linux-stable.git/arch/mips/kernel, branch linux-6.11.y

of/fdt: add dt_phys arg to early_init_dt_scan and early_init_dt_verify

2024-12-05T12:53:03+00:00

[ Upstream commit b2473a359763e27567993e7d8f37de82f57a0829 ]

 __pa() is only intended to be used for linear map addresses and using
it for initial_boot_params which is in fixmap for arm64 will give an
incorrect value. Hence save the physical address when it is known at
boot time when calling early_init_dt_scan for arm64 and use it at kexec
time instead of converting the virtual address using __pa().

Note that arm64 doesn't need the FDT region reserved in the DT as the
kernel explicitly reserves the passed in FDT. Therefore, only a debug
warning is fixed with this change.

Reported-by: Breno Leitao 
Suggested-by: Mark Rutland 
Signed-off-by: Usama Arif 
Fixes: ac10be5cdbfa ("arm64: Use common of_kexec_alloc_and_setup_fdt()")
Link: https://lore.kernel.org/r/20241023171426.452688-1-usamaarif642@gmail.com
Signed-off-by: Rob Herring (Arm) 
Signed-off-by: Sasha Levin

MIPS: export __cmpxchg_small()

2024-11-08T15:31:04+00:00

commit 90a88784cdb7757feb8dd520255e6cb861f30943 upstream.

Export the symbol __cmpxchg_small() for btrfs.ko that uses it to store
blk_status_t, which is u8. Reported by LKP:

>> ERROR: modpost: "__cmpxchg_small" [fs/btrfs/btrfs.ko] undefined!

Patch using the cmpxchg() https://lore.kernel.org/linux-btrfs/1d4f72f7fee285b2ddf4bf62b0ac0fd89def5417.1728575379.git.naohiro.aota@wdc.com/

Link: https://lore.kernel.org/all/20241016134919.GO1609@suse.cz/
Acked-by: Thomas Bogendoerfer 
Signed-off-by: David Sterba 
Signed-off-by: Greg Kroah-Hartman

Revert "MIPS: csrc-r4k: Apply verification clocksource flags"

2024-08-25T22:26:30+00:00

This reverts commit 7190401fc56fb5f02ee3d04476778ab000bbaf32.

Verifying the clock source sometimes deems the MIPS clock
to be unstable, at least in qemu.

clocksource: timekeeping watchdog on CPU0: Marking clocksource 'MIPS' as unstable because the skew is too large:
clocksource:                       'jiffies' wd_nsec: 500000000 wd_now: ffff8bde wd_last: ffff8bac mask: ffffffff
clocksource:                       'MIPS' cs_nsec: 940634468 cs_now: 310181c4 cs_last: 28090a09 mask: ffffffff
clocksource:                       Clocksource 'MIPS' skewed 440634468 ns (440 ms) over watchdog 'jiffies' interval of 500000000 ns (500 ms)
clocksource:                       'MIPS' is current clocksource.

If this happens, network interfaces fail to come online.

Signed-off-by: Guenter Roeck

MIPS: cevt-r4k: Don't call get_c0_compare_int if timer irq is installed

2024-08-20T08:36:52+00:00

This avoids warning:

[    0.118053] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:283

Caused by get_c0_compare_int on secondary CPU.

We also skipped saving IRQ number to struct clock_event_device *cd as
it's never used by clockevent core, as per comments it's only meant
for "non CPU local devices".

Reported-by: Serge Semin 
Closes: https://lore.kernel.org/linux-mips/6szkkqxpsw26zajwysdrwplpjvhl5abpnmxgu2xuj3dkzjnvsf@4daqrz4mf44k/
Signed-off-by: Jiaxun Yang 
Reviewed-by: Philippe Mathieu-Daudé 
Reviewed-by: Serge Semin 
Tested-by: Serge Semin 
Signed-off-by: Thomas Bogendoerfer

MIPS: Loongson64: Set timer mode in cpu-probe

2024-08-08T16:17:43+00:00

Loongson64 C and G processors have EXTIMER feature which
is conflicting with CP0 counter.

Although the processor resets in EXTIMER disabled & INTIMER
enabled mode, which is compatible with MIPS CP0 compare, firmware
may attempt to enable EXTIMER and interfere CP0 compare.

Set timer mode back to MIPS compatible mode to fix booting on
systems with such firmware before we have an actual driver for
EXTIMER.

Cc: stable@vger.kernel.org
Signed-off-by: Jiaxun Yang 
Signed-off-by: Thomas Bogendoerfer

Merge tag 'mips_6.11_1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

2024-07-25T19:41:53+00:00

Pull MIPS updates from Thomas Bogendoerfer:

 - Use improved timer sync for Loongson64

 - Fix address of GCR_ACCESS register

 - Add missing MODULE_DESCRIPTION

* tag 'mips_6.11_1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux:
  mips: sibyte: add missing MODULE_DESCRIPTION() macro
  MIPS: SMP-CPS: Fix address for GCR_ACCESS register for CM3 and later
  MIPS: Loongson64: Switch to SYNC_R4K

MIPS: SMP-CPS: Fix address for GCR_ACCESS register for CM3 and later

2024-07-23T07:30:13+00:00

When the CM block migrated from CM2.5 to CM3.0, the address offset for
the Global CSR Access Privilege register was modified. We saw this in
the "MIPS64 I6500 Multiprocessing System Programmer's Guide," it is
stated that "the Global CSR Access Privilege register is located at
offset 0x0120" in section 5.4. It is at least the same for I6400.

This fix allows to use the VP cores in SMP mode if the reset values
were modified by the bootloader.

Based on the work of Vladimir Kondratiev
 and the feedback from Jiaxun Yang
.

Fixes: 197e89e0984a ("MIPS: mips-cm: Implement mips_cm_revision")
Signed-off-by: Gregory CLEMENT 
Reviewed-by: Jiaxun Yang 
Signed-off-by: Thomas Bogendoerfer

Merge tag 'mips_6.11' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

2024-07-20T16:03:36+00:00

Pull MIPS updates from Thomas Bogendoerfer:

 - add support for Realtek RTL9302C

 - add support for Mobileye EyeQ6H

 - add support for Mobileye EyeQ OLB system controller

 - improve r4k clocksource

 - add mode for emulating ieee754 NAN2008

 - rework for BMIPS CBR address handling

 - fixes for Loongson 2K1000

 - defconfig updates

 - cleanups and fixes

* tag 'mips_6.11' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (58 commits)
  MIPS: config: Add ip30_defconfig
  MIPS: config: lemote2f: Regenerate defconfig
  MIPS: config: generic: Add board-litex
  MIPS: config: Enable MSA and virtualization for MIPS64R6
  MIPS: Fix fallback march for SB1
  mips: dts: realtek: Add RTL9302C board
  mips: generic: add fdt fixup for Realtek reference board
  mips: select REALTEK_OTTO_TIMER for Realtek platforms
  dt-bindings: interrupt-controller: realtek,rtl-intc: Add rtl9300-intc
  dt-bindings: mips: realtek: Add rtl930x-soc compatible
  dt-bindings: vendor-prefixes: Add Cameo Communications
  mips: dts: realtek: add device_type property to cpu node
  mips: dts: realtek: use "serial" instead of "uart" in node name
  MIPS: Implement ieee754 NAN2008 emulation mode
  MIPS: lantiq: improve USB initialization
  MIPS: GIC: Generate redirect block accessors
  MIPS: CPS: Add a couple of multi-cluster utility functions
  MIPS: Octeron: remove source file executable bit
  MAINTAINERS: Mobileye: add OLB drivers and dt-bindings
  MIPS: mobileye: eyeq5: add OLB system-controller node
  ...

MIPS: Implement ieee754 NAN2008 emulation mode

2024-07-12T11:09:25+00:00

Implement ieee754 NAN2008 emulation mode.

When this mode is enabled, kernel will accept ELF file
compiled for both NaN 2008 and NaN legacy, but if hardware
does not have capability to match ELF's NaN mode, __own_fpu
will fail for corresponding thread and fpuemu will then kick
in.

This mode trade performance for correctness, while maintaining
support for both NaN mode regardless of hardware capability.
It is useful for multilib installation that have both types
of binary exist in system.

Reviewed-by: Philippe Mathieu-Daudé 
Signed-off-by: Jiaxun Yang 
Signed-off-by: Thomas Bogendoerfer

MIPS: CPS: Add a couple of multi-cluster utility functions

2024-07-09T08:48:17+00:00

This patch introduces a couple of utility functions which help later
patches with introducing support for multi-cluster systems.

 - mips_cps_multicluster_cpus() allows its caller to determine whether
   the system includes CPUs spread across multiple clusters. This is
   useful because in some cases behaviour can be more optimal taking
   this knowledge into account. The means by which we check this is
   dependent upon the way we probe CPUs & assign their numbers, so
   keeping this knowledge confined here in arch/mips/ seems appropriate.

 - mips_cps_first_online_in_cluster() allows its caller to determine
   whether it is running upon the first CPU online within its cluster.
   This information is useful in cases where some cluster-wide
   configuration may need to occur, but should not be repeated if
   another CPU in the cluster is already online. Similarly to the above
   this is determined based upon knowledge of CPU numbering so it makes
   sense to keep that knowledge in arch/mips/. The function is defined
   in mips-cm.c rather than in asm/mips-cps.h in order to allow us to
   use asm/cpu-info.h & linux/smp.h without encountering an include
   nightmare.

Signed-off-by: Paul Burton 
Signed-off-by: Chao-ying Fu 
Signed-off-by: Dragan Mladjenovic 
Signed-off-by: Aleksandar Rikalo 
Signed-off-by: Thomas Bogendoerfer