linux-stable.git/drivers/mmc/core/queue.c, branch linux-5.14.y

mmc: switch to blk_mq_alloc_disk

2021-06-30T21:34:04+00:00

Use the blk_mq_alloc_disk to allocate the request_queue and gendisk
together.

Signed-off-by: Christoph Hellwig 
Reviewed-by: Ulf Hansson 
Link: https://lore.kernel.org/r/20210616053934.880951-3-hch@lst.de
Signed-off-by: Jens Axboe

mmc: core: Remove mq->use_cqe from the struct mmc_queue

2021-03-30T09:42:02+00:00

The host->cqe_enabled is already containing the needed information about
whether the CQE is enabled or not, hence there is no need to keep another
copy of it around.

Signed-off-by: Luca Porzio 
Signed-off-by: Zhan Liu 
Link: https://lore.kernel.org/r/20210215003217.GA12240@lupo-laptop
Signed-off-by: Ulf Hansson

mmc: queue: Remove unused define

2021-02-08T11:56:52+00:00

MMC_CQE_QUEUE_FULL is not set and is only cleared.
Therefore, define is unnecessary.

Signed-off-by: ChanWoo Lee 
Acked-by: Adrian Hunter 
Link: https://lore.kernel.org/r/20210203072014.30272-1-cw9316.lee@samsung.com
Signed-off-by: Ulf Hansson

mmc: core: Exclude unnecessary header file

2021-02-01T11:02:34+00:00

From the 4.19 kernel, thread related code has been removed in queue.c.
So we can exclude unnecessary header file.

Signed-off-by: ChanWoo Lee 
Acked-by: Coly Li 
Link: https://lore.kernel.org/r/20210125064355.28545-1-cw9316.lee@samsung.com
Signed-off-by: Ulf Hansson

mmc: core: Add basic support for inline encryption

2021-02-01T11:02:33+00:00

In preparation for adding CQHCI crypto engine (inline encryption)
support, add the code required to make mmc_core and mmc_block aware of
inline encryption.  Specifically:

- Add a capability flag MMC_CAP2_CRYPTO to struct mmc_host.  Drivers
  will set this if the host and driver support inline encryption.

- Embed a blk_keyslot_manager in struct mmc_host.  Drivers will
  initialize this (as a device-managed resource) if the host and driver
  support inline encryption.  mmc_block registers this keyslot manager
  with the request_queue of any MMC card attached to the host.

- Make mmc_block copy the crypto keyslot and crypto data unit number
  from struct request to struct mmc_request, so that drivers will have
  access to them.

- If the MMC host is reset, reprogram all the keyslots to ensure that
  the software state stays in sync with the hardware state.

Co-developed-by: Satya Tangirala 
Signed-off-by: Satya Tangirala 
Acked-by: Adrian Hunter 
Reviewed-by: Satya Tangirala 
Reviewed-and-tested-by: Peng Zhou 
Signed-off-by: Eric Biggers 
Link: https://lore.kernel.org/r/20210126001456.382989-2-ebiggers@kernel.org
Signed-off-by: Ulf Hansson

mmc: core: don't initialize block size from ext_csd if not present

2021-01-15T11:09:15+00:00

If extended CSD was not available, the eMMC driver would incorrectly
set the block size to 0, as the data_sector_size field of ext_csd
was never initialized. This issue was exposed by commit 817046ecddbc
("block: Align max_hw_sectors to logical blocksize") which caused
max_sectors and max_hw_sectors to be set to 0 after setting the block
size to 0, resulting in a kernel panic in bio_split when attempting
to read from the device. Fix it by only reading the block size from
ext_csd if it is available.

Fixes: a5075eb94837 ("mmc: block: Allow disabling 512B sector size emulation")
Signed-off-by: Peter Collingbourne 
Reviewed-by: Damien Le Moal 
Link: https://linux-review.googlesource.com/id/If244d178da4d86b52034459438fec295b02d6e60
Acked-by: Adrian Hunter 
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20210114201405.2934886-1-pcc@google.com
Signed-off-by: Ulf Hansson

Merge tag 'block-5.10-2020-10-12' of git://git.kernel.dk/linux-block

2020-10-13T19:12:44+00:00

Pull block updates from Jens Axboe:

 - Series of merge handling cleanups (Baolin, Christoph)

 - Series of blk-throttle fixes and cleanups (Baolin)

 - Series cleaning up BDI, seperating the block device from the
   backing_dev_info (Christoph)

 - Removal of bdget() as a generic API (Christoph)

 - Removal of blkdev_get() as a generic API (Christoph)

 - Cleanup of is-partition checks (Christoph)

 - Series reworking disk revalidation (Christoph)

 - Series cleaning up bio flags (Christoph)

 - bio crypt fixes (Eric)

 - IO stats inflight tweak (Gabriel)

 - blk-mq tags fixes (Hannes)

 - Buffer invalidation fixes (Jan)

 - Allow soft limits for zone append (Johannes)

 - Shared tag set improvements (John, Kashyap)

 - Allow IOPRIO_CLASS_RT for CAP_SYS_NICE (Khazhismel)

 - DM no-wait support (Mike, Konstantin)

 - Request allocation improvements (Ming)

 - Allow md/dm/bcache to use IO stat helpers (Song)

 - Series improving blk-iocost (Tejun)

 - Various cleanups (Geert, Damien, Danny, Julia, Tetsuo, Tian, Wang,
   Xianting, Yang, Yufen, yangerkun)

* tag 'block-5.10-2020-10-12' of git://git.kernel.dk/linux-block: (191 commits)
  block: fix uapi blkzoned.h comments
  blk-mq: move cancel of hctx->run_work to the front of blk_exit_queue
  blk-mq: get rid of the dead flush handle code path
  block: get rid of unnecessary local variable
  block: fix comment and add lockdep assert
  blk-mq: use helper function to test hw stopped
  block: use helper function to test queue register
  block: remove redundant mq check
  block: invoke blk_mq_exit_sched no matter whether have .exit_sched
  percpu_ref: don't refer to ref->data if it isn't allocated
  block: ratelimit handle_bad_sector() message
  blk-throttle: Re-use the throtl_set_slice_end()
  blk-throttle: Open code __throtl_de/enqueue_tg()
  blk-throttle: Move service tree validation out of the throtl_rb_first()
  blk-throttle: Move the list operation after list validation
  blk-throttle: Fix IO hang for a corner case
  blk-throttle: Avoid tracking latency if low limit is invalid
  blk-throttle: Avoid getting the current time if tg->last_finish_time is 0
  blk-throttle: Remove a meaningless parameter for throtl_downgrade_state()
  block: Remove redundant 'return' statement
  ...

mmc: core: don't set limits.discard_granularity as 0

2020-10-09T06:26:09+00:00

In mmc_queue_setup_discard() the mmc driver queue's discard_granularity
might be set as 0 (when card->pref_erase > max_discard) while the mmc
device still declares to support discard operation. This is buggy and
triggered the following kernel warning message,

WARNING: CPU: 0 PID: 135 at __blkdev_issue_discard+0x200/0x294
CPU: 0 PID: 135 Comm: f2fs_discard-17 Not tainted 5.9.0-rc6 #1
Hardware name: Google Kevin (DT)
pstate: 00000005 (nzcv daif -PAN -UAO BTYPE=--)
pc : __blkdev_issue_discard+0x200/0x294
lr : __blkdev_issue_discard+0x54/0x294
sp : ffff800011dd3b10
x29: ffff800011dd3b10 x28: 0000000000000000 x27: ffff800011dd3cc4 x26: ffff800011dd3e18 x25: 000000000004e69b x24: 0000000000000c40 x23: ffff0000f1deaaf0 x22: ffff0000f2849200 x21: 00000000002734d8 x20: 0000000000000008 x19: 0000000000000000 x18: 0000000000000000 x17: 0000000000000000 x16: 0000000000000000 x15: 0000000000000000 x14: 0000000000000394 x13: 0000000000000000 x12: 0000000000000000 x11: 0000000000000000 x10: 00000000000008b0 x9 : ffff800011dd3cb0 x8 : 000000000004e69b x7 : 0000000000000000 x6 : ffff0000f1926400 x5 : ffff0000f1940800 x4 : 0000000000000000 x3 : 0000000000000c40 x2 : 0000000000000008 x1 : 00000000002734d8 x0 : 0000000000000000 Call trace:
__blkdev_issue_discard+0x200/0x294
__submit_discard_cmd+0x128/0x374
__issue_discard_cmd_orderly+0x188/0x244
__issue_discard_cmd+0x2e8/0x33c
issue_discard_thread+0xe8/0x2f0
kthread+0x11c/0x120
ret_from_fork+0x10/0x1c
---[ end trace e4c8023d33dfe77a ]---

This patch fixes the issue by setting discard_granularity as SECTOR_SIZE
instead of 0 when (card->pref_erase > max_discard) is true. Now no more
complain from __blkdev_issue_discard() for the improper value of discard
granularity.

This issue is exposed after commit b35fd7422c2f ("block: check queue's
limits.discard_granularity in __blkdev_issue_discard()"), a "Fixes:" tag
is also added for the commit to make sure people won't miss this patch
after applying the change of __blkdev_issue_discard().

Fixes: e056a1b5b67b ("mmc: queue: let host controllers specify maximum discard timeout")
Fixes: b35fd7422c2f ("block: check queue's limits.discard_granularity in __blkdev_issue_discard()").
Reported-and-tested-by: Vicente Bergas 
Signed-off-by: Coly Li 
Acked-by: Adrian Hunter 
Cc: Ulf Hansson 
Link: https://lore.kernel.org/r/20201002013852.51968-1-colyli@suse.de
Signed-off-by: Ulf Hansson

bdi: replace BDI_CAP_STABLE_WRITES with a queue and a sb flag

2020-09-24T19:43:39+00:00

The BDI_CAP_STABLE_WRITES is one of the few bits of information in the
backing_dev_info shared between the block drivers and the writeback code.
To help untangling the dependency replace it with a queue flag and a
superblock flag derived from it.  This also helps with the case of e.g.
a file system requiring stable writes due to its own checksumming, but
not forcing it on other users of the block device like the swap code.

One downside is that we an't support the stable_pages_required bdi
attribute in sysfs anymore.  It is replaced with a queue attribute which
also is writable for easier testing.

Signed-off-by: Christoph Hellwig 
Reviewed-by: Jan Kara 
Reviewed-by: Johannes Thumshirn 
Signed-off-by: Jens Axboe

mmc: core: Correct misspelling of 'mq' in mmc_init_request()'s docs

2020-07-13T10:18:25+00:00

Correcting this misspelling squashes the following W=1 build warning(s):

 mmc/core/queue.c:212: warning: Function parameter or member 'mq' not described in '__mmc_init_request'
 mmc/core/queue.c:212: warning: Excess function parameter 'q' description in '__mmc_init_request'

Signed-off-by: Lee Jones 
Link: https://lore.kernel.org/r/20200701124702.908713-8-lee.jones@linaro.org
Signed-off-by: Ulf Hansson