commit 6797b39e6f6f34c74177736e146406e894b9482b upstream. The cypress PS/2 trackpad models supported by the cypress_ps2 driver emulate BTN_RIGHT events in firmware based on the finger position, as part of this no motion events are sent when the finger is in the button area. The INPUT_PROP_BUTTONPAD property is there to indicate to userspace that BTN_RIGHT events should be emulated in userspace, which is not necessary in this case. When INPUT_PROP_BUTTONPAD is advertised userspace will wait for a motion event before propagating the button event higher up the stack, as it needs current abs x + y data for its BTN_RIGHT emulation. Since in the cypress_ps2 pads don't report motion events in the button area, this means that clicks in the button area end up being ignored, so INPUT_PROP_BUTTONPAD actually causes problems for these touchpads, and removing it fixes: https://bugs.freedesktop.org/show_bug.cgi?id=76341 Reported-by: Adam Williamson <awilliam@redhat.com> Tested-by: Adam Williamson <awilliam@redhat.com> Reviewed-by: Peter Hutterer <peter.hutterer@who-t.net> Signed-off-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
commit 8a0435d958fb36d93b8df610124a0e91e5675c82 upstream. This extends Benjamin Tissoires manual min/max quirk table with support for the ThinkPad X240. Signed-off-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
commit 421e08c41fda1f0c2ff6af81a67b491389b653a5 upstream. The new Lenovo Haswell series (-40's) contains a new Synaptics touchpad. However, these new Synaptics devices report bad axis ranges. Under Windows, it is not a problem because the Windows driver uses RMI4 over SMBus to talk to the device. Under Linux, we are using the PS/2 fallback interface and it occurs the reported ranges are wrong. Of course, it would be too easy to have only one range for the whole series, each touchpad seems to be calibrated in a different way. We can not use SMBus to get the actual range because I suspect the firmware will switch into the SMBus mode and stop talking through PS/2 (this is the case for hybrid HID over I2C / PS/2 Synaptics touchpads). So as a temporary solution (until RMI4 land into upstream), start a new list of quirks with the min/max manually set. Signed-off-by: Benjamin Tissoires <benjamin.tissoires@redhat.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
commit c15bdfd5b9831e4cab8cfc118243956e267dd30e upstream. The current assumption in the elantech driver that hw version 3 touchpads are never clickpads and hw version 4 touchpads are always clickpads is wrong. There are several bug reports for this, ie: https://bugzilla.redhat.com/show_bug.cgi?id=1030802 http://superuser.com/questions/619582/right-elantech-touchpad-button-not-working-in-linux I've spend a couple of hours wading through various bugzillas, launchpads and forum posts to create a list of fw-versions and capabilities for different laptop models to find a good method to differentiate between clickpads and versions with separate hardware buttons. Which shows that a device being a clickpad is reliable indicated by bit 12 being set in the fw_version. I've included the gathered list inside the driver, so that we've this info at hand if we need to revisit this later. Signed-off-by: Hans de Goede <hdegoede@redhat.com> Reviewed-by: Benjamin Tissoires <benjamin.tissoires@redhat.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> Cc: Josh Boyer <jwboyer@fedoraproject.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The device uses special MPU controller that necessitates the new initialization sequence for the device. We also define a new protocol for the trackpad that allows reporting better resolution than older V2 protocol. Signed-off-by: Yunkang Tang <yunkang.tang@cn.alps.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Added detection for newer Elantech touchpads, so that kernel doesn't fall-back to default PS/2 driver. Supports touchpads released after ~August 2013. Fixes bug: https://lists.launchpad.net/kernel-packages/msg18481.html Tested on an Acer Aspire S7-392-6302. Signed-off by: Matt Walker <matt.g.d.walker@gmail.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
If hardware (or firmware) detects palm on the surface of the device it does not mean that the data packet is bad from the protocol standpoint. Instead of reporting PSMOUSE_BAD_DATA in this case simply threat it as if nothing touches the surface. BugLink: http://bugs.launchpad.net/bugs/1229361 Signed-off-by: Joseph Salisbury <joseph.salisbury@canonical.com> Tested-by: Kamal Mostafa <kamal@canonical.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Get rid of unnecessary (void *) casting in 'cypress_init' function. Signed-off-by: Geyslan G. Bem <geyslan@gmail.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Change the dev2's name from "PS/2 Mouse" to "ALPS PS/2 Device". Signed-off-by: Yunkang Tang <yunkang.tang@cn.alps.com> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Merge with mainline to bring in changes to input subsystem that were committed through other trees.