linux-stable.git/drivers/net/bonding, branch linux-4.8.y

bonding: Fix bonding crash

2016-09-04T18:41:12+00:00

Following few steps will crash kernel -

  (a) Create bonding master
      > modprobe bonding miimon=50
  (b) Create macvlan bridge on eth2
      > ip link add link eth2 dev mvl0 address aa:0:0:0:0:01 \
	   type macvlan
  (c) Now try adding eth2 into the bond
      > echo +eth2 > /sys/class/net/bond0/bonding/slaves
      

Bonding does lots of things before checking if the device enslaved is
busy or not.

In this case when the notifier call-chain sends notifications, the
bond_netdev_event() assumes that the rx_handler /rx_handler_data is
registered while the bond_enslave() hasn't progressed far enough to
register rx_handler for the new slave.

This patch adds a rx_handler check that can be performed right at the
beginning of the enslave code to avoid getting into this situation.

Signed-off-by: Mahesh Bandewar 
Acked-by: Eric Dumazet 
Signed-off-by: David S. Miller

bonding: fix the typo

2016-08-09T21:57:14+00:00

The message "803.ad" should be "802.3ad".

Signed-off-by: Zhu Yanjun 
Signed-off-by: David S. Miller

net/bonding: Enforce active-backup policy for IPoIB bonds

2016-07-25T17:18:58+00:00

When using an IPoIB bond currently only active-backup mode is a valid
use case and this commit strengthens it.

Since commit 2ab82852a270 ("net/bonding: Enable bonding to enslave
netdevices not supporting set_mac_address()") was introduced till
4.7-rc1, IPoIB didn't support the set_mac_address ndo, and hence the
fail over mac policy always applied to IPoIB bonds.

With the introduction of commit 492a7e67ff83 ("IB/IPoIB: Allow setting
the device address"), that doesn't hold and practically IPoIB bonds are
broken as of that. To fix it, lets go to fail over mac if the device
doesn't support the ndo OR this is IPoIB device.

As a by-product, this commit also prevents a stack corruption which
occurred when trying to copy 20 bytes (IPoIB) device address
to a sockaddr struct that has only 16 bytes of storage.

Signed-off-by: Mark Bloch 
Signed-off-by: Or Gerlitz 
Signed-off-by: Saeed Mahameed 
Acked-by: Andy Gospodarek 
Signed-off-by: Jay Vosburgh 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-07-24T04:53:32+00:00

Just several instances of overlapping changes.

Signed-off-by: David S. Miller

bonding: set carrier off for devices created through netlink

2016-07-14T23:17:43+00:00

Commit e826eafa65c6 ("bonding: Call netif_carrier_off after
register_netdevice") moved netif_carrier_off() from bond_init() to
bond_create(), but the latter is called only for initial default
devices and ones created through sysfs:

 $ modprobe bonding
 $ echo +bond1 > /sys/class/net/bonding_masters
 $ ip link add bond2 type bond
 $ grep "MII Status" /proc/net/bonding/*
 /proc/net/bonding/bond0:MII Status: down
 /proc/net/bonding/bond1:MII Status: down
 /proc/net/bonding/bond2:MII Status: up

Ensure that carrier is initially off also for devices created through
netlink.

Signed-off-by: Beniamino Galvani 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-07-06T17:35:22+00:00

Conflicts:
	drivers/net/ethernet/mellanox/mlx5/core/en.h
	drivers/net/ethernet/mellanox/mlx5/core/en_main.c
	drivers/net/usb/r8152.c

All three conflicts were overlapping changes.

Signed-off-by: David S. Miller

bonding: fix enslavement slave link notifications

2016-07-05T18:51:55+00:00

Currently, link notifications are not sent by
bond_set_slave_link_state() upon enslavement if
the slave is enslaved when up.

This happens because slave->link default init value
is 0, which is the same as BOND_LINK_UP, resulting
in bond_set_slave_link_state() ignoring this transition.

This patch sets the default value of slave->link to
BOND_LINK_NOCHANGE, assuring it will count as a state
transition and thus trigger notification logic.

Signed-off-by: Aviv Heller 
Reviewed-by: Jiri Pirko 
Signed-off-by: Saeed Mahameed 
Signed-off-by: David S. Miller

net: introduce default neigh_construct/destroy ndo calls for L2 upper devices

2016-07-05T16:06:28+00:00

L2 upper device needs to propagate neigh_construct/destroy calls down to
lower devices. Do this by defining default ndo functions and use them in
team, bond, bridge and vlan.

Signed-off-by: Jiri Pirko 
Reviewed-by: Ido Schimmel 
Signed-off-by: David S. Miller

bonding: prevent out of bound accesses

2016-07-01T10:06:09+00:00

ether_addr_equal_64bits() requires some care about its arguments,
namely that 8 bytes might be read, even if last 2 byte values are not
used.

KASan detected a violation with null_mac_addr and lacpdu_mcast_addr
in bond_3ad.c

Same problem with mac_bcast[] and mac_v6_allmcast[] in bond_alb.c :
Although the 8-byte alignment was there, KASan would detect out
of bound accesses.

Fixes: 815117adaf5b ("bonding: use ether_addr_equal_unaligned for bond addr compare")
Fixes: bb54e58929f3 ("bonding: Verify RX LACPDU has proper dest mac-addr")
Fixes: 885a136c52a8 ("bonding: use compare_ether_addr_64bits() in ALB")
Signed-off-by: Eric Dumazet 
Reported-by: Dmitry Vyukov 
Acked-by: Dmitry Vyukov 
Acked-by: Nikolay Aleksandrov 
Acked-by: Ding Tianhong 
Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2016-06-30T09:03:36+00:00

Several cases of overlapping changes, except the packet scheduler
conflicts which deal with the addition of the free list parameter
to qdisc_enqueue().

Signed-off-by: David S. Miller