_entry() it's not a
problem for a bond device to change namespaces (the bug fixed by the
Fixes commit) but since commit
f9399814927ad ("bonding: Don't allow bond devices to change network
namespaces.") that can't happen anyway.

Reported-by: Carol Soto 
Signed-off-by: Nikolay Aleksandrov 
Fixes: a64d49c3dd50 ("bonding: Manage /proc/net/bonding/ entries from
                      the netdev events")
Tested-by: Carol L Soto 
Signed-off-by: David S. Miller

bonding: "primary_reselect" with "failure" is not working properly

2015-07-08T23:06:08+00:00

When "primary_reselect" is set to "failure", primary interface should
not become active until current active slave is down. But if we set first
member of bond device as a "primary" interface and "primary_reselect"
is set to "failure" then whenever primary interface's link get back(up)
it become active slave even if current active slave is still up.

With this patch, "bond_find_best_slave" will not traverse members if
primary interface is not candidate for failover/reselection and current
active slave is still up.

Signed-off-by: Mazhar Rana 
Signed-off-by: Jay Vosburgh 
Signed-off-by: Jay Vosburgh 
Signed-off-by: David S. Miller

bonding: Display LACP info only to CAP_NET_ADMIN capable user

2015-06-23T10:11:52+00:00

Actor and Partner details can be accessed via proc-fs, sys-fs
entries or netlink interface. These interfaces are world readable
at this moment. The earlier patch-series made the LACP communication
secure to avoid nuisance attack from within the same L2 domain but
it did not prevent "someone unprivileged" looking at that information
on host and perform the same act.

This patch essentially avoids spitting those entries if the user
in question does not have enough privileges.

Signed-off-by: Mahesh Bandewar 
Signed-off-by: Andy Gospodarek 
Signed-off-by: David S. Miller

bonding: export slave's partner_oper_port_state via sysfs and netlink

2015-06-15T23:40:24+00:00

Export the partner_oper_port_state of each port via sysfs and netlink.
In 802.3ad mode it is valuable for the user to be able to check the
partner_oper state, it is already exported via bond's proc entry.

Signed-off-by: Nikolay Aleksandrov 
Signed-off-by: Andy Gospodarek 
Signed-off-by: David S. Miller

bonding: export slave's actor_oper_port_state via sysfs and netlink

2015-06-15T23:40:24+00:00

Export the actor_oper_port_state of each port via sysfs and netlink.
In 802.3ad mode it is valuable for the user to be able to check the
actor_oper state, it is already exported via bond's proc entry.

Signed-off-by: Nikolay Aleksandrov 
Signed-off-by: Andy Gospodarek 
Signed-off-by: David S. Miller

net: Add full IPv6 addresses to flow_keys

2015-06-04T22:44:30+00:00

This patch adds full IPv6 addresses into flow_keys and uses them as
input to the flow hash function. The implementation supports either
IPv4 or IPv6 addresses in a union, and selector is used to determine
how may words to input to jhash2.

We also add flow_get_u32_dst and flow_get_u32_src functions which are
used to get a u32 representation of the source and destination
addresses. For IPv6, ipv6_addr_hash is called. These functions retain
getting the legacy values of src and dst in flow_keys.

With this patch, Ethertype and IP protocol are now included in the
flow hash input.

Signed-off-by: Tom Herbert 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2015-05-23T05:22:35+00:00

Conflicts:
	drivers/net/ethernet/cadence/macb.c
	drivers/net/phy/phy.c
	include/linux/skbuff.h
	net/ipv4/tcp.c
	net/switchdev/switchdev.c

Switchdev was a case of RTNH_H_{EXTERNAL --> OFFLOAD}
renaming overlapping with net-next changes of various
sorts.

phy.c was a case of two changes, one adding a local
variable to a function whilst the second was removing
one.

tcp.c overlapped a deadlock fix with the addition of new tcp_info
statistic values.

macb.c involved the addition of two zyncq device entries.

skbuff.h involved adding back ipv4_daddr to nf_bridge_info
whilst net-next changes put two other existing members of
that struct into a union.

Signed-off-by: David S. Miller