linux-stable.git/arch, branch v3.0.73

x86-32, mm: Rip out x86_32 NUMA remapping code

2013-04-12T16:18:10+00:00

commit f03574f2d5b2d6229dcdf2d322848065f72953c7 upstream.

This code was an optimization for 32-bit NUMA systems.

It has probably been the cause of a number of subtle bugs over
the years, although the conditions to excite them would have
been hard to trigger.  Essentially, we remap part of the kernel
linear mapping area, and then sometimes part of that area gets
freed back in to the bootmem allocator.  If those pages get
used by kernel data structures (say mem_map[] or a dentry),
there's no big deal.  But, if anyone ever tried to use the
linear mapping for these pages _and_ cared about their physical
address, bad things happen.

For instance, say you passed __GFP_ZERO to the page allocator
and then happened to get handed one of these pages, it zero the
remapped page, but it would make a pte to the _old_ page.
There are probably a hundred other ways that it could screw
with things.

We don't need to hang on to performance optimizations for
these old boxes any more.  All my 32-bit NUMA systems are long
dead and buried, and I probably had access to more than most
people.

This code is causing real things to break today:

	https://lkml.org/lkml/2013/1/9/376

I looked in to actually fixing this, but it requires surgery
to way too much brittle code, as well as stuff like
per_cpu_ptr_to_phys().

[ hpa: Cc: this for -stable, since it is a memory corruption issue.
  However, an alternative is to simply mark NUMA as depends BROKEN
  rather than EXPERIMENTAL in the X86_32 subclause... ]

Link: http://lkml.kernel.org/r/20130131005616.1C79F411@kernel.stglabs.ibm.com
Signed-off-by: H. Peter Anvin 
Cc: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

powerpc: pSeries_lpar_hpte_remove fails from Adjunct partition being performed before the ANDCOND test

2013-04-12T16:18:09+00:00

commit 9fb2640159f9d4f5a2a9d60e490482d4cbecafdb upstream.

Some versions of pHyp will perform the adjunct partition test before the
ANDCOND test.  The result of this is that H_RESOURCE can be returned and
cause the BUG_ON condition to occur. The HPTE is not removed.  So add a
check for H_RESOURCE, it is ok if this HPTE is not removed as
pSeries_lpar_hpte_remove is looking for an HPTE to remove and not a
specific HPTE to remove.  So it is ok to just move on to the next slot
and try again.

Signed-off-by: Michael Wolf 
Signed-off-by: Stephen Rothwell 
Signed-off-by: Greg Kroah-Hartman

alpha: Add irongate_io to PCI bus resources

2013-04-12T16:18:09+00:00

commit aa8b4be3ac049c8b1df2a87e4d1d902ccfc1f7a9 upstream.

Fixes a NULL pointer dereference at boot on UP1500.

Reviewed-and-Tested-by: Matt Turner 
Signed-off-by: Jay Estabrook 
Signed-off-by: Matt Turner 
Signed-off-by: Michael Cree 
Signed-off-by: Linus Torvalds 
Signed-off-by: Greg Kroah-Hartman

iommu/amd: Make sure dma_ops are set for hotplug devices

2013-04-05T17:16:54+00:00

commit c2a2876e863356b092967ea62bebdb4dd663af80 upstream.

There is a bug introduced with commit 27c2127 that causes
devices which are hot unplugged and then hot-replugged to
not have per-device dma_ops set. This causes these devices
to not function correctly. Fixed with this patch.

Reported-by: Andreas Degert 
Signed-off-by: Joerg Roedel 
Signed-off-by: Greg Kroah-Hartman

KVM: x86: invalid opcode oops on SET_SREGS with OSXSAVE bit set (CVE-2012-4461)

2013-04-05T17:16:51+00:00

commit 6d1068b3a98519247d8ba4ec85cd40ac136dbdf9 upstream.

On hosts without the XSAVE support unprivileged local user can trigger
oops similar to the one below by setting X86_CR4_OSXSAVE bit in guest
cr4 register using KVM_SET_SREGS ioctl and later issuing KVM_RUN
ioctl.

invalid opcode: 0000 [#2] SMP
Modules linked in: tun ip6table_filter ip6_tables ebtable_nat ebtables
...
Pid: 24935, comm: zoog_kvm_monito Tainted: G      D      3.2.0-3-686-pae
EIP: 0060:[] EFLAGS: 00210246 CPU: 0
EIP is at kvm_arch_vcpu_ioctl_run+0x92a/0xd13 [kvm]
EAX: 00000001 EBX: 000f387e ECX: 00000000 EDX: 00000000
ESI: 00000000 EDI: 00000000 EBP: ef5a0060 ESP: d7c63e70
 DS: 007b ES: 007b FS: 00d8 GS: 00e0 SS: 0068
Process zoog_kvm_monito (pid: 24935, ti=d7c62000 task=ed84a0c0
task.ti=d7c62000)
Stack:
 00000001 f70a1200 f8b940a9 ef5a0060 00000000 00200202 f8769009 00000000
 ef5a0060 000f387e eda5c020 8722f9c8 00015bae 00000000 ed84a0c0 ed84a0c0
 c12bf02d 0000ae80 ef7f8740 fffffffb f359b740 ef5a0060 f8b85dc1 0000ae80
Call Trace:
 [] ? kvm_arch_vcpu_ioctl_set_sregs+0x2fe/0x308 [kvm]
...
 [] ? syscall_call+0x7/0xb
Code: 89 e8 e8 14 ee ff ff ba 00 00 04 00 89 e8 e8 98 48 ff ff 85 c0 74
1e 83 7d 48 00 75 18 8b 85 08 07 00 00 31 c9 8b 95 0c 07 00 00 <0f> 01
d1 c7 45 48 01 00 00 00 c7 45 1c 01 00 00 00 0f ae f0 89
EIP: [] kvm_arch_vcpu_ioctl_run+0x92a/0xd13 [kvm] SS:ESP
0068:d7c63e70

QEMU first retrieves the supported features via KVM_GET_SUPPORTED_CPUID
and then sets them later. So guest's X86_FEATURE_XSAVE should be masked
out on hosts without X86_FEATURE_XSAVE, making kvm_set_cr4 with
X86_CR4_OSXSAVE fail. Userspaces that allow specifying guest cpuid with
X86_FEATURE_XSAVE even on hosts that do not support it, might be
susceptible to this attack from inside the guest as well.

Allow setting X86_CR4_OSXSAVE bit only if host has XSAVE support.

Signed-off-by: Petr Matousek 
Signed-off-by: Marcelo Tosatti 
Signed-off-by: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

KVM: Ensure all vcpus are consistent with in-kernel irqchip settings

2013-04-05T17:16:38+00:00

commit 3e515705a1f46beb1c942bb8043c16f8ac7b1e9e upstream.

If some vcpus are created before KVM_CREATE_IRQCHIP, then
irqchip_in_kernel() and vcpu->arch.apic will be inconsistent, leading
to potential NULL pointer dereferences.

Fix by:
- ensuring that no vcpus are installed when KVM_CREATE_IRQCHIP is called
- ensuring that a vcpu has an apic if it is installed after KVM_CREATE_IRQCHIP

This is somewhat long winded because vcpu->arch.apic is created without
kvm->lock held.

Based on earlier patch by Michael Ellerman.

Signed-off-by: Michael Ellerman 
Signed-off-by: Avi Kivity 
Signed-off-by: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

KVM: x86: Prevent starting PIT timers in the absence of irqchip support

2013-04-05T17:16:38+00:00

commit 0924ab2cfa98b1ece26c033d696651fd62896c69 upstream.

User space may create the PIT and forgets about setting up the irqchips.
In that case, firing PIT IRQs will crash the host:

BUG: unable to handle kernel NULL pointer dereference at 0000000000000128
IP: [] kvm_set_irq+0x30/0x170 [kvm]
...
Call Trace:
 [] pit_do_work+0x51/0xd0 [kvm]
 [] process_one_work+0x111/0x4d0
 [] worker_thread+0x152/0x340
 [] kthread+0x7e/0x90
 [] kernel_thread_helper+0x4/0x10

Prevent this by checking the irqchip mode before starting a timer. We
can't deny creating the PIT if the irqchips aren't set up yet as
current user land expects this order to work.

Signed-off-by: Jan Kiszka 
Signed-off-by: Marcelo Tosatti 
Signed-off-by: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

KVM: Clean up error handling during VCPU creation

2013-04-05T17:16:37+00:00

commit d780592b99d7d8a5ff905f6bacca519d4a342c76 upstream.

So far kvm_arch_vcpu_setup is responsible for freeing the vcpu struct if
it fails. Move this confusing resonsibility back into the hands of
kvm_vm_ioctl_create_vcpu. Only kvm_arch_vcpu_setup of x86 is affected,
all other archs cannot fail.

Signed-off-by: Jan Kiszka 
Signed-off-by: Avi Kivity 
Signed-off-by: Jiri Slaby 
Signed-off-by: Greg Kroah-Hartman

signal: Define __ARCH_HAS_SA_RESTORER so we know whether to clear sa_restorer

2013-04-05T17:16:35+00:00

Vaguely based on upstream commit 574c4866e33d 'consolidate kernel-side
struct sigaction declarations'.

flush_signal_handlers() needs to know whether sigaction::sa_restorer
is defined, not whether SA_RESTORER is defined.  Define the
__ARCH_HAS_SA_RESTORER macro to indicate this.

Signed-off-by: Ben Hutchings 
Cc: Al Viro 
Signed-off-by: Greg Kroah-Hartman

x86-64: Fix the failure case in copy_user_handle_tail()

2013-03-28T19:06:03+00:00

commit 66db3feb486c01349f767b98ebb10b0c3d2d021b upstream.

The increment of "to" in copy_user_handle_tail() will have incremented
before a failure has been noted.  This causes us to skip a byte in the
failure case.

Only do the increment when assured there is no failure.

Signed-off-by: CQ Tang 
Link: http://lkml.kernel.org/r/20130318150221.8439.993.stgit@phlsvslse11.ph.intel.com
Signed-off-by: Mike Marciniszyn 
Signed-off-by: H. Peter Anvin 
Signed-off-by: Greg Kroah-Hartman