Pull more MFD updates from Lee Jones:
 "I missed collecting these patches due to a branch/tag naming
  ambiguity.  Completely my own fault, as I mindlessly named a branch
  and tag identically.  Sorry for the fuss.

  This pull-request contains some misplaced patches from Tony Lindgren
  that should have been part of the initial one"

* tag 'mfd-for-linus-3.16-1' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd:
  mfd: twl4030-power: Add a configuration to turn off oscillator during off-idle
  mfd: twl4030-power: Add support for board specific configuration
  mfd: twl4030-power: Add recommended idle configuration
  mfd: twl4030-power: Add generic reset configuration
  mfd: twl4030-power: Fix some defines for SW_EVENTS
  mfd: twl4030-power: Fix hang on reboot if sleep configuration was loaded earlier

Pull powerpc updates from Ben Herrenschmidt:
 "Here is the bulk of the powerpc changes for this merge window.  It got
  a bit delayed in part because I wasn't paying attention, and in part
  because I discovered I had a core PCI change without a PCI maintainer
  ack in it.  Bjorn eventually agreed it was ok to merge it though we'll
  probably improve it later and I didn't want to rebase to add his ack.

  There is going to be a bit more next week, essentially fixes that I
  still want to sort through and test.

  The biggest item this time is the support to build the ppc64 LE kernel
  with our new v2 ABI.  We previously supported v2 userspace but the
  kernel itself was a tougher nut to crack.  This is now sorted mostly
  thanks to Anton and Rusty.

  We also have a fairly big series from Cedric that add support for
  64-bit LE zImage boot wrapper.  This was made harder by the fact that
  traditionally our zImage wrapper was always 32-bit, but our new LE
  toolchains don't really support 32-bit anymore (it's somewhat there
  but not really "supported") so we didn't want to rely on it.  This
  meant more churn that just endian fixes.

  This brings some more LE bits as well, such as the ability to run in
  LE mode without a hypervisor (ie. under OPAL firmware) by doing the
  right OPAL call to reinitialize the CPU to take HV interrupts in the
  right mode and the usual pile of endian fixes.

  There's another series from Gavin adding EEH improvements (one day we
  *will* have a release with less than 20 EEH patches, I promise!).

  Another highlight is the support for the "Split core" functionality on
  P8 by Michael.  This allows a P8 core to be split into "sub cores" of
  4 threads which allows the subcores to run different guests under KVM
  (the HW still doesn't support a partition per thread).

  And then the usual misc bits and fixes ..."

[ Further delayed by gmail deciding that BenH is a dirty spammer.
  Google knows.  ]

* 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/benh/powerpc: (155 commits)
  powerpc/powernv: Add missing include to LPC code
  selftests/powerpc: Test the THP bug we fixed in the previous commit
  powerpc/mm: Check paca psize is up to date for huge mappings
  powerpc/powernv: Pass buffer size to OPAL validate flash call
  powerpc/pseries: hcall functions are exported to modules, need _GLOBAL_TOC()
  powerpc: Exported functions __clear_user and copy_page use r2 so need _GLOBAL_TOC()
  powerpc/powernv: Set memory_block_size_bytes to 256MB
  powerpc: Allow ppc_md platform hook to override memory_block_size_bytes
  powerpc/powernv: Fix endian issues in memory error handling code
  powerpc/eeh: Skip eeh sysfs when eeh is disabled
  powerpc: 64bit sendfile is capped at 2GB
  powerpc/powernv: Provide debugfs access to the LPC bus via OPAL
  powerpc/serial: Use saner flags when creating legacy ports
  powerpc: Add cpu family documentation
  powerpc/xmon: Fix up xmon format strings
  powerpc/powernv: Add calls to support little endian host
  powerpc: Document sysfs DSCR interface
  powerpc: Fix regression of per-CPU DSCR setting
  powerpc: Split __SYSFS_SPRSETUP macro
  arch: powerpc/fadump: Cleaning up inconsistent NULL checks
  ...

Pull MFD updates from Lee Jones:
 "Changes to existing drivers:
   - increase DT coverage: arizona, mc13xxx, stmpe-i2c, syscon,
     sun6i-prcm
   - regmap use of and/or clean-up: tps65090, twl6040
   - basic renaming: max14577
   - use new cpufreq helpers: db8500-prcmu
   - increase regulator support: stmpe, arizona, wm5102
   - reduce legacy GPIO overhead: stmpe
   - provide necessary remove path: bcm590xx
   - expand sysfs presence: kempld
   - move driver specific code out to drivers: rtc-s5m, arizona
   - clk handling: twl6040
   - use managed (devm_*) resources: ipaq-micro
   - clean-up/remove unused/duplicated code: tps65218, sec, pm8921,
     abx500-core, db8500-prcmu, menelaus
   - build/boot/sematic bug fixes: rtsx_usb, stmpe, bcm590xx, abx500,
     mc13xxx, rdc321x-southbridge, mfd-core, sec, max14577, syscon,
     cros_ec_spi
   - constify stuff: sm501, tps65910, tps6507x, tps6586x, max77686,
     max8997, kempld, max77693, max8907, rtsx_usb, db8500-prcmu,
     max8998, wm8400, sec, lp3943, max14577, as3711, omap-usb-host,
     ipaq-micro

  Support for new devices:
   - add support for max77836 into max14577
   - add support for tps658640 into tps6586x
   - add support for cros-ec-i2c-tunnel into cros_ec
   - add new driver for rtsx_usb_sdmmc and rtsx_usb_ms
   - add new driver for axp20x
   - add new driver for sun6i-prcm
   - add new driver for ipaq-micro"

* tag 'mfd-for-linus-3.16' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (77 commits)
  mfd: wm5102: Correct default for LDO Control 2 register
  mfd: menelaus: Use module_i2c_driver
  mfd: tps65218: Terminate of match table
  mfd: db8500-prcmu: Remove check for CONFIG_DBX500_PRCMU_DEBUG
  mfd: ti-keystone-devctrl: Add bindings for device state control
  mfd: palmas: Format the header file
  mfd: abx500-core: Remove unused function abx500_dump_all_banks()
  mfd: arizona: Correct addresses of always-on trigger registers
  mfd: max14577: Cast to architecture agnostic data type
  i2c: ChromeOS EC tunnel driver
  mfd: cros_ec: Sync to the latest cros_ec_commands.h from EC sources
  mfd: cros_ec: spi: Increase cros_ec_spi deadline from 5ms to 100ms
  mfd: cros_ec: spi: Make the cros_ec_spi timeout more reliable
  mfd: cros_ec: spi: Add mutex to cros_ec_spi
  mfd: cros_ec: spi: Calculate delay between transfers correctly
  mfd: arizona: Correct error message for addition of main IRQ chip
  mfd: wm8997: Add registers for high power mode
  mfd: arizona: Add MICVDD to mapped regulators
  mfd: ipaq-micro: Make mfd_cell array const
  mfd: ipaq-micro: Use devm_ioremap_resource()
  ...

Pull sound updates from Takashi Iwai:
 "At this time, majority of changes come from ASoC world while we got a
  few new drivers in other places for FireWire and USB.  There have been
  lots of ASoC core cleanups / refactoring, but very little visible to
  external users.

  ASoC:
   - Support for specifying aux CODECs in DT
   - Removal of the deprecated mux and enum macros
   - More moves towards full componentisation
   - Removal of some unused I/O code
   - Lots of cleanups, fixes and enhancements to the davinci, Freescale,
     Haswell and Realtek drivers
   - Several drivers exposed directly in Kconfig for use with
     simple-card
   - GPIO descriptor support for jacks
   - More updates and fixes to the Freescale SSI, Intel and rsnd drivers
   - New drivers for Cirrus CS42L56, Realtek RT5639, RT5642 and RT5651
     and ST STA350, Analog Devices ADAU1361, ADAU1381, ADAU1761 and
     ADAU1781, and Realtek RT5677

  HD-audio:
   - Clean up Dell headset quirks
   - Noise fixes for Dell and Sony laptops
   - Thinkpad T440 dock fix
   - Realtek codec updates (ALC293,ALC233,ALC3235)
   - Tegra HD-audio HDMI support

  FireWire-audio:
   - FireWire audio stack enhancement (AMDTP, MIDI), support for
     incoming isochronous stream and duplex streams with timestamp
     synchronization
   - BeBoB-based devices support
   - Fireworks-based device support

  USB-audio:
   - Behringer BCD2000 USB device support

  Misc:
   - Clean up of a few old drivers, atmel, fm801, etc"

* tag 'sound-3.16-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound: (480 commits)
  ASoC: Fix wrong argument for card remove callbacks
  ASoC: free jack GPIOs before the sound card is freed
  ALSA: firewire-lib: Remove a comment about restriction of asynchronous operation
  ASoC: cache: Fix error code when not using ASoC level cache
  ALSA: hda/realtek - Fix COEF widget NID for ALC260 replacer fixup
  ALSA: hda/realtek - Correction of fixup codes for PB V7900 laptop
  ALSA: firewire-lib: Use IEC 61883-6 compliant labels for Raw Audio data
  ASoC: add RT5677 CODEC driver
  ASoC: intel: The Baytrail/MAX98090 driver depends on I2C
  ASoC: rt5640: Add the function "get_clk_info" to RL6231 shared support
  ASoC: rt5640: Add the function of the PLL clock calculation to RL6231 shared support
  ASoC: rt5640: Add RL6231 class device shared support for RT5640, RT5645 and RT5651
  ASoC: cache: Fix possible ZERO_SIZE_PTR pointer dereferencing error.
  ASoC: Add helper functions to cast from DAPM context to CODEC/platform
  ALSA: bebob: sizeof() vs ARRAY_SIZE() typo
  ASoC: wm9713: correct mono out PGA sources
  ALSA: synth: emux: soundfont.c: Cleaning up memory leak
  ASoC: fsl: Remove dependencies of boards for SND_SOC_EUKREA_TLV320
  ASoC: fsl-ssi: Use regmap
  ASoC: fsl-ssi: reorder and document fsl_ssi_private
  ...

The Keystone II devices have a set of registers that are used to control
the status of its peripherals. This node is intended to allow access to
this functionality.

Reviewed-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

Document DT bindings of the PRCM (Power/Reset/Clock Management) unit.

Signed-off-by: Boris BREZILLON <boris.brezillon@free-electrons.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

In certain boards the source for the clk32k clock can be gated. In these
boards the clk32k clock can be provided to the driver and it is going to be
enabled/disabled when it is needed.
If the clk32k clock is not provided the driver will assume that it is always
running.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

Some oscillators can be turned off during off-idle saving few
a little bit power at the cost of the oscillator start up
latency.

If you board can do this, you can now enable it by using the
ti,twl4030-power-idle-osc-off compatible flag.

Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

These settings are based on the "Recommended Sleep Sequences for
the Zoom Platform".

The settings assume most of the regulators are under control of
Linux, and twl4030 only cuts off VDD1 and VDD2 during off-idle as
Linux cannot do it.

For any board specific changes to these, let's patch them in as
changes to the generic data in the follow-up patches. This keeps
the board specific changes small.

Note that this does not consider the twl5030 errata 27 and 28.
That can be added later on after it has been tested. For more
information about errata 27 and 28.

Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>