This loop intends to retry a max of 10 times, with some implicit
termination based on the SD_{R,}OCR_S18A bit. Unfortunately, the
termination condition depends on the value reported by the SD card
(*rocr), which may or may not correctly reflect what we asked it to do.

Needless to say, it's not wise to rely on the card doing what we expect;
we should at least terminate the loop regardless. So, check both the
input and output values, so we ensure we will terminate regardless of
the SD card behavior.

Note that SDIO learned a similar retry loop in commit 0797e5f1453b
("mmc: core: Fixup signal voltage switch"), but that used the 'ocr'
result, and so the current pre-terminating condition looks like:

    rocr & ocr & R4_18V_PRESENT

(i.e., it doesn't have the same bug.)

This addresses a number of crash reports seen on ChromeOS that look
like the following:

    ... // lots of repeated: ...
    <4>[13142.846061] mmc1: Skipping voltage switch
    <4>[13143.406087] mmc1: Skipping voltage switch
    <4>[13143.964724] mmc1: Skipping voltage switch
    <4>[13144.526089] mmc1: Skipping voltage switch
    <4>[13145.086088] mmc1: Skipping voltage switch
    <4>[13145.645941] mmc1: Skipping voltage switch
    <3>[13146.153969] INFO: task halt:30352 blocked for more than 122 seconds.
    ...

Fixes: f2119df6b764 ("mmc: sd: add support for signal voltage switch procedure")
Cc: <stable@vger.kernel.org>
Signed-off-by: Brian Norris <briannorris@chromium.org>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20220914014010.2076169-1-briannorris@chromium.org
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

If re-initialization results is a different signal voltage, because the
voltage switch failed previously, but not this time (or vice versa), then
sd3_bus_mode will be inconsistent with the card because the SD_SWITCH
command is done only upon first initialization.

Fix by always reading SD_SWITCH information during re-initialization, which
also means it does not need to be re-read later for the 1.8V fixup
workaround.

Note, brief testing showed SD_SWITCH took about 1.8ms to 2ms which added
about 1% to 1.5% to the re-initialization time, so it's not particularly
significant.

Reported-by: Seunghui Lee <sh043.lee@samsung.com>
Signed-off-by: Adrian Hunter <adrian.hunter@intel.com>
Reviewed-by: Seunghui Lee <sh043.lee@samsung.com>
Tested-by: Seunghui Lee <sh043.lee@samsung.com>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20220815073321.63382-3-adrian.hunter@intel.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

When introduced, upon success, the 1.8V fixup workaround in
mmc_sd_init_card() would branch to practically the end of the function, to
a label named "done". Unfortunately, perhaps due to the label name, over
time new code has been added that really should have come after "done" not
before it. Let's fix the problem by moving the label to the correct place
and rename it "cont".

Fixes: 045d705dc1fb ("mmc: core: Enable the MMC host software queue for the SD card")
Signed-off-by: Adrian Hunter <adrian.hunter@intel.com>
Reviewed-by: Seunghui Lee <sh043.lee@samsung.com>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20220815073321.63382-2-adrian.hunter@intel.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

Pull MMC updates from Ulf Hansson:
 "MMC core:
   - Add support for the asynchronous SDIO wakeup interrupts
   - Skip redundant evaluation of eMMC HS400 caps when no-MMC-cap
   - Add support to store error stats from host drivers
   - Extend debugfs to show error stats from host drivers
   - Add single I/O read support in the recovery path for 4k sector cards

  MMC host:
   - dw_mmc-exynos: Convert corresponding DT bindings to the dtschema
   - dw_mmc-rockchip: Add support for the Rockchip RV1126 variant
   - mmc_spi: Convert corresponding DT bindings to the dtschema
   - mtk-sd: Extend support for interrupts/pinctrls for SDIO low-power mode
   - mtk-sd: Add support for SDIO wake irqs
   - mtk-sd: Add support for the Mediatek MT8188 variant
   - renesas_sdhi: Drop redundant manual tap correction for newer SoCs
   - renesas_sdhi: Add support for the R-Car S4-8 and generic Gen4 variants
   - sdhci/cqhci: Add support to capture stats from host errors
   - sdhci-brcmstb: Add ability to increase max clock rate for SDIO on 72116b0
   - sdhci-msm: Add support for the MSM8998 and SM8450 variant
   - sdhci-of-at91: Fixup UHS-I mode by rewriting of MC1R
   - sdhci-of-dwcmshc: Add support for the Rockchip rk3588 variant
   - sdhci-of-dwcmshc: Enable reset support for the Rockchip variants
   - sdhci-pci-gli: Improve I/O read/write performance for GL9763E
   - sdhci-s3c: Convert corresponding DT bindings to the dtschema
   - tmio: Avoid glitches when resetting

  MEMSTICK core:
   - A couple of minor fixes and cleanups"

* tag 'mmc-v5.20' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (61 commits)
  mmc: mediatek: add support for SDIO eint wakup IRQ
  mmc: core: Add support for SDIO wakeup interrupt
  dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties
  dt-bindings: mmc: rockchip-dw-mshc: Document Rockchip RV1126
  mmc: renesas_sdhi: newer SoCs don't need manual tap correction
  mmc: cavium-thunderx: Add of_node_put() when breaking out of loop
  mmc: cavium-octeon: Add of_node_put() when breaking out of loop
  mmc: core: quirks: Add of_node_put() when breaking out of loop
  mmc: sdhci-brcmstb: use clk_get_rate(base_clk) in PM resume
  dt-bindings: mmc: sdhci-msm: Document the SM8450 compatible
  mmc: sdhci-msm: drop redundant of_device_id entries
  dt-bindings: mmc: sdhci-msm: add MSM8998
  mmc: block: Add single read for 4k sector cards
  mmc: mxcmmc: Use mmc_card_sdio macro
  mmc: core: Use mmc_card_* macro and add a new for the sd_combo type
  dt-bindings: mmc: sdhci-msm: constrain reg-names per variants
  dt-bindings: mmc: sdhci-msm: fix reg-names entries
  dt-bindings: mmc: Add compatible for MediaTek MT8188
  dt-bindings: mmc: sdhci-msm: document resets
  mmc: sdhci-of-at91: fix set_uhs_signaling rewriting of MC1R
  ...

If wakeup-source flag is set in host dts node, parse EAI information
from SDIO CCCR interrupt externsion segment for in-band wakeup. If
async interrupt is supported by SDIO card then enable it and set
enable_async_irq flag in sdio_cccr structure to 1. The parse flow is
implemented in sdio_read_cccr().

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Axe Yang <axe.yang@mediatek.com>
Link: https://lore.kernel.org/r/20220726062842.18846-3-axe.yang@mediatek.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

In mmc_fixup_of_compatible_match(), we should call of_node_put()
when breaking out of for_each_child_of_node() which will increase
and decrease the refcount during one iteration.

Fixes: b360b1102670 ("mmc: core: allow to match the device tree to apply quirks")
Signed-off-by: Liang He <windhl@126.com>
Link: https://lore.kernel.org/r/20220719091051.1210806-1-windhl@126.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

In case of adding disk failure, the disk needs to be released, otherwise
disk/queue is leaked.

Signed-off-by: Ming Lei <ming.lei@redhat.com>
Link: https://lore.kernel.org/r/20220718160851.312972-1-ming.lei@redhat.com
Signed-off-by: Jens Axboe <axboe@kernel.dk>

Cards with 4k native sector size may only be read 4k-aligned,
accommodate for this in the single read recovery and use it.

Fixes: 81196976ed946 (mmc: block: Add blk-mq support)
Signed-off-by: Christian Loehle <cloehle@hyperstone.com>
Acked-by: Adrian Hunter <adrian.hunter@intel.com>
Reviewed-by: Avri Altman <avri.altman@wdc.com>
Link: https://lore.kernel.org/r/cf4f316274c5474586d0d99b17db4a4c@hyperstone.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

Add mmc_card_sd_combo() macro for sd combo type card and use the mmc_card_*
macro to simplify code instead of comparing card->type.

Signed-off-by: Seunghui Lee <sh043.lee@samsung.com>
Link: https://lore.kernel.org/r/20220713033635.28432-2-sh043.lee@samsung.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

SD_ROCR_S18A is already defined and is used to check the rocr value, so
let's replace with already defined values for readability.

Signed-off-by: ChanWoo Lee <cw9316.lee@samsung.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20220706004840.24812-1-cw9316.lee@samsung.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>