linux-stable.git/drivers/clk, branch v4.19.26

clk: imx6sl: ensure MMDC CH0 handshake is bypassed

2019-02-12T18:47:08+00:00

[ Upstream commit 0efcc2c0fd2001a83240a8c3d71f67770484917e ]

Same as other i.MX6 SoCs, ensure unused MMDC channel's
handshake is bypassed, this is to make sure no request
signal will be generated when periphe_clk_sel is changed
or SRC warm reset is triggered.

Signed-off-by: Anson Huang 
Signed-off-by: Stephen Boyd 
Signed-off-by: Sasha Levin

clk: sunxi-ng: a33: Set CLK_SET_RATE_PARENT for all audio module clocks

2019-02-12T18:47:05+00:00

[ Upstream commit 6e6da2039c82271dd873b9ad2b902a692a7dd554 ]

All the audio interfaces on Allwinner SoCs need to change their module
clocks during operation, to switch between support for 44.1 kHz and 48
kHz family sample rates. The clock rate for the module clocks is
governed by their upstream audio PLL. The module clocks themselves only
have a gate, and sometimes a divider or mux. Thus any rate changes need
to be propagated upstream.

Set the CLK_SET_RATE_PARENT flag for all audio module clocks to achieve
this.

Signed-off-by: Chen-Yu Tsai 
Signed-off-by: Maxime Ripard 
Signed-off-by: Sasha Levin

clk: meson: meson8b: mark the CPU clock as CLK_IS_CRITICAL

2019-02-12T18:47:01+00:00

[ Upstream commit 0dad1ec65bc30a549aba38d34a727309bbf41bc8 ]

We don't want the common clock framework to disable the "cpu_clk" if
it's not used by any device. The cpufreq-dt driver does not enable the
CPU clocks. However, even if it would we would still want the CPU clock
to be enabled at all times because the CPU clock is also required even
if we disable CPU frequency scaling on a specific board.

The reason why we want the CPU clock to be enabled is a clock further up
in the tree:
Since commit 6f888e7bc7bd58 ("clk: meson: clk-pll: add enable bit") the
sys_pll can be disabled. However, since the CPU clock is derived from
sys_pll we don't want sys_pll to get disabled. The common clock
framework takes care of that for us by enabling all parent clocks of our
CPU clock when we mark the CPU clock with CLK_IS_CRITICAL.

Until now this is not a problem yet because all clocks in the CPU
clock's tree (including sys_pll) are read-only. However, once we allow
modifications to the clocks in that tree we will need this.

Signed-off-by: Martin Blumenstingl 
Acked-by: Jerome Brunet 
Signed-off-by: Neil Armstrong 
Link: https://lkml.kernel.org/r/20181115224048.13511-4-martin.blumenstingl@googlemail.com
Signed-off-by: Sasha Levin

clk: meson: meson8b: fix the width of the cpu_scale_div clock

2019-02-12T18:47:01+00:00

[ Upstream commit a8662eadd1032018f31e37deda811790b2326662 ]

According to the public S805 datasheet HHI_SYS_CPU_CLK_CNTL1[29:20] is
the register for the CPU scale_div clock. This matches the code in
Amlogic's 3.10 GPL kernel sources:
N = (aml_read_reg32(P_HHI_SYS_CPU_CLK_CNTL1) >> 20) & 0x3FF;

This means that the divider register is 10 bit wide instead of 9 bits.
So far this is not a problem since all u-boot versions I have seen are
not using the cpu_scale_div clock at all (instead they are configuring
the CPU clock to run off cpu_in_sel directly).

The fixes tag points to the latest rework of the CPU clocks. However,
even before the rework it was wrong. Commit 7a29a869434e8b ("clk: meson:
Add support for Meson clock controller") defines MESON_N_WIDTH as 9 (in
drivers/clk/meson/clk-cpu.c). But since the old clk-cpu implementation
this only carries the fixes tag for the CPU clock rewordk.

Fixes: 251b6fd38bcb9c ("clk: meson: rework meson8b cpu clock")
Signed-off-by: Martin Blumenstingl 
Signed-off-by: Neil Armstrong 
Link: https://lkml.kernel.org/r/20180927085921.24627-3-martin.blumenstingl@googlemail.com
Signed-off-by: Sasha Levin

clk: meson: meson8b: do not use cpu_div3 for cpu_scale_out_sel

2019-02-12T18:47:01+00:00

[ Upstream commit a5ac1ead32c9aac285f6436e09b4f6111996e9b8 ]

The cpu_div3 clock (cpu_in divided by 3) generates a signal with a duty
cycle of 33%. The CPU clock however requires a clock signal with a duty
cycle of 50% to run stable.
cpu_div3 was observed to be problematic when cycling through all
available CPU frequencies (with additional patches on top of this one)
while running "stress --cpu 4" in the background. This caused sporadic
hangs where the whole system would fully lock up.

Amlogic's 3.10 kernel code also does not use the cpu_div3 clock either
when changing the CPU clock.

Signed-off-by: Martin Blumenstingl 
Reviewed-by: Jerome Brunet 
Signed-off-by: Neil Armstrong 
Link: https://lkml.kernel.org/r/20181115224048.13511-3-martin.blumenstingl@googlemail.com
Signed-off-by: Sasha Levin

clk: boston: fix possible memory leak in clk_boston_setup()

2019-02-12T18:46:58+00:00

[ Upstream commit 46fda5b5067a391912cf73bf3d32c26b6a22ad09 ]

Smatch report warnings:
drivers/clk/imgtec/clk-boston.c:76 clk_boston_setup() warn: possible memory leak of 'onecell'
drivers/clk/imgtec/clk-boston.c:83 clk_boston_setup() warn: possible memory leak of 'onecell'
drivers/clk/imgtec/clk-boston.c:90 clk_boston_setup() warn: possible memory leak of 'onecell'

'onecell' is malloced in clk_boston_setup(), but not be freed
before leaving from the error handling cases.

Signed-off-by: Yi Wang 
Signed-off-by: Stephen Boyd 
Signed-off-by: Sasha Levin

clk: socfpga: stratix10: fix naming convention for the fixed-clocks

2019-01-31T07:14:34+00:00

commit b488517b28a47d16b228ce8dcf07f5cb8e5b3dc5 upstream.

The fixed clocks in the DTS file have a hyphen, but the clock driver has
the fixed clocks using underbar. Thus the clock driver cannot detect the
other fixed clocks correctly. Change the fixed clock names to a hyphen.

Fixes: 07afb8db7340 ("clk: socfpga: stratix10: add clock driver for
Stratix10 platform")
Cc: linux-stable@vger.kernel.org
Signed-off-by: Dinh Nguyen 
Signed-off-by: Stephen Boyd 
Signed-off-by: Greg Kroah-Hartman

clk: socfpga: stratix10: fix rate calculation for pll clocks

2019-01-31T07:14:34+00:00

commit c0a636e4cc2eb39244d23c0417c117be4c96a7fe upstream.

The main PLL calculation has a mistake. We should be using the
multiplying the VCO frequency, not the parent clock frequency.

Fixes: 07afb8db7340 ("clk: socfpga: stratix10: add clock driver for
Stratix10 platform")
Cc: linux-stable@vger.kernel.org
Signed-off-by: Dinh Nguyen 
Signed-off-by: Stephen Boyd 
Signed-off-by: Greg Kroah-Hartman

clk: imx6q: reset exclusive gates on init

2019-01-26T08:32:38+00:00

[ Upstream commit f7542d817733f461258fd3a47d77da35b2d9fc81 ]

The exclusive gates may be set up in the wrong way by software running
before the clock driver comes up. In that case the exclusive setup is
locked in its initial state, as the complementary function can't be
activated without disabling the initial setup first.

To avoid this lock situation, reset the exclusive gates to the off
state and allow the kernel to provide the proper setup.

Signed-off-by: Lucas Stach 
Reviewed-by: Dong Aisheng 
Signed-off-by: Stephen Boyd 
Signed-off-by: Sasha Levin

clk: imx: make mux parent strings const

2019-01-26T08:32:37+00:00

[ Upstream commit 9e5ef7a57ca75a1b9411c46caeeb6881124284a3 ]

As the commit 2893c379461a ("clk: make strings in parent name arrays
const"), let's make the parent strings const, otherwise we may meet
the following warning when compiling:

drivers/clk/imx/clk-imx7ulp.c: In function 'imx7ulp_clocks_init':
drivers/clk/imx/clk-imx7ulp.c:73:35: warning: passing argument 5 of
	'imx_clk_mux_flags' discards 'const' qualifier from pointer target type

  clks[IMX7ULP_CLK_APLL_PRE_SEL] = imx_clk_mux_flags("apll_pre_sel", base + 0x508, 0,
	1, pll_pre_sels, ARRAY_SIZE(pll_pre_sels), CLK_SET_PARENT_GATE);
                                   ^
In file included from drivers/clk/imx/clk-imx7ulp.c:23:0:
drivers/clk/imx/clk.h:200:27: note: expected 'const char **' but argument is
 of type 'const char * const*'
...

Cc: Stephen Boyd 
Cc: Michael Turquette 
Cc: Shawn Guo 
Signed-off-by: Dong Aisheng 
Signed-off-by: Stephen Boyd 
Signed-off-by: Sasha Levin