For the same reason as commit 19514fc665ff ("arm, kbuild: make "make
install" not depend on vmlinux"), the install targets should never
trigger the rebuild of the kernel.
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Pull ARM SoC fixes from Olof Johansson: "The first real batch of fixes for this release cycle, so there are a few more than usual. Most of these are fixes and tweaks to board support (DT bugfixes, etc). I've also picked up a couple of small cleanups that seemed innocent enough that there was little reason to wait (const/ __initconst and Kconfig deps). Quite a bit of the changes on OMAP were due to fixes to no longer write to rodata from assembly when ARM_KERNMEM_PERMS was enabled, but there were also other fixes. Kirkwood had a bunch of gpio fixes for some boards. OMAP had RTC fixes on OMAP5, and Nomadik had changes to MMC parameters in DT. All in all, mostly the usual mix of various fixes" * tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (46 commits) ARM: multi_v7_defconfig: enable DW_WATCHDOG ARM: nomadik: fix up SD/MMC DT settings ARM64: tegra: Add chosen node for tegra132 norrin ARM: realview: use "depends on" instead of "if" after prompt ARM: tango: use "depends on" instead of "if" after prompt ARM: tango: use const and __initconst for smp_operations ARM: realview: use const and __initconst for smp_operations bus: uniphier-system-bus: revive tristate prompt arm64: dts: Add missing DMA Abort interrupt to Juno bus: vexpress-config: Add missing of_node_put ARM: dts: am57xx: sbc-am57x: correct Eth PHY settings ARM: dts: am57xx: cl-som-am57x: fix CPSW EMAC pinmux ARM: dts: am57xx: sbc-am57x: fix UART3 pinmux ARM: dts: am57xx: cl-som-am57x: update SPI Flash frequency ARM: dts: am57xx: cl-som-am57x: set HOST mode for USB2 ARM: dts: am57xx: sbc-am57x: fix SB-SOM EEPROM I2C address ARM: dts: LogicPD Torpedo: Revert Duplicative Entries ARM: dts: am437x: pixcir_tangoc: use correct flags for irq types ARM: dts: am4372: fix irq type for arm twd and global timer ARM: dts: at91: sama5d4 xplained: fix phy0 IRQ type ...
Pull networking fixes from David Miller:
"This looks like a lot but it's a mixture of regression fixes as well
as fixes for longer standing issues.
1) Fix on-channel cancellation in mac80211, from Johannes Berg.
2) Handle CHECKSUM_COMPLETE properly in xt_TCPMSS netfilter xtables
module, from Eric Dumazet.
3) Avoid infinite loop in UDP SO_REUSEPORT logic, also from Eric
Dumazet.
4) Avoid a NULL deref if we try to set SO_REUSEPORT after a socket is
bound, from Craig Gallek.
5) GRO key comparisons don't take lightweight tunnels into account,
from Jesse Gross.
6) Fix struct pid leak via SCM credentials in AF_UNIX, from Eric
Dumazet.
7) We need to set the rtnl_link_ops of ipv6 SIT tunnels before we
register them, otherwise the NEWLINK netlink message is missing
the proper attributes. From Thadeu Lima de Souza Cascardo.
8) Several Spectrum chip bug fixes for mlxsw switch driver, from Ido
Schimmel
9) Handle fragments properly in ipv4 easly socket demux, from Eric
Dumazet.
10) Don't ignore the ifindex key specifier on ipv6 output route
lookups, from Paolo Abeni"
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (128 commits)
tcp: avoid cwnd undo after receiving ECN
irda: fix a potential use-after-free in ircomm_param_request
net: tg3: avoid uninitialized variable warning
net: nb8800: avoid uninitialized variable warning
net: vxge: avoid unused function warnings
net: bgmac: clarify CONFIG_BCMA dependency
net: hp100: remove unnecessary #ifdefs
net: davinci_cpdma: use dma_addr_t for DMA address
ipv6/udp: use sticky pktinfo egress ifindex on connect()
ipv6: enforce flowi6_oif usage in ip6_dst_lookup_tail()
netlink: not trim skb for mmaped socket when dump
vxlan: fix a out of bounds access in __vxlan_find_mac
net: dsa: mv88e6xxx: fix port VLAN maps
fib_trie: Fix shift by 32 in fib_table_lookup
net: moxart: use correct accessors for DMA memory
ipv4: ipconfig: avoid unused ic_proto_used symbol
bnxt_en: Fix crash in bnxt_free_tx_skbs() during tx timeout.
bnxt_en: Exclude rx_drop_pkts hw counter from the stack's rx_dropped counter.
bnxt_en: Ring free response from close path should use completion ring
net_sched: drr: check for NULL pointer in drr_dequeue
...
vexpress fixes for v4.5 Couple of minor fixes for vexpress platforms: 1. Add missing of_node_put in vexpress config bus 2. Add missing DMA-330 abort interrupt on Juno platforms * tag 'vexpress-for-v4.5/fixes-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/sudeep.holla/linux: arm64: dts: Add missing DMA Abort interrupt to Juno bus: vexpress-config: Add missing of_node_put Signed-off-by: Olof Johansson <olof@lixom.net>
The NVIDIA bootloader, nvtboot, expects the "chosen" node to be present in the device-tree blob and if it is not then it fails to boot the kernel. Add the chosen node so we can boot the kernel on Tegra132 Norrin with the nvtboot bootloader. Signed-off-by: Jon Hunter <jonathanh@nvidia.com> Acked-by: Thierry Reding <treding@nvidia.com> Signed-off-by: Olof Johansson <olof@lixom.net>
The DMA-330 has an "irq_abort" interrupt line on which it signals faults separately from the "irq[n:0]" channel interrupts. On Juno, this is wired up to SPI 92; add it to the DT so that DMAC faults are correctly reported for the driver to reset the thing, rather than leaving it locked up and waiting to time out. CC: Liviu Dudau <liviu.dudau@arm.com> CC: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com> Signed-off-by: Robin Murphy <robin.murphy@arm.com> Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Pull ARM SoC support for Tegra platforms from Olof Johansson: "Here's a single-SoC topic branch that we've staged separately. Mainly because it was hard to sort the branch contents in a way that fit our existing branches due to some refactorings. The code has been in -next for quite a while, but we staged it in arm-soc a bit late, which is why we've kept it separate from the other updates and are sending it separately here" * tag 'armsoc-tegra' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: arm64: tegra: Add NVIDIA Jetson TX1 Developer Kit support arm64: tegra: Add NVIDIA P2597 I/O board support arm64: tegra: Add NVIDIA Jetson TX1 support arm64: tegra: Add NVIDIA P2571 board support arm64: tegra: Add NVIDIA P2371 board support arm64: tegra: Add NVIDIA P2595 I/O board support arm64: tegra: Add NVIDIA P2530 main board support arm64: tegra: Add Tegra210 support arm64: tegra: Add NVIDIA Tegra132 Norrin support arm64: tegra: Add Tegra132 support ARM: tegra: select USB_ULPI from EHCI rather than platform ARM: tegra: Ensure entire dcache is flushed on entering LP0/1 amba: Hide TEGRA_AHB symbol soc/tegra: Add Tegra210 support soc/tegra: Provide per-SoC Kconfig symbols
This patch replace the assoication between dsaf and enet from string matching to object reference. It requires the DTS to be updated within BIOS. Thanks god it can be done for all released boards. Signed-off-by: Kejian Yan <yankejian@huawei.com> Acked-by: Rob Herring <robh@kernel.org> Acked-by: Yisen Zhuang <yisen.zhuang@huawei.com> Signed-off-by: David S. Miller <davem@davemloft.net>
Pull ARM SoC driver updates from Olof Johansson:
"Driver updates for ARM SoCs. Some for SoC-family code under
drivers/soc, but also some other driver updates that don't belong
anywhere else. We also bring in the drivers/reset code through
arm-soc.
Some of the larger updates:
- Qualcomm support for SMEM, SMSM, SMP2P. All used to communicate
with other parts of the chip/board on these platforms, all
proprietary protocols that don't fit into other subsystems and live
in drivers/soc for now.
- System bus driver for UniPhier
- Driver for the TI Wakeup M3 IPC device
- Power management for Raspberry PI
+ Again a bunch of other smaller updates and patches"
* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (38 commits)
bus: uniphier: allow only built-in driver
ARM: bcm2835: clarify RASPBERRYPI_FIRMWARE dependency
MAINTAINERS: Drop Kumar Gala from QCOM
bus: uniphier-system-bus: add UniPhier System Bus driver
ARM: bcm2835: add rpi power domain driver
dt-bindings: add rpi power domain driver bindings
ARM: bcm2835: Define two new packets from the latest firmware.
drivers/soc: make mediatek/mtk-scpsys.c explicitly non-modular
soc: mediatek: SCPSYS: Add regulator support
MAINTAINERS: Change QCOM entries
soc: qcom: smd-rpm: Add existing platform support
memory/tegra: Add number of TLB lines for Tegra124
reset: hi6220: fix modular build
soc: qcom: Introduce WCNSS_CTRL SMD client
ARM: qcom: select ARM_CPU_SUSPEND for power management
MAINTAINERS: Add rules for Qualcomm dts files
soc: qcom: enable smsm/smp2p modular build
serial: msm_serial: Make config tristate
soc: qcom: smp2p: Qualcomm Shared Memory Point to Point
soc: qcom: smsm: Add driver for Qualcomm SMSM
...
Pull ARM 64-bit DT updates from Olof Johansson: "This is the first release where we split up the 64-bit contributions a bit more, and in particular we are having a separate DT branch for them. Contents: - New devices added to Broadcom NorthStar2 - Misc fixes for Exynos7 boards - QCOM updates for MSM8916 - Rockchip tweaks for rk3368 SoC and eval board - A series of fixes for APM X-Gene v1 and v2 - Renesas R8A7795 CPU/PSCI additions - Marvell Berlin4CT PSCI, cpuidle, watchdog portions - Freescale LS1043a SoC and dev board support + some treewide or other misc changes" * tag 'armsoc-dt64' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (104 commits) dts/ls2080a: Update DTSI to add support of SP805 WDT Documentation: DT: Add entry for ARM SP805-WDT arm64: dts: X-Gene v2: I2C1 clock is always on arm64: dts: X-Gene v1: I2C0 clock is always on arm64: dts: Fix to use standard DT node names for X-Gene 1 and X-Gene 2 platforms arm64: dts: hikey: add label properties to UARTs arm64: dts: apq8016-sbc: add label properties for UART, I2C, and SPI arm64: dts: apq8016-sbc: enable UART0 on LS connector arm64: dts: juno: Add idle-states to device tree arm64: dts: Added syscon-reboot node for FSL's LS2080A SoC arm64: dts: add LS1043a-RDB board support arm64: dts: add Freescale LS1043a SoC support Documentation: DT: Add entry for Freescale LS1043a-RDB board arm64: dts: uniphier: add PH1-LD10 SoC/board support arm64: renesas: r8a7795: fix SATA clock assignment arm64: dts: salvator-x: Enable SATA controller arm64: dts: r8a7795: Add SATA controller node arm64: renesas: r8a7795: add internal delay for i2c IPs arm64: renesas: salvator-x: Add board part number to DT bindings arm64: dts: r8a7795: Add pmu device nodes ...