From Simon Horman:
Renesas ARM based SoC fixes for v3.13

* r8a7790 (R-Car H1) SoC
  - Correct GPIO resources in DT.

    This problem has been present since GPIOs were added to the r8a7790 SoC
    by f98e10c88aa95bf7 ("ARM: shmobile: r8a7790: Add GPIO controller
    devices to device tree") in v3.12-rc1.

* irqchip renesas-intc-irqpin
  - Correct register bitfield shift calculation

    This bug has been present since the renesas-intc-irqpin driver was
    introduced by 443580486e3b9657 ("irqchip: Renesas INTC External IRQ pin
    driver") in v3.10-rc1

* Lager board
  - Do not build the phy fixup unless CONFIG_PHYLIB is enabled

    This problem was introduced by 48c8b96f21817aad

* tag 'renesas-fixes-for-v3.13' of git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas:
  ARM: shmobile: r8a7790: Fix GPIO resources in DTS
  irqchip: renesas-intc-irqpin: Fix register bitfield shift calculation
  ARM: shmobile: lager: phy fixup needs CONFIG_PHYLIB

Signed-off-by: Kevin Hilman <khilman@linaro.org>

Pull irq fixes from Thomas Gleixner:
 - Correction of fuzzy and fragile IRQ_RETVAL macro
 - IRQ related resume fix affecting only XEN
 - ARM/GIC fix for chained GIC controllers

* 'irq-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  irqchip: Gic: fix boot for chained gics
  irq: Enable all irqs unconditionally in irq_resume
  genirq: Correct fuzzy and fragile IRQ_RETVAL() definition

As of c0114709ed: "irqchip: gic: Perform the gic_secondary_init() call
via CPU notifier", booting on a platform with chained gics (e.g.
Realview EB ARM11MPCore) will result in the gic_cpu_notifier being
registered twice, corrupting the cpu notifier list and rendering the
platform unbootable.

This patch ensures that we only register the notifier for the first
gic, allowing platforms with chained gics to boot. At the same time we
limit the pointlessly duplicated calls to set_smp_cross_call and
set_handle_irq to the first gic registered.

Signed-off-by: Mark Rutland <mark.rutland@arm.com>
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: linux-arm-kernel@lists.infradead.org
Cc: marc.zyngier@arm.com
Cc: rob.herring@calxeda.com
Cc: olof@lixom.net
Link: http://lkml.kernel.org/r/1385648500-29048-1-git-send-email-mark.rutland@arm.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>

The SENSE register bitfield position is incorrectly computed for SoCs
that use 2-bit IRQ sense fields. Fix it.

This has been tested on the Marzen (H1) and Bockw (M1) boards.

This bug has been present since the renesas-intc-irqpin driver was
introduced by 443580486e3b9657 ("irqchip: Renesas INTC External IRQ pin
driver") in v3.10-rc1.

Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Acked-by: Magnus Damm <damm@opensource.se>
Tested-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

Pull ARM updates from Russell King:
 "Included in this series are:

   1. BE8 (modern big endian) changes for ARM from Ben Dooks
   2. big.Little support from Nicolas Pitre and Dave Martin
   3. support for LPAE systems with all system memory above 4GB
   4. Perf updates from Will Deacon
   5. Additional prefetching and other performance improvements from Will.
   6. Neon-optimised AES implementation fro Ard.
   7. A number of smaller fixes scattered around the place.

  There is a rather horrid merge conflict in tools/perf - I was never
  notified of the conflict because it originally occurred between Will's
  tree and other stuff.  Consequently I have a resolution which Will
  forwarded me, which I'll forward on immediately after sending this
  mail.

  The other notable thing is I'm expecting some build breakage in the
  crypto stuff on ARM only with Ard's AES patches.  These were merged
  into a stable git branch which others had already pulled, so there's
  little I can do about this.  The problem is caused because these
  patches have a dependency on some code in the crypto git tree - I
  tried requesting a branch I can pull to resolve these, and all I got
  each time from the crypto people was "we'll revert our patches then"
  which would only make things worse since I still don't have the
  dependent patches.  I've no idea what's going on there or how to
  resolve that, and since I can't split these patches from the rest of
  this pull request, I'm rather stuck with pushing this as-is or
  reverting Ard's patches.

  Since it should "come out in the wash" I've left them in - the only
  build problems they seem to cause at the moment are with randconfigs,
  and since it's a new feature anyway.  However, if by -rc1 the
  dependencies aren't in, I think it'd be best to revert Ard's patches"

I resolved the perf conflict roughly as per the patch sent by Russell,
but there may be some differences.  Any errors are likely mine.  Let's
see how the crypto issues work out..

* 'for-linus' of git://git.linaro.org/people/rmk/linux-arm: (110 commits)
  ARM: 7868/1: arm/arm64: remove atomic_clear_mask() in "include/asm/atomic.h"
  ARM: 7867/1: include: asm: use 'int' instead of 'unsigned long' for 'oldval' in atomic_cmpxchg().
  ARM: 7866/1: include: asm: use 'long long' instead of 'u64' within atomic.h
  ARM: 7871/1: amba: Extend number of IRQS
  ARM: 7887/1: Don't smp_cross_call() on UP devices in arch_irq_work_raise()
  ARM: 7872/1: Support arch_irq_work_raise() via self IPIs
  ARM: 7880/1: Clear the IT state independent of the Thumb-2 mode
  ARM: 7878/1: nommu: Implement dummy early_paging_init()
  ARM: 7876/1: clear Thumb-2 IT state on exception handling
  ARM: 7874/2: bL_switcher: Remove cpu_hotplug_driver_{lock,unlock}()
  ARM: footbridge: fix build warnings for netwinder
  ARM: 7873/1: vfp: clear vfp_current_hw_state for dying cpu
  ARM: fix misplaced arch_virt_to_idmap()
  ARM: 7848/1: mcpm: Implement cpu_kill() to synchronise on powerdown
  ARM: 7847/1: mcpm: Factor out logical-to-physical CPU translation
  ARM: 7869/1: remove unused XSCALE_PMU Kconfig param
  ARM: 7864/1: Handle 64-bit memory in case of 32-bit phys_addr_t
  ARM: 7863/1: Let arm_add_memory() always use 64-bit arguments
  ARM: 7862/1: pcpu: replace __get_cpu_var_uses
  ARM: 7861/1: cacheflush: consolidate single-CPU ARMv7 cache disabling code
  ...

Pull IRQ changes from Ingo Molnar:
 "The biggest change this cycle are the softirq/hardirq stack
  interaction and nesting fixes, cleanups and reorganizations from
  Frederic.  This is the longer followup story to the softirq nesting
  fix that is already upstream (commit ded797547548: "irq: Force hardirq
  exit's softirq processing on its own stack")"

* 'irq-core-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  irqchip: bcm2835: Convert to use IRQCHIP_DECLARE macro
  powerpc: Tell about irq stack coverage
  x86: Tell about irq stack coverage
  irq: Optimize softirq stack selection in irq exit
  irq: Justify the various softirq stack choices
  irq: Improve a bit softirq debugging
  irq: Optimize call to softirq on hardirq exit
  irq: Consolidate do_softirq() arch overriden implementations
  x86/irq: Correct comment about i8259 initialization

Pull ARM SoC DT updates from Olof Johansson:
 "Most of this branch consists of updates, additions and general churn
  of the device tree source files in the kernel (arch/arm/boot/dts).
  Besides that, there are a few things to point out:

   - Lots of platform conversion on OMAP2+, with removal of old board
     files for various platforms.
   - Final conversion of a bunch of ux500 (ST-Ericsson) platforms as
     well
   - Some updates to pinctrl and other subsystems.  Most of these are
     for DT-enablement of the various platforms and acks have been
     collected"

* tag 'dt-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (385 commits)
  ARM: dts: bcm11351: Use GIC/IRQ defines for sdio interrupts
  ARM: dts: bcm: Add missing UARTs for bcm11351 (bcm281xx)
  ARM: dts: bcm281xx: Add card detect GPIO
  ARM: dts: rename ARCH_BCM to ARCH_BCM_MOBILE (dt)
  ARM: bcm281xx: Add device node for the GPIO controller
  ARM: mvebu: Add Netgear ReadyNAS 104 board
  ARM: tegra: fix Tegra114 IOMMU register address
  ARM: kirkwood: add support for OpenBlocks A7 platform
  ARM: dts: omap4-panda: add DPI pinmuxing
  ARM: dts: AM33xx: Add RNG node
  ARM: dts: AM33XX: Add hwspinlock node
  ARM: dts: OMAP5: Add hwspinlock node
  ARM: dts: OMAP4: Add hwspinlock node
  ARM: dts: use 'status' property for PCIe nodes
  ARM: dts: sirf: add missed address-cells and size-cells for prima2 I2C
  ARM: dts: sirf: add missed cell, cs and dma channel for SPI nodes
  ARM: dts: sirf: add missed graphics2d iobg in atlas6 dts
  ARM: dts: sirf: add missed chhifbg node in prima2 and atlas6 dts
  ARM: dts: sirf: add missed memcontrol-monitor node in prima2 and atlas6 dts
  ARM: mvebu: Add the core-divider clock to Armada 370/XP
  ...

This patch converts irq-bcm2835 driver to use the new IRQCHIP_DECLARE and
irqchip_init.

Signed-off-by: Axel Lin <axel.lin@ingics.com>
Tested-by: Stephen Warren <swarren@wwwdotorg.org>
Cc: Simon Arlott <simon@fire.lp0.eu>
Cc: Olof Johansson <olof@lixom.net>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: linux-rpi-kernel@lists.infradead.org
Cc: linux-arm-kernel@lists.infradead.org
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>

This commit introduces the support for the MSI interrupts in the
armada-370-xp interrupt controller driver. It registers an MSI chip to
the MSI chip registry, which will be used by the Marvell PCIe host
controller driver.

The MSI interrupts use the 16 high doorbells, and are therefore
notified using IRQ1 of the main interrupt controller.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
Acked-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
Signed-off-by: Jason Cooper <jason@lakedaemon.net>

Instead of using of_iomap(), we now use of_address_to_resource(),
request_mem_region() and ioremap(). This allows the corresponding I/O
regions to be properly requested and visible in /proc/iomem.

The main motivation for this change is that the introduction of the
MSI support requires us to get the physical address of the main
interrupt controller registers, so we will need the corresponding
'struct resource' anyway.

We also take this opportunity to change a panic() to BUG_ON(), in
order to be consistent with the rest of the driver.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
Tested-by: Daniel Price <daniel.price@gmail.com>
Acked-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
Signed-off-by: Jason Cooper <jason@lakedaemon.net>