commit e9adb336d0bf391be23e820975ca5cd12c31d781 upstream.

mfio 84 to 89 are described wrongly, fix it to describe
the right pin and add them to right pin-mux group.

The correct order is:
	pll1_lock => mips_pll	-- MFIO_83
	pll2_lock => audio_pll	-- MFIO_84
	pll3_lock => rpu_v_pll	-- MFIO_85
	pll4_lock => rpu_l_pll	-- MFIO_86
	pll5_lock => sys_pll	-- MFIO_87
	pll6_lock => wifi_pll	-- MFIO_88
	pll7_lock => bt_pll	-- MFIO_89

Cc: linux-gpio@vger.kernel.org
Cc: devicetree@vger.kernel.org
Cc: linux-mips@linux-mips.org
Cc: James Hartley <James.Hartley@imgtec.com>
Fixes: cefc03e5995e("pinctrl: Add Pistachio SoC pin control driver")
Signed-off-by: Govindraj Raja <Govindraj.Raja@imgtec.com>
Acked-by: Andrew Bresticker <abrestic@chromium.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 1363074667a6b7d0507527742ccd7bbed5e3ceaa upstream.

Add a new NO_REPORT_LUNS quirk and set it for Seagate drives with
an usb-id of: 0bc2:331a, as these will fail to respond to a
REPORT_LUNS command.

Reported-and-tested-by: David Webb <djw@noc.ac.uk>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 844a5fe219cf472060315971e15cbf97674a3324 upstream.

Yes, all of these are needed. :) This is admittedly a bit odd, but
kvm-unit-tests access.flat tests this if you run it with "-cpu host"
and of course ept=0.

KVM runs the guest with CR0.WP=1, so it must handle supervisor writes
specially when pte.u=1/pte.w=0/CR0.WP=0.  Such writes cause a fault
when U=1 and W=0 in the SPTE, but they must succeed because CR0.WP=0.
When KVM gets the fault, it sets U=0 and W=1 in the shadow PTE and
restarts execution.  This will still cause a user write to fault, while
supervisor writes will succeed.  User reads will fault spuriously now,
and KVM will then flip U and W again in the SPTE (U=1, W=0).  User reads
will be enabled and supervisor writes disabled, going back to the
originary situation where supervisor writes fault spuriously.

When SMEP is in effect, however, U=0 will enable kernel execution of
this page.  To avoid this, KVM also sets NX=1 in the shadow PTE together
with U=0.  If the guest has not enabled NX, the result is a continuous
stream of page faults due to the NX bit being reserved.

The fix is to force EFER.NX=1 even if the CPU is taking care of the EFER
switch.  (All machines with SMEP have the CPU_LOAD_IA32_EFER vm-entry
control, so they do not use user-return notifiers for EFER---if they did,
EFER.NX would be forced to the same value as the host).

There is another bug in the reserved bit check, which I've split to a
separate patch for easier application to stable kernels.

Cc: Andy Lutomirski <luto@amacapital.net>
Reviewed-by: Xiao Guangrong <guangrong.xiao@linux.intel.com>
Fixes: f6577a5fa15d82217ca73c74cd2dcbc0f6c781dd
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit 2e18f5a1bc18e8af7031b3b26efde25307014837 upstream.

Introduce a dt property, ti,no-idle, that prevents an IP to idle at any
point. This is to handle Errata i877, which tells that GMAC clocks
cannot be disabled.

Acked-by: Roger Quadros <rogerq@ti.com>
Tested-by: Mugunthan V N <mugunthanvnm@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Dave Gerlach <d-gerlach@ti.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit ed8b0de5a33d2a2557dce7f9429dca8cb5bc5879 upstream.

"rm -rf" is bricking some peoples' laptops because of variables being
used to store non-reinitializable firmware driver data that's required
to POST the hardware.

These are 100% bugs, and they need to be fixed, but in the mean time it
shouldn't be easy to *accidentally* brick machines.

We have to have delete working, and picking which variables do and don't
work for deletion is quite intractable, so instead make everything
immutable by default (except for a whitelist), and make tools that
aren't quite so broad-spectrum unset the immutable flag.

Signed-off-by: Peter Jones <pjones@redhat.com>
Tested-by: Lee, Chun-Yi <jlee@suse.com>
Acked-by: Matthew Garrett <mjg59@coreos.com>
Signed-off-by: Matt Fleming <matt@codeblueprint.co.uk>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit bf5ce5bf3cc7136fd7fe5e8999a580bc93a9c8f6 upstream.

Commit 655fe4effe0f ("usbcore: add sysfs support to xHCI usb3
hardware LPM") introduced usb3_hardware_lpm sysfs node. This
doesn't show the correct status of USB3 U1 and U2 LPM status.

This patch fixes this by replacing usb3_hardware_lpm with two
nodes, usb3_hardware_lpm_u1 (for U1) and usb3_hardware_lpm_u2
(for U2), and recording the U1/U2 LPM status in right places.

This patch should be back-ported to kernels as old as 4.3,
that contains Commit 655fe4effe0f ("usbcore: add sysfs support
to xHCI usb3 hardware LPM").

Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull networking fixes from David Miller:

 1) Prevent XFRM per-cpu counter updates for one namespace from being
    applied to another namespace.  Fix from DanS treetman.

 2) Fix RCU de-reference in iwl_mvm_get_key_sta_id(), from Johannes
    Berg.

 3) Remove ethernet header assumption in nft_do_chain_netdev(), from
    Pablo Neira Ayuso.

 4) Fix cpsw PHY ident with multiple slaves and fixed-phy, from Pascal
    Speck.

 5) Fix use after free in sixpack_close and mkiss_close.

 6) Fix VXLAN fw assertion on bnx2x, from Yuval Mintz.

 7) natsemi doesn't check for DMA mapping errors, from Alexey
    Khoroshilov.

 8) Fix inverted test in ip6addrlbl_get(), from ANdrey Ryabinin.

 9) Missing initialization of needed_headroom in geneve tunnel driver,
    from Paolo Abeni.

10) Fix conntrack template leak in openvswitch, from Joe Stringer.

11) Mission initialization of wq->flags in sock_alloc_inode(), from
    Nicolai Stange.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (35 commits)
  sctp: sctp should release assoc when sctp_make_abort_user return NULL in sctp_close
  net, socket, socket_wq: fix missing initialization of flags
  drivers: net: cpsw: fix error return code
  openvswitch: Fix template leak in error cases.
  sctp: label accepted/peeled off sockets
  sctp: use GFP_USER for user-controlled kmalloc
  qlcnic: fix a loop exit condition better
  net: cdc_ncm: avoid changing RX/TX buffers on MTU changes
  geneve: initialize needed_headroom
  ipv6: honor ifindex in case we receive ll addresses in router advertisements
  addrconf: always initialize sysctl table data
  ipv6/addrlabel: fix ip6addrlbl_get()
  switchdev: bridge: Pass ageing time as clock_t instead of jiffies
  sh_eth: fix 16-bit descriptor field access endianness too
  veth: don’t modify ip_summed; doing so treats packets with bad checksums as good.
  net: usb: cdc_ncm: Adding Dell DW5813 LTE AT&T Mobile Broadband Card
  net: usb: cdc_ncm: Adding Dell DW5812 LTE Verizon Mobile Broadband Card
  natsemi: add checks for dma mapping errors
  rhashtable: Kill harmless RCU warning in rhashtable_walk_init
  openvswitch: correct encoding of set tunnel action attributes
  ...

Pull input fixes from Dmitry Torokhov:
 "Just a few assorted driver fixes"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: elants_i2c - fix wake-on-touch
  Input: elan_i2c - set input device's vendor and product IDs
  Input: sun4i-lradc-keys - fix typo in binding documentation
  Input: atmel_mxt_ts - add maxtouch to I2C table for module autoload
  Input: arizona-haptic - fix disabling of haptics device
  Input: aiptek - fix crash on detecting device without endpoints
  Input: atmel_mxt_ts - add generic platform data for Chromebooks
  Input: parkbd - clear unused function pointers
  Input: walkera0701 - clear unused function pointers
  Input: turbografx - clear unused function pointers
  Input: gamecon - clear unused function pointers
  Input: db9 - clear unused function pointers

Commit 1f71e8c96fc654724723ce987e0a8b2aeb81746d ("drivers: net: cpsw: Add
support for fixed-link PHY") did not parse the "phy-mode" property in
the case of a fixed-link PHY, leaving slave_data->phy_if with its default
of PHY_INTERFACE_MODE_NA(0). This later gets passed to phy_connect() in
cpsw_slave_open(), and eventually to cpsw_phy_sel() where it hits a default
case that configures the MAC for MII mode.

The user visible symptom is that while kernel log messages seem to indicate
that the interface is set up, there is no network communication. Eventually
a watchdog error occurs:
    NETDEV WATCHDOG: eth0 (cpsw): transmit queue 0 timed out

Fixes: 1f71e8c96fc6 ("drivers: net: cpsw: Add support for fixed-link PHY")
Signed-off-by: David Rivshin <drivshin@allworx.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull MTD fixes from Brian Norris:
 "I was holding out on this pull request for a bit, since there are a
  few other small issues being discussed that look like 4.4-rc
  regressions.  Hopefully I can get those stabilized soon, but these are
  ready at any rate:

   - A little bit of a last-minute change for the device tree "fixed
     partition" binding.  This is needed because we might want to reuse
     the 'partitions' subnode for other sorts of partitioning
     descriptions -- e.g., for describing which on-flash partition
     format(s) might be used on the system.

   - Also tone down a warning message, since it is probably going to
     show up on a lot of systems where it should just be ignored"

* tag 'for-linus-20151217' of git://git.infradead.org/linux-mtd:
  doc: dt: mtd: partitions: add compatible property to "partitions" node
  mtd: ofpart: don't complain about missing 'partitions' node too loudly