linux-stable.git/drivers/gpio/Makefile, branch linux-5.2.y

Merge tag 'armsoc-soc' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2019-05-16T15:31:32+00:00

Pull ARM SoC platform updates from Olof Johansson:
 "SoC updates, mostly refactorings and cleanups of old legacy platforms.

  Major themes this release:

   - Conversion of ixp4xx to a modern platform (drivers, DT, bindings)

   - Moving some of the ep93xx headers around to get it closer to
     multiplatform enabled.

   - Cleanups of Davinci

  This also contains a few patches that were queued up as fixes before
  5.1 but I didn't get sent in before release"

* tag 'armsoc-soc' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (123 commits)
  ARM: debug-ll: add default address for digicolor
  ARM: u300: regulator: add MODULE_LICENSE()
  ARM: ep93xx: move private headers out of mach/*
  ARM: ep93xx: move pinctrl interfaces into include/linux/soc
  ARM: ep93xx: keypad: stop using mach/platform.h
  ARM: ep93xx: move network platform data to separate header
  ARM: stm32: add AMBA support for stm32 family
  MAINTAINERS: update arch/arm/mach-davinci
  ARM: rockchip: add missing of_node_put in rockchip_smp_prepare_pmu
  ARM: dts: Add queue manager and NPE to the IXP4xx DTSI
  soc: ixp4xx: qmgr: Add DT probe code
  soc: ixp4xx: qmgr: Add DT bindings for IXP4xx qmgr
  soc: ixp4xx: npe: Add DT probe code
  soc: ixp4xx: Add DT bindings for IXP4xx NPE
  soc: ixp4xx: qmgr: Pass resources
  soc: ixp4xx: Remove unused functions
  soc: ixp4xx: Uninline several functions
  soc: ixp4xx: npe: Pass addresses as resources
  ARM: ixp4xx: Turn the QMGR into a platform device
  ARM: ixp4xx: Turn the NPE into a platform device
  ...

Merge tag 'mfd-next-5.2' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd

2019-05-14T17:39:08+00:00

Pull MFD updates from Lee Jones:
 "Core Framework:
   - Document (kerneldoc) core mfd_add_devices() API

  New Drivers:
   - Altera SOCFPGA System Manager
   - Maxim MAX77650/77651 PMIC
   - Maxim MAX77663 PMIC
   - ST Multi-Function eXpander (STMFX)

  New Device Support:
   - LEDs support in Intel Cherry Trail Whiskey Cove PMIC
   - RTC support in SAMSUNG Electronics S2MPA01 PMIC
   - SAM9X60 support in Atmel HLCDC (High-end LCD Controller)
   - USB X-Powers AXP 8xx PMICs
   - Integrated Sensor Hub (ISH) in ChromeOS EC
   - USB PD Logger in ChromeOS EC
   - AXP223 in X-Powers AXP series PMICs
   - Power Supply in X-Powers AXP 803 PMICs
   - Comet Lake in Intel Low Power Subsystem
   - Fingerprint MCU in ChromeOS EC
   - Touchpad MCU in ChromeOS EC
   - Move TI LM3532 support to LED

  New Functionality:
   - max77650, max77620: Add/extend DT support
   - max77620 power-off
   - syscon clocking
   - croc_ec host sleep event

  Fix-ups:
   - Trivial; Formatting, spelling, etc; Kconfig, sec-core, ab8500-debugfs
   - Remove unused functionality; rk808, da9063-*
   - SPDX conversion; da9063-*, atmel-*,
   - Adapt/add new register definitions; cs47l35-tables, cs47l90-tables, imx6q-iomuxc-gpr
   - Fix-up DT bindings; ti-lmu, cirrus,lochnagar
   - Simply obtaining driver data; ssbi, t7l66xb, tc6387xb, tc6393xb

  Bug Fixes:
   - Fix incorrect defined values; max77620, da9063
   - Fix device initialisation; twl6040
   - Reset device on init; intel-lpss
   - Fix build warnings when !OF; sun6i-prcm
   - Register OF match tables; tps65912-spi
   - Fix DMI matching; intel_quark_i2c_gpio"

* tag 'mfd-next-5.2' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (65 commits)
  mfd: Use dev_get_drvdata() directly
  mfd: cros_ec: Instantiate properly CrOS Touchpad MCU device
  mfd: cros_ec: Instantiate properly CrOS FP MCU device
  mfd: cros_ec: Update the EC feature codes
  mfd: intel-lpss: Add Intel Comet Lake PCI IDs
  mfd: lochnagar: Add links to binding docs for sound and hwmon
  mfd: ab8500-debugfs: Fix a typo ("deubgfs")
  mfd: imx6sx: Add MQS register definition for iomuxc gpr
  dt-bindings: mfd: LMU: Fix lm3632 dt binding example
  mfd: intel_quark_i2c_gpio: Adjust IOT2000 matching
  mfd: da9063: Fix OTP control register names to match datasheets for DA9063/63L
  mfd: tps65912-spi: Add missing of table registration
  mfd: axp20x: Add USB power supply mfd cell to AXP803
  mfd: sun6i-prcm: Fix build warning for non-OF configurations
  mfd: intel-lpss: Set the device in reset state when init
  platform/chrome: Add support for v1 of host sleep event
  mfd: cros_ec: Add host_sleep_event_v1 command
  mfd: cros_ec: Instantiate the CrOS USB PD logger driver
  mfd: cs47l90: Make DAC_AEC_CONTROL_2 readable
  mfd: cs47l35: Make DAC_AEC_CONTROL_2 readable
  ...

gpio: max77650: Add GPIO support

2019-05-08T11:06:58+00:00

Add GPIO support for max77650 mfd device. This PMIC exposes a single
GPIO line.

Signed-off-by: Bartosz Golaszewski 
Reviewed-by: Linus Walleij 
Signed-off-by: Lee Jones

gpio: ixp4xx: Add driver for the IXP4xx GPIO

2019-04-23T14:02:13+00:00

This adds a driver for the IXP4xx GPIO block found in
the Intel XScale IXP4xx systems.

The GPIO part of this block is pretty straight-forward and
just uses the generic MMIO GPIO library.

The irqchip side of this driver is hierarchical where
the main irqchip will receive a processed level trigger
in response to the edge detector of the GPIO block,
so for this reason the v2 version of the irqdomain API
is used (as well as in the parent IXP4xx irqchip) and
masking, unmasking and setting up the type on IRQ
happens on several levels.

Currently this GPIO controller will grab the parent
irqdomain using a special function, but as the platform
move toward device tree probing, this will not be needed:
we can just look up the parent irqdomain from the device
tree.

Cc: Bartosz Golaszewski 
Signed-off-by: Linus Walleij

gpio: add driver for Mellanox BlueField GPIO controller

2019-03-26T17:41:21+00:00

This patch adds support for the GPIO controller used by Mellanox
BlueField SOCs.

Reviewed-by: David Woods 
Signed-off-by: Shravan Kumar Ramani 
Signed-off-by: Bartosz Golaszewski

gpio: AMD G-Series PCH gpio driver

2019-02-22T16:26:52+00:00

GPIO platform driver for the AMD G-series PCH (eg. on GX-412TC)

This driver doesn't registers itself automatically, as it needs to
be provided with platform specific configuration, provided by some
board driver setup code.

Didn't implement oftree probing yet, as it's rarely found on x86.

Cc: linux-gpio@vger.kernel.org
Cc: linus.walleij@linaro.org
Cc: bgolaszewski@baylibre.com
Cc: dvhart@infradead.org
Cc: platform-driver-x86@vger.kernel.org
Reviewed-by: Andy Shevchenko 
Signed-off-by: Enrico Weigelt, metux IT consult 
Signed-off-by: Linus Walleij

gpio: Add a Gateworks PLD GPIO driver

2019-02-09T10:33:37+00:00

This adds a driver for Gateworks PLD GPIO, that exist in
two instances on the Gateworks Cambria GW2358-4 router
platform at least.

Cc: Imre Kaloz 
Cc: Tim Harvey 
Reviewed-by: Bartosz Golaszewski 
Signed-off-by: Linus Walleij

gpio: tqmx86: Add GPIO from for this IO controller

2019-01-28T14:19:23+00:00

Some TQ-Systems ComExpress modules contain an IO controller with 8
GPIO lines.

Signed-off-by: Andrew Lunn 
Signed-off-by: Linus Walleij

gpio: Add Cadence GPIO driver

2018-12-21T10:41:00+00:00

This patch adds a driver for Cadence GPIO controller.

It can be enabled with GPIO_CADENCE Kconfig option.
It uses generic GPIO infrastructure and works
as an interrupt controller.
At the moment it only supports level sensitive irqs.

Signed-off-by: Jan Kotas 
Signed-off-by: Linus Walleij

gpio: add driver for SAMA5D2 PIOBU pins

2018-12-21T09:55:57+00:00

PIOBU pins do not lose their voltage during Backup/Self-refresh.
This patch adds a simple GPIO controller for them and a
maintainer for the driver.

This driver adds support for using the pins as GPIO
offering the possibility to read/set the voltage.

Signed-off-by: Andrei Stefanescu 
Signed-off-by: Linus Walleij