Pull GPIO fix from Linus Walleij:
 "Fix a build error in gpio-adp5588"

* tag 'gpio-v5.2-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio:
  gpio: fix gpio-adp5588 build errors

The gpio-adp5588 driver uses interfaces that are provided by
GPIOLIB_IRQCHIP, so select that symbol in its Kconfig entry.

Fixes these build errors:

../drivers/gpio/gpio-adp5588.c: In function ‘adp5588_irq_handler’:
../drivers/gpio/gpio-adp5588.c:266:26: error: ‘struct gpio_chip’ has no member named ‘irq’
            dev->gpio_chip.irq.domain, gpio));
                          ^
../drivers/gpio/gpio-adp5588.c: In function ‘adp5588_irq_setup’:
../drivers/gpio/gpio-adp5588.c:298:2: error: implicit declaration of function ‘gpiochip_irqchip_add_nested’ [-Werror=implicit-function-declaration]
  ret = gpiochip_irqchip_add_nested(&dev->gpio_chip,
  ^
../drivers/gpio/gpio-adp5588.c:307:2: error: implicit declaration of function ‘gpiochip_set_nested_irqchip’ [-Werror=implicit-function-declaration]
  gpiochip_set_nested_irqchip(&dev->gpio_chip,
  ^

Fixes: 459773ae8dbb ("gpio: adp5588-gpio: support interrupt controller")
Reported-by: kbuild test robot <lkp@intel.com>
Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Cc: linux-gpio@vger.kernel.org
Reviewed-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Acked-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add SPDX license identifiers to all Make/Kconfig files which:

 - Have no license information of any form

These files fall under the project license, GPL v2 only. The resulting SPDX
license identifier is:

  GPL-2.0-only

Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull ARM SoC platform updates from Olof Johansson:
 "SoC updates, mostly refactorings and cleanups of old legacy platforms.

  Major themes this release:

   - Conversion of ixp4xx to a modern platform (drivers, DT, bindings)

   - Moving some of the ep93xx headers around to get it closer to
     multiplatform enabled.

   - Cleanups of Davinci

  This also contains a few patches that were queued up as fixes before
  5.1 but I didn't get sent in before release"

* tag 'armsoc-soc' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (123 commits)
  ARM: debug-ll: add default address for digicolor
  ARM: u300: regulator: add MODULE_LICENSE()
  ARM: ep93xx: move private headers out of mach/*
  ARM: ep93xx: move pinctrl interfaces into include/linux/soc
  ARM: ep93xx: keypad: stop using mach/platform.h
  ARM: ep93xx: move network platform data to separate header
  ARM: stm32: add AMBA support for stm32 family
  MAINTAINERS: update arch/arm/mach-davinci
  ARM: rockchip: add missing of_node_put in rockchip_smp_prepare_pmu
  ARM: dts: Add queue manager and NPE to the IXP4xx DTSI
  soc: ixp4xx: qmgr: Add DT probe code
  soc: ixp4xx: qmgr: Add DT bindings for IXP4xx qmgr
  soc: ixp4xx: npe: Add DT probe code
  soc: ixp4xx: Add DT bindings for IXP4xx NPE
  soc: ixp4xx: qmgr: Pass resources
  soc: ixp4xx: Remove unused functions
  soc: ixp4xx: Uninline several functions
  soc: ixp4xx: npe: Pass addresses as resources
  ARM: ixp4xx: Turn the QMGR into a platform device
  ARM: ixp4xx: Turn the NPE into a platform device
  ...

Pull MFD updates from Lee Jones:
 "Core Framework:
   - Document (kerneldoc) core mfd_add_devices() API

  New Drivers:
   - Altera SOCFPGA System Manager
   - Maxim MAX77650/77651 PMIC
   - Maxim MAX77663 PMIC
   - ST Multi-Function eXpander (STMFX)

  New Device Support:
   - LEDs support in Intel Cherry Trail Whiskey Cove PMIC
   - RTC support in SAMSUNG Electronics S2MPA01 PMIC
   - SAM9X60 support in Atmel HLCDC (High-end LCD Controller)
   - USB X-Powers AXP 8xx PMICs
   - Integrated Sensor Hub (ISH) in ChromeOS EC
   - USB PD Logger in ChromeOS EC
   - AXP223 in X-Powers AXP series PMICs
   - Power Supply in X-Powers AXP 803 PMICs
   - Comet Lake in Intel Low Power Subsystem
   - Fingerprint MCU in ChromeOS EC
   - Touchpad MCU in ChromeOS EC
   - Move TI LM3532 support to LED

  New Functionality:
   - max77650, max77620: Add/extend DT support
   - max77620 power-off
   - syscon clocking
   - croc_ec host sleep event

  Fix-ups:
   - Trivial; Formatting, spelling, etc; Kconfig, sec-core, ab8500-debugfs
   - Remove unused functionality; rk808, da9063-*
   - SPDX conversion; da9063-*, atmel-*,
   - Adapt/add new register definitions; cs47l35-tables, cs47l90-tables, imx6q-iomuxc-gpr
   - Fix-up DT bindings; ti-lmu, cirrus,lochnagar
   - Simply obtaining driver data; ssbi, t7l66xb, tc6387xb, tc6393xb

  Bug Fixes:
   - Fix incorrect defined values; max77620, da9063
   - Fix device initialisation; twl6040
   - Reset device on init; intel-lpss
   - Fix build warnings when !OF; sun6i-prcm
   - Register OF match tables; tps65912-spi
   - Fix DMI matching; intel_quark_i2c_gpio"

* tag 'mfd-next-5.2' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (65 commits)
  mfd: Use dev_get_drvdata() directly
  mfd: cros_ec: Instantiate properly CrOS Touchpad MCU device
  mfd: cros_ec: Instantiate properly CrOS FP MCU device
  mfd: cros_ec: Update the EC feature codes
  mfd: intel-lpss: Add Intel Comet Lake PCI IDs
  mfd: lochnagar: Add links to binding docs for sound and hwmon
  mfd: ab8500-debugfs: Fix a typo ("deubgfs")
  mfd: imx6sx: Add MQS register definition for iomuxc gpr
  dt-bindings: mfd: LMU: Fix lm3632 dt binding example
  mfd: intel_quark_i2c_gpio: Adjust IOT2000 matching
  mfd: da9063: Fix OTP control register names to match datasheets for DA9063/63L
  mfd: tps65912-spi: Add missing of table registration
  mfd: axp20x: Add USB power supply mfd cell to AXP803
  mfd: sun6i-prcm: Fix build warning for non-OF configurations
  mfd: intel-lpss: Set the device in reset state when init
  platform/chrome: Add support for v1 of host sleep event
  mfd: cros_ec: Add host_sleep_event_v1 command
  mfd: cros_ec: Instantiate the CrOS USB PD logger driver
  mfd: cs47l90: Make DAC_AEC_CONTROL_2 readable
  mfd: cs47l35: Make DAC_AEC_CONTROL_2 readable
  ...

Pull gpio updates from Linus Walleij:
 "This is the bulk of the GPIO changes for the v5.2 kernel cycle. A bit
  later than usual because I was ironing out my own mistakes. I'm
  holding some stuff back for the next kernel as a result, and this
  should be a healthy and well tested batch.

  Core changes:

   - The gpiolib MMIO driver has been enhanced to handle two direction
     registers, i.e. one register to set lines as input and one register
     to set lines as output. It turns out some silicon engineer thinks
     the ability to configure a line as input and output at the same
     time makes sense, this can be debated but includes a lot of analog
     electronics reasoning, and the registers are there and need to be
     handled consistently. Unsurprisingly, we enforce the lines to be
     either inputs or outputs in such schemes.

   - Send in the proper argument value to .set_config() dispatched to
     the pin control subsystem. Nobody used it before, now someone does,
     so fix it to work as expected.

   - The ACPI gpiolib portions can now handle pin bias setting (pull up
     or pull down). This has been in the ACPI spec for years and we
     finally have it properly integrated with Linux GPIOs. It was based
     on an observation from Andy Schevchenko that Thomas Petazzoni's
     changes to the core for biasing the PCA950x GPIO expander actually
     happen to fit hand-in-glove with what the ACPI core needed. Such
     nice synergies happen sometimes.

  New drivers:

   - A new driver for the Mellanox BlueField GPIO controller. This is
     using 64bit MMIO registers and can configure lines as inputs and
     outputs at the same time and after improving the MMIO library we
     handle it just fine. Interesting.

   - A new IXP4xx proper gpiochip driver with hierarchical interrupts
     should be coming in from the ARM SoC tree as well.

  Driver enhancements:

   - The PCA053x driver handles the CAT9554 GPIO expander.

   - The PCA053x driver handles the NXP PCAL6416 GPIO expander.

   - Wake-up support on PCA053x GPIO lines.

   - OMAP now does a nice asynchronous IRQ handling on wake-ups by
     letting everything wake up on edges, and this makes runtime PM work
     as expected too.

  Misc:

   - Several cleanups such as devres fixes.

   - Get rid of some languager comstructs that cause problems when
     compiling with LLVMs clang.

   - Documentation review and update"

* tag 'gpio-v5.2-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio: (85 commits)
  gpio: Update documentation
  docs: gpio: convert docs to ReST and rename to *.rst
  gpio: sch: Remove write-only core_base
  gpio: pxa: Make two symbols static
  gpiolib: acpi: Respect pin bias setting
  gpiolib: acpi: Add acpi_gpio_update_gpiod_lookup_flags() helper
  gpiolib: acpi: Set pin value, based on bias, more accurately
  gpiolib: acpi: Change type of dflags
  gpiolib: Introduce GPIO_LOOKUP_FLAGS_DEFAULT
  gpiolib: Make use of enum gpio_lookup_flags consistent
  gpiolib: Indent entry values of enum gpio_lookup_flags
  gpio: pca953x: add support for pca6416
  dt-bindings: gpio: pca953x: document the nxp,pca6416
  gpio: pca953x: add pcal6416 to the of_device_id table
  gpio: gpio-omap: Remove conditional pm_runtime handling for GPIO interrupts
  gpio: gpio-omap: configure edge detection for level IRQs for idle wakeup
  tracing: stop making gpio tracing configurable
  gpio: pca953x: Configure wake-up path when wake-up is enabled
  gpio: of: Optimize quirk checks
  gpio: mmio: Drop bgpio_dir_inverted
  ...

Add GPIO support for max77650 mfd device. This PMIC exposes a single
GPIO line.

Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

This adds a driver for the IXP4xx GPIO block found in
the Intel XScale IXP4xx systems.

The GPIO part of this block is pretty straight-forward and
just uses the generic MMIO GPIO library.

The irqchip side of this driver is hierarchical where
the main irqchip will receive a processed level trigger
in response to the edge detector of the GPIO block,
so for this reason the v2 version of the irqdomain API
is used (as well as in the parent IXP4xx irqchip) and
masking, unmasking and setting up the type on IRQ
happens on several levels.

Currently this GPIO controller will grab the parent
irqdomain using a special function, but as the platform
move toward device tree probing, this will not be needed:
we can just look up the parent irqdomain from the device
tree.

Cc: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Make the anon_inodes facility unconditional so that it can be used by core
VFS code and pidfd code.

Signed-off-by: David Howells <dhowells@redhat.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
[christian@brauner.io: adapt commit message to mention pidfds]
Signed-off-by: Christian Brauner <christian@brauner.io>

gpio: updates for v5.2 (part 1)

- batch of improvements for the vf610 driver which shrink the code and
  make use of resource managed helpers
- support for a new variant of pca953x
- make gpio-mockup buildable on systems without IOMEM
- make gpio-74x164 more flexible by using generic device properties
  plus minor improvements
- new driver for Mellanox BlueField
- fixes for wakeup GPIOs in gpio-omap
- use devm_platform_ioremap_resource() in gpio-mxc
- a couple improvements of kernel docs for ACPI code
- don't WARN() in gpiod_put() on optional GPIOs