commit 26d5bb9e4c4b541c475751e015072eb2cbf70d15 upstream.

FMAN DMA read or writes under heavy traffic load may cause FMAN
internal resource leak; thus stopping further packet processing.

The FMAN internal queue can overflow when FMAN splits single
read or write transactions into multiple smaller transactions
such that more than 17 AXI transactions are in flight from FMAN
to interconnect. When the FMAN internal queue overflows, it can
stall further packet processing. The issue can occur with any one
of the following three conditions:

  1. FMAN AXI transaction crosses 4K address boundary (Errata
     A010022)
  2. FMAN DMA address for an AXI transaction is not 16 byte
     aligned, i.e. the last 4 bits of an address are non-zero
  3. Scatter Gather (SG) frames have more than one SG buffer in
     the SG list and any one of the buffers, except the last
     buffer in the SG list has data size that is not a multiple
     of 16 bytes, i.e., other than 16, 32, 48, 64, etc.

With any one of the above three conditions present, there is
likelihood of stalled FMAN packet processing, especially under
stress with multiple ports injecting line-rate traffic.

To avoid situations that stall FMAN packet processing, all of the
above three conditions must be avoided; therefore, configure the
system with the following rules:

  1. Frame buffers must not span a 4KB address boundary, unless
     the frame start address is 256 byte aligned
  2. All FMAN DMA start addresses (for example, BMAN buffer
     address, FD[address] + FD[offset]) are 16B aligned
  3. SG table and buffer addresses are 16B aligned and the size
     of SG buffers are multiple of 16 bytes, except for the last
     SG buffer that can be of any size.

Additional workaround notes:
- Address alignment of 64 bytes is recommended for maximally
efficient system bus transactions (although 16 byte alignment is
sufficient to avoid the stall condition)
- To support frame sizes that are larger than 4K bytes, there are
two options:
  1. Large single buffer frames that span a 4KB page boundary can
     be converted into SG frames to avoid transaction splits at
     the 4KB boundary,
  2. Align the large single buffer to 256B address boundaries,
     ensure that the frame address plus offset is 256B aligned.
- If software generated SG frames have buffers that are unaligned
and with random non-multiple of 16 byte lengths, before
transmitting such frames via FMAN, frames will need to be copied
into a new single buffer or multiple buffer SG frame that is
compliant with the three rules listed above.

Signed-off-by: Madalin Bucur <madalin.bucur@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit ab4562f4dd92c455f6b313717af5e7d72a55d7b4 upstream.

APF6 Dev compatible is armadeus,imx6dl-apf6dev and not
armadeus,imx6dl-apf6dldev.

Fixes: 3d735471d066 ("dt-bindings: arm: Document Armadeus SoM and Dev boards devicetree binding")
Signed-off-by: Sébastien Szymanski <sebastien.szymanski@armadeus.com>
Signed-off-by: Rob Herring <robh@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit a5b0cda136f4f420a8e24e50d19dfcef2f81df2e upstream.

Fixes: 2e36e140b8b8 ("regulator: qcom_spmi: Add support for PM8004 regulators")

Signed-off-by: Petr Vorel <petr.vorel@gmail.com>
Link: https://lore.kernel.org/r/20200127231439.3562452-1-petr.vorel@gmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

commit a6c4f77cb3b11f81077b53c4a38f21b92d41f21e upstream.

This patch set the correct value for oversampling maxItems. In the
original example, appears 3 items for oversampling while the maxItems
is set to 1, this patch fixes those issues.

Fixes: 416f882c3b40 ("dt-bindings: iio: adc: Migrate AD7606 documentation to yaml")
Signed-off-by: Beniamin Bia <beniamin.bia@analog.com>
Signed-off-by: Rob Herring <robh@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Add an entry for erratum A011043: the MDIO_CFG[MDIO_RD_ER]
bit may be falsely set when reading internal PCS registers.
MDIO reads to internal PCS registers may result in having
the MDIO_CFG[MDIO_RD_ER] bit set, even when there is no
error and read data (MDIO_DATA[MDIO_DATA]) is correct.
Software may get false read error when reading internal
PCS registers through MDIO. As a workaround, all internal
MDIO accesses should ignore the MDIO_CFG[MDIO_RD_ER] bit.

Signed-off-by: Madalin Bucur <madalin.bucur@oss.nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull i2c fixes from Wolfram Sang:
 "Two driver bugfixes, a documentation fix, and a removal of a spec
  violation for the bus recovery algorithm in the core"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: fix bus recovery stop mode timing
  i2c: bcm2835: Store pointer to bus clock
  dt-bindings: i2c: at91: fix i2c-sda-hold-time-ns documentation for sam9x60
  i2c: at91: fix clk_offset for sam9x60

Pull spi fixes from Mark Brown:
 "A small collection of fixes here, one to make the newly added PTP
  timestamping code more accurate, a few driver fixes and a fix for the
  core DT binding to document the fact that we support eight wire buses"

* tag 'spi-fix-v5.5-rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: Document Octal mode as valid SPI bus width
  spi: spi-dw: Add lock protect dw_spi rx/tx to prevent concurrent calls
  spi: spi-fsl-dspi: Fix 16-bit word order in 32-bit XSPI mode
  spi: Don't look at TX buffer for PTP system timestamping
  spi: uniphier: Fix FIFO threshold

SAM9X60 also supports i2c-sda-hold-time-ns. Fix the documentation accordingly.

Fixes: 2034e3f4c9a5 ("dt-bindings: i2c: at91: add new compatible")
Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

SPI core supports Octal SPI controllers which have 8 IO lines.
Therefore document 8 as a valid option for spi-tx{rx}-bus-width

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Link: https://lore.kernel.org/r/20200102102118.23318-1-vigneshr@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>

Pull networking fixes from David Miller:

 1) Several nf_flow_table_offload fixes from Pablo Neira Ayuso,
    including adding a missing ipv6 match description.

 2) Several heap overflow fixes in mwifiex from qize wang and Ganapathi
    Bhat.

 3) Fix uninit value in bond_neigh_init(), from Eric Dumazet.

 4) Fix non-ACPI probing of nxp-nci, from Stephan Gerhold.

 5) Fix use after free in tipc_disc_rcv(), from Tuong Lien.

 6) Enforce limit of 33 tail calls in mips and riscv JIT, from Paul
    Chaignon.

 7) Multicast MAC limit test is off by one in qede, from Manish Chopra.

 8) Fix established socket lookup race when socket goes from
    TCP_ESTABLISHED to TCP_LISTEN, because there lacks an intervening
    RCU grace period. From Eric Dumazet.

 9) Don't send empty SKBs from tcp_write_xmit(), also from Eric Dumazet.

10) Fix active backup transition after link failure in bonding, from
    Mahesh Bandewar.

11) Avoid zero sized hash table in gtp driver, from Taehee Yoo.

12) Fix wrong interface passed to ->mac_link_up(), from Russell King.

13) Fix DSA egress flooding settings in b53, from Florian Fainelli.

14) Memory leak in gmac_setup_txqs(), from Navid Emamdoost.

15) Fix double free in dpaa2-ptp code, from Ioana Ciornei.

16) Reject invalid MTU values in stmmac, from Jose Abreu.

17) Fix refcount leak in error path of u32 classifier, from Davide
    Caratti.

18) Fix regression causing iwlwifi firmware crashes on boot, from Anders
    Kaseorg.

19) Fix inverted return value logic in llc2 code, from Chan Shu Tak.

20) Disable hardware GRO when XDP is attached to qede, frm Manish
    Chopra.

21) Since we encode state in the low pointer bits, dst metrics must be
    at least 4 byte aligned, which is not necessarily true on m68k. Add
    annotations to fix this, from Geert Uytterhoeven.

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (160 commits)
  sfc: Include XDP packet headroom in buffer step size.
  sfc: fix channel allocation with brute force
  net: dst: Force 4-byte alignment of dst_metrics
  selftests: pmtu: fix init mtu value in description
  hv_netvsc: Fix unwanted rx_table reset
  net: phy: ensure that phy IDs are correctly typed
  mod_devicetable: fix PHY module format
  qede: Disable hardware gro when xdp prog is installed
  net: ena: fix issues in setting interrupt moderation params in ethtool
  net: ena: fix default tx interrupt moderation interval
  net/smc: unregister ib devices in reboot_event
  net: stmmac: platform: Fix MDIO init for platforms without PHY
  llc2: Fix return statement of llc_stat_ev_rx_null_dsap_xid_c (and _test_c)
  net: hisilicon: Fix a BUG trigered by wrong bytes_compl
  net: dsa: ksz: use common define for tag len
  s390/qeth: don't return -ENOTSUPP to userspace
  s390/qeth: fix promiscuous mode after reset
  s390/qeth: handle error due to unsupported transport mode
  cxgb4: fix refcount init for TC-MQPRIO offload
  tc-testing: initial tdc selftests for cls_u32
  ...