linux-stable.git/drivers/md/md.c, branch v5.3

Merge branch 'for-5.3' of git://git.kernel.org/pub/scm/linux/kernel/git/dennis/percpu

2019-07-14T23:17:18+00:00

Pull percpu updates from Dennis Zhou:
 "This includes changes to let percpu_ref release the backing percpu
  memory earlier after it has been switched to atomic in cases where the
  percpu ref is not revived.

  This will help recycle percpu memory earlier in cases where the
  refcounts are pinned for prolonged periods of time"

* 'for-5.3' of git://git.kernel.org/pub/scm/linux/kernel/git/dennis/percpu:
  percpu_ref: release percpu memory early without PERCPU_REF_ALLOW_REINIT
  md: initialize percpu refcounters using PERCU_REF_ALLOW_REINIT
  io_uring: initialize percpu refcounters using PERCU_REF_ALLOW_REINIT
  percpu_ref: introduce PERCPU_REF_ALLOW_REINIT flag

Merge tag 'v5.2-rc6' into for-5.3/block

2019-07-01T14:16:08+00:00

Merge 5.2-rc6 into for-5.3/block, so we get the same page merge leak
fix. Otherwise we end up having conflicts with future patches between
for-5.3/block and master that touch this area. In particular, it makes
the bio_full() fix hard to backport to stable.

* tag 'v5.2-rc6': (482 commits)
  Linux 5.2-rc6
  Revert "iommu/vt-d: Fix lock inversion between iommu->lock and device_domain_lock"
  Bluetooth: Fix regression with minimum encryption key size alignment
  tcp: refine memory limit test in tcp_fragment()
  x86/vdso: Prevent segfaults due to hoisted vclock reads
  SUNRPC: Fix a credential refcount leak
  Revert "SUNRPC: Declare RPC timers as TIMER_DEFERRABLE"
  net :sunrpc :clnt :Fix xps refcount imbalance on the error path
  NFS4: Only set creation opendata if O_CREAT
  ARM: 8867/1: vdso: pass --be8 to linker if necessary
  KVM: nVMX: reorganize initial steps of vmx_set_nested_state
  KVM: PPC: Book3S HV: Invalidate ERAT when flushing guest TLB entries
  habanalabs: use u64_to_user_ptr() for reading user pointers
  nfsd: replace Jeff by Chuck as nfsd co-maintainer
  inet: clear num_timeout reqsk_alloc()
  PCI/P2PDMA: Ignore root complex whitelist when an IOMMU is present
  net: mvpp2: debugfs: Add pmap to fs dump
  ipv6: Default fib6_type to RTN_UNICAST when not set
  net: hns3: Fix inconsistent indenting
  net/af_iucv: always register net_device notifier
  ...

md: add bitmap_abort label in md_run

2019-06-20T23:36:00+00:00

Now, there are two places need to consider about
the failure of destroy bitmap, so move the common
part between bitmap_abort and abort label.

Reviewed-by: NeilBrown 
Signed-off-by: Guoqing Jiang 
Signed-off-by: Song Liu

md: introduce mddev_create/destroy_wb_pool for the change of member device

2019-06-20T23:36:00+00:00

Previously, we called rdev_init_wb to avoid potential data
inconsistency when array is created.

Now, we need to call the function and create mempool if a
device is added or just be flaged as "writemostly". So
mddev_create_wb_pool is introduced and called accordingly.
And for safety reason, we mark implicit GFP_NOIO allocation
scope for create mempool during mddev_suspend/mddev_resume.

And mempool should be removed conversely after remove a
member device or its's "writemostly" flag, which is done
by call mddev_destroy_wb_pool.

Reviewed-by: NeilBrown 
Signed-off-by: Guoqing Jiang 
Signed-off-by: Song Liu

md/raid1: fix potential data inconsistency issue with write behind device

2019-06-20T23:35:59+00:00

For write-behind mode, we think write IO is complete once it has
reached all the non-writemostly devices. It works fine for single
queue devices.

But for multiqueue device, if there are lots of IOs come from upper
layer, then the write-behind device could issue those IOs to different
queues, depends on the each queue's delay, so there is no guarantee
that those IOs can arrive in order.

To address the issue, we need to check the collision among write
behind IOs, we can only continue without collision, otherwise wait
for the completion of previous collisioned IO.

And WBCollision is introduced for multiqueue device which is worked
under write-behind mode.

But this patch doesn't handle below cases which could have the data
inconsistency issue as well, these cases will be handled in later
patches.

1. modify max_write_behind by write backlog node.
2. add or remove array's bitmap dynamically.
3. the change of member disk.

Reviewed-by: NeilBrown 
Signed-off-by: Guoqing Jiang 
Signed-off-by: Song Liu

md: fix for divide error in status_resync

2019-06-18T15:02:25+00:00

Stopping external metadata arrays during resync/recovery causes
retries, loop of interrupting and starting reconstruction, until it
hit at good moment to stop completely. While these retries
curr_mark_cnt can be small- especially on HDD drives, so subtraction
result can be smaller than 0. However it is casted to uint without
checking. As a result of it the status bar in /proc/mdstat while stopping
is strange (it jumps between 0% and 99%).

The real problem occurs here after commit 72deb455b5ec ("block: remove
CONFIG_LBDAF"). Sector_div() macro has been changed, now the
divisor is casted to uint32. For db = -8 the divisior(db/32-1) becomes 0.

Check if db value can be really counted and replace these macro by
div64_u64() inline.

Signed-off-by: Mariusz Tkaczyk 
Signed-off-by: Song Liu

md: fix spelling typo and add necessary space

2019-06-15T07:37:34+00:00

This patch fix a spelling typo and add necessary space for code.
In addition, the patch get rid of the unnecessary 'if'.

Signed-off-by: Yufen Yu 
Signed-off-by: Song Liu 
Signed-off-by: Jens Axboe

md: md.c: Return -ENODEV when mddev is NULL in rdev_attr_show

2019-06-15T07:37:34+00:00

Commit c42d3240990814eec1e4b2b93fa0487fc4873aed
("md: return -ENODEV if rdev has no mddev assigned") changed
rdev_attr_store to return -ENODEV when rdev->mddev is NULL, now do the
same to rdev_attr_show.

Signed-off-by: Marcos Paulo de Souza 
Signed-off-by: Song Liu 
Signed-off-by: Jens Axboe

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 47

2019-05-24T15:27:13+00:00

Based on 1 normalized pattern(s):

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license as published by
  the free software foundation either version 2 or at your option any
  later version you should have received a copy of the gnu general
  public license for example usr src linux copying if not write to the
  free software foundation inc 675 mass ave cambridge ma 02139 usa

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-or-later

has been chosen to replace the boilerplate/reference in 20 file(s).

Signed-off-by: Thomas Gleixner 
Reviewed-by: Allison Randal 
Reviewed-by: Kate Stewart 
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190520170858.552543146@linutronix.de
Signed-off-by: Greg Kroah-Hartman

md: initialize percpu refcounters using PERCU_REF_ALLOW_REINIT

2019-05-09T17:50:59+00:00

Percpu reference counters should now be initialized with the
PERCPU_REF_ALLOW_REINIT in order to allow switching them to the
percpu mode from the atomic mode.
To make percpu_ref_switch_to_percpu() call in set_in_sync()
succeed,let's initialize percpu refcounters with the
PERCU_REF_ALLOW_REINIT flag.

Signed-off-by: Roman Gushchin 
Acked-by: Tejun Heo 
Signed-off-by: Dennis Zhou