Pull powerpc fixes from Michael Ellerman:
 - Fix build error on 32-bit with checkpoint restart from Aneesh Kumar
 - Fix dedotify for binutils >= 2.26 from Andreas Schwab
 - Don't trace hcalls on offline CPUs from Denis Kirjanov
 - eeh: Fix stale cached primary bus from Gavin Shan
 - eeh: Fix stale PE primary bus from Gavin Shan
 - mm: Fix Multi hit ERAT cause by recent THP update from Aneesh Kumar K.V
 - ioda: Set "read" permission when "write" is set from Alexey Kardashevskiy

* tag 'powerpc-4.5-3' of git://git.kernel.org/pub/scm/linux/kernel/git/powerpc/linux:
  powerpc/ioda: Set "read" permission when "write" is set
  powerpc/mm: Fix Multi hit ERAT cause by recent THP update
  powerpc/powernv: Fix stale PE primary bus
  powerpc/eeh: Fix stale cached primary bus
  powerpc/pseries: Don't trace hcalls on offline CPUs
  powerpc: Fix dedotify for binutils >= 2.26
  powerpc/book3s_32: Fix build error with checkpoint restart

With ppc64 we use the deposited pgtable_t to store the hash pte slot
information. We should not withdraw the deposited pgtable_t without
marking the pmd none. This ensure that low level hash fault handling
will skip this huge pte and we will handle them at upper levels.

Recent change to pmd splitting changed the above in order to handle the
race between pmd split and exit_mmap. The race is explained below.

Consider following race:

		CPU0				CPU1
shrink_page_list()
  add_to_swap()
    split_huge_page_to_list()
      __split_huge_pmd_locked()
        pmdp_huge_clear_flush_notify()
	// pmd_none() == true
					exit_mmap()
					  unmap_vmas()
					    zap_pmd_range()
					      // no action on pmd since pmd_none() == true
	pmd_populate()

As result the THP will not be freed. The leak is detected by check_mm():

	BUG: Bad rss-counter state mm:ffff880058d2e580 idx:1 val:512

The above required us to not mark pmd none during a pmd split.

The fix for ppc is to clear the huge pte of _PAGE_USER, so that low
level fault handling code skip this pte. At higher level we do take ptl
lock. That should serialze us against the pmd split. Once the lock is
acquired we do check the pmd again using pmd_same. That should always
return false for us and hence we should retry the access. We do the
pmd_same check in all case after taking plt with
THP (do_huge_pmd_wp_page, do_huge_pmd_numa_page and
huge_pmd_set_accessed)

Also make sure we wait for irq disable section in other cpus to finish
before flipping a huge pte entry with a regular pmd entry. Code paths
like find_linux_pte_or_hugepte depend on irq disable to get
a stable pte_t pointer. A parallel thp split need to make sure we
don't convert a pmd pte to a regular pmd entry without waiting for the
irq disable section to finish.

Fixes: eef1b3ba053a ("thp: implement split_huge_pmd()")
Acked-by: Kirill A. Shutemov <kirill.shutemov@linux.intel.com>
Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

When PE is created, its primary bus is cached to pe->bus. At later
point, the cached primary bus is returned from eeh_pe_bus_get().
However, we could get stale cached primary bus and run into kernel
crash in one case: full hotplug as part of fenced PHB error recovery
releases all PCI busses under the PHB at unplugging time and recreate
them at plugging time. pe->bus is still dereferencing the PCI bus
that was released.

This adds another PE flag (EEH_PE_PRI_BUS) to represent the validity
of pe->bus. pe->bus is updated when its first child EEH device is
online and the flag is set. Before unplugging in full hotplug for
error recovery, the flag is cleared.

Fixes: 8cdb2833 ("powerpc/eeh: Trace PCI bus from PE")
Cc: stable@vger.kernel.org #v3.11+
Reported-by: Andrew Donnellan <andrew.donnellan@au1.ibm.com>
Reported-by: Pradipta Ghosh <pradghos@in.ibm.com>
Signed-off-by: Gavin Shan <gwshan@linux.vnet.ibm.com>
Tested-by: Andrew Donnellan <andrew.donnellan@au1.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

If a cpu is hotplugged while the hcall trace points are active, it's
possible to hit a warning from RCU due to the trace points calling into
RCU from an offline cpu, eg:

  RCU used illegally from offline CPU!
  rcu_scheduler_active = 1, debug_locks = 1

Make the hypervisor tracepoints conditional by using
TRACE_EVENT_FN_COND.

Acked-by: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Denis Kirjanov <kda@linux-powerpc.org>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Pull powerpc fixes from Michael Ellerman:
 - Wire up copy_file_range() syscall from Chandan Rajendra
 - Simplify module TOC handling from Alan Modra
 - Remove newly added extra definition of pmd_dirty from Stephen Rothwell
 - Allow user space to map rtas_rmo_buf from Vasant Hegde
 - Fix PE location code from Gavin Shan
 - Remove PPMU_HAS_SSLOT flag for Power8 from Madhavan Srinivasan
 - Fixup _HPAGE_CHG_MASK from Aneesh Kumar K.V

* tag 'powerpc-4.5-2' of git://git.kernel.org/pub/scm/linux/kernel/git/powerpc/linux:
  powerpc/mm: Fixup _HPAGE_CHG_MASK
  powerpc/perf: Remove PPMU_HAS_SSLOT flag for Power8
  powerpc/eeh: Fix PE location code
  powerpc/mm: Allow user space to map rtas_rmo_buf
  powerpc: Remove newly added extra definition of pmd_dirty
  powerpc: Simplify module TOC handling
  powerpc: Wire up copy_file_range() syscall

This was wrongly updated by commit 7aa9a23c69ea ("powerpc, thp: remove
infrastructure for handling splitting PMDs") during the last merge
window. Fix it up.

This could lead to incorrect behaviour in THP and/or mprotect(), at a
minimum.

Fixes: 7aa9a23c69ea ("powerpc, thp: remove infrastructure for handling splitting PMDs")
Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Pull KVM fixes from Paolo Bonzini:
 "s390 and POWER bug fixes, plus enabling the KVM-VFIO interface on
  s390"

* tag 'for-linus' of git://git.kernel.org/pub/scm/virt/kvm/kvm:
  KVM doc: Fix KVM_SMI chapter number
  KVM: s390: fix memory overwrites when vx is disabled
  KVM: s390: Enable the KVM-VFIO device
  KVM: s390: fix guest fprs memory leak
  KVM: PPC: Fix ONE_REG AltiVec support
  KVM: PPC: Increase memslots to 512
  KVM: PPC: Book3S PR: Remove unused variable 'vcpu_book3s'
  KVM: PPC: Fix emulation of H_SET_DABR/X on POWER8
  KVM: PPC: Book3S HV: Handle unexpected traps in guest entry/exit code better

KVM: s390: Fixes for kvm/master (targeting 4.5)

1. Fallout of some bigger floating point/vector rework in s390
- memory leak -> stable 4.3+
- memory overwrite -> stable 4.4+

2. enable KVM-VFIO for s390

Commit d5d6a443b243 ("arch/powerpc/include/asm/pgtable-ppc64.h:
add pmd_[dirty|mkclean] for THP") added a new identical definition
of pmd_dirty(). Remove it again.

Cc: Minchan Kim <minchan@kernel.org>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Test runs on a ppc64 BE guest succeeded using modified fstests.

Also tested on ppc64 LE using a home made test - mpe.

Signed-off-by: Chandan Rajendra <chandan@linux.vnet.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>