Some engines have transfer size and address alignment restrictions.  Add
a per-operation alignment property to struct dma_device that the async
routines and dmatest can use to check alignment capabilities.

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

Some engines optimize operation by reading ahead in the descriptor chain
such that descriptor2 may start execution before descriptor1 completes.
If descriptor2 depends on the result from descriptor1 then a fence is
required (on descriptor2) to disable this optimization.  The async_tx
api could implicitly identify dependencies via the 'depend_tx'
parameter, but that would constrain cases where the dependency chain
only specifies a completion order rather than a data dependency.  So,
provide an ASYNC_TX_FENCE to explicitly identify data dependencies.

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

If module_init and module_exit are nops then neither need to be defined.

[ Impact: pure cleanup ]

Reviewed-by: Andre Noll <maan@systemlinux.org>
Acked-by: Maciej Sosnowski <maciej.sosnowski@intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

Prepare the api for the arrival of a new parameter, 'scribble'.  This
will allow callers to identify scratchpad memory for dma address or page
address conversions.  As this adds yet another parameter, take this
opportunity to convert the common submission parameters (flags,
dependency, callback, and callback argument) into an object that is
passed by reference.

Also, take this opportunity to fix up the kerneldoc and add notes about
the relevant ASYNC_TX_* flags for each routine.

[ Impact: moves api pass-by-value parameters to a pass-by-reference struct ]

Signed-off-by: Andre Noll <maan@systemlinux.org>
Acked-by: Maciej Sosnowski <maciej.sosnowski@intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

In support of inter-channel chaining async_tx utilizes an ack flag to
gate whether a dependent operation can be chained to another.  While the
flag is not set the chain can be considered open for appending.  Setting
the ack flag closes the chain and flags the descriptor for garbage
collection.  The ASYNC_TX_DEP_ACK flag essentially means "close the
chain after adding this dependency".  Since each operation can only have
one child the api now implicitly sets the ack flag at dependency
submission time.  This removes an unnecessary management burden from
clients of the api.

[ Impact: clean up and enforce one dependency per operation ]

Reviewed-by: Andre Noll <maan@systemlinux.org>
Acked-by: Maciej Sosnowski <maciej.sosnowski@intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

All callers of async_tx_sync_epilog have called async_tx_quiesce on the
depend_tx, so async_tx_sync_epilog need only call the callback to
complete the operation.

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

Replace open coded "wait and acknowledge" instances with async_tx_quiesce.

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

commit 636bdeaa 'dmaengine: ack to flags: make use of the unused bits in
the 'ack' field' missed an ->ack conversion in
crypto/async_tx/async_memset.c

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

Signed-off-by: Dan Williams <dan.j.williams@intel.com>

The source and destination addresses are included to allow channel
selection based on address alignment.

Signed-off-by: Dan Williams <dan.j.williams@intel.com>
Reviewed-by: Haavard Skinnemoen <hskinnemoen@atmel.com>